FCC ID: 2ATKO-GROOVE Portable Bluetooth Speaker

TABLE OF CONTENTS 2

- INSIDE 3-4

- BUTTONS 5-6

- BATTERY CHARGE 7-8

- BLUETOOTH WIRELESS TECHNOLOGY 9

- ENABLE/DISABLE FUNCTION SOUNDS 10-11

- AUXILIARY IN 12

- ENABLE/DISABLE AUTO OFF FUNCTION 13

- FACTORY RESET 14

- CARE AND CLEANING 1 INSIDE CONTENU CONTENIDO INHALT CONTENUTO CONTEDO International Adapters Included. Adaptateurs Internationaux Inclus. Contiene Adaptadores Internacionales. Internationale Adapter Im Lieferumfang Enthalten. Sono Inclusi Adattatori Internazionali. Adaptadores Internacionais Includos. 2 BUTTONS CONTENU CONTENIDO INHALT CONTENUTO CONTEDO

ON/OFF Auxiliary Select Volume Down Bluetooth Source Select Play/Pause Volume Up 3 ON/OFF Sous tensio / Hors tension Bluetooth Source Select Slection de la source Bluetooth Encendido / Apagado Seleccin de fuente Bluetooth Ein / Aus Acceso / Spento Ligar / Desligar

Bluetooth Quellenwahl Selezione segnale Bluetooth Seleo de fonte Bluetooth Bluetooth Play/Pause Lecture/pause Reproduccin/pausa Wiedergabe/Pause Riproduzione / Pausa Reproduzir/Pausar

Volume Down Volume bas Bajada de volumen Leiser Riduzione volume Diminuir o volume Auxilary Select Slection auxiliaire Seleccin de auxiliar AUX-Auswahl Selezione ingresso ausiliario Seleo de auxiliar Volume Up Volume haut Subida de volumen Lauter Aumento volume Aumentar o volume 4 BATTERY CHARGE CHARGE BATTERIE CARGA DE LA PILA AKKULADESTAND CARICA BATTERIA CARGA DA BATERIA 1 5 2 Green =

Yellow =

Solid Red =

Flashing Red =

> 50%

< 50%

< 10%

< 5%

Green Vert Verde Grn Verde Verde Yellow Jaune Amarillo Gelb Giallo Amarela Solid Red Rouge continu Rojo continuo Dauerhaft Rot Vermelho a luce fissa Rosso constante Flashing Red Clignotement Rouge Destella Rojo Blinkt Rot Vermelho lampeggiante Rosso intermitente 6 BLUETOOTH WIRELESS TECHNOLOGY TECNOLOGA INALMBRICA BLUETOOTH CONFIGURACIN DE TECNOLOGIA WIRELESS BLUETOOTH DRAHTLOSE BLUETOOTH -TECHNOLOGIE-SETUP CONFIGURAZIONE TECNOLOGIA WIRELESS BLUETOOTH CONFIGURAO DE TECNOLOGIA SEM FIO BLUETOOTH BLUETOOTH 1 2 7 3 Hold 3 Seconds Appuyer pendant 3 secondes Mantenga oprimido durante 3 segundos 3 Sekunden gedrckt halten Tenere premuto per 3 secondi Manter pressionado por 3 segundos 3 Bluetooth Bluetooth Devices Settings ON 4 5 Settings Bluetooth Bluetooth ON Devices Klipsch Groove Not Paired Klipsch Groove Connected Flashing Clignotant Destello Blinkt Lampeggiante Intermitente 1 1 2 2

* Example only. Your device may differ. titre dexemple seulement. Votre appareil peut tre diffrent. Este es solo un ejemplo. Es posible que su dispositivo sea diferente. Nur als Beispiel. Ihr Gert kann anders aussehen Solo a titolo esemplificativo. Lo specifico dispositivo pu essere diverso. Apenas para exemplo. O dispositivo pode ser diferente. . . 3 3 4 4 5 5 Settings Settings Bluetooth Bluetooth Settings Settings Bluetooth Bluetooth Bluetooth Bluetooth ON ON Bluetooth Bluetooth ON ON Devices Devices Devices Devices Klipsch Groove Klipsch Groove Not Paired Not Paired Klipsch Groove Klipsch Groove Connected Connected Solid Continu Continuo Dauerhaft Luce fissa Constante 8 When Bluetooth is disconnected AUX IN AUX IN ENTRADA AUX AUX IN IN AUX AUX IN 1 2

3

3.5mm cable not included Cble 3,5 mm non inclus El cable de 3.5 mm no se incluye 3,5-mm-Kabel nicht im Lieferumfang Cavo da 3,5 mm non incluso Cabo de 3,5 mm no includo 3.5 10

FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. RF warning statement:

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. IC warning

- English:

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canadas licence-exempt RSS(s). Operation is subject to the following two conditions:

(1) This device may not cause interference.

(2) This device must accept any interference, including interference that may cause undesired operation of the device.

- French:

Lmetteur/rcepteur exempt de licence contenu dans le prsent appareil est conforme aux CNR dInnovation, Sciences et Dveloppement conomique Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes :

1) Lappareil ne doit pas produire de brouillage;

2) Lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement 3502 WOODVIEW TRACE, INDIANAPOLIS, IN, USA KLIPSCH.COM 2018, Klipsch Group, Inc. Klipsch Group, Inc. is a wholly-owned subsidiary of Voxx International Corporation. Klipsch and Keepers of the Sound are trademarks of Klipsch Group, Inc., registered in the United States and other countries. The Bluetooth word mark is a registered trademark owned by Bluetooth SIG, Inc. and any use of such mark by Klipsch Group, Inc. is under license. V01 - MK2 - 181217

6.6mm 25133-GROOVE 2ATKO-GROOVE 19 mm 106968621120001 91.8mm 6.6mm 25133-GROOVE 2ATKO-GROOVE 19 mm 106968621120001 91.8mm 6.6mm 25133-GROOVE 2ATKO-GROOVE 19 mm 106968621120001 91.8mm 6.6mm 106971920450001 6.6mm 106971920450001 6.6mm 106971920450001

DATE

:2021-10-1 2 Fede eral Commu unications C ommission Auth horization &

Evaluation D Division 7345 5 Oakland M Mills Road Colu umbia, Mary land 21046 Author rity to Act a asAgent Ono Houj Chin subm ough mmu for a urbehalf,Iap jie, natoactasour mitteddocum ht.Ialsocertif unicationsCo approval with ppointEST T Technology ragentinthep mentsproper fythateachun ommissions h this applica Do preparationo lydescribeth nitmanufactu sregulations ation. Co., Ltd.Ad ongguan, ofthisapplica hedeviceorsy ured,importe swillhaveaffix ddress:Chilin ngxiang, Qis ationforequip ystemforwhi edormarkete xedtoit a lab pmentcertific ichequipmen ed,asdefined bel identical shantou, Sa Guangd cation.Icertif ntcertificatio dintheFeder to that subm antun, dong, fythat oniss ralCo mitted Forin nowl idesw Micr Chin nstanceswhe ledgethatallr withSoundla rolab Industr na ereourautho responsibilit ab Technolo rial Park, No orizedagents tyforcomplyi gy Company o.2 Baozi So signstheapp ngwiththete y LimitedAd outh Road, K plicationforce rmsandcond ddress:No.1 Kengzi, Ping ertificationon ditionsforcer 01,202,Buil gshan Distri nourbehalf,Ia rtification,sti lding 1, ict, ShenZhe ack llres en,

<Sign Name Title Applic nature>

ekenny xie e r on Engineer Certificatio anySound dlab Techno cant Compa ology Comp d pany Limited

DATE : 2021-10-12 Equipment Autorisation Division Federal Communications Commission 7435 Oakland Mills Road Columbia, MD 21046 FCC ID: 2ATKO-GROOVE Product Name: Portable Bluetooth Speaker Request for Confidentiality Pursuant to Sections 0.457 and 0.459 of the commissions rules, we hereby request that the following documents be held confidential:

Schematics Block diagram Operation description These materials contain trade secrets and proprietary information and are not customarily released to the public. The public disclosure of this information might be harmful to the company and provide unjustified benefits to our competitors.

<Signature>

Namekenny xie TitleCertification Engineer CompanySoundlab Technology Company Limited

Soundlab Technology Company Limited I, the undersigned, kenny xie:

The following models have the same technical construction including circuit diagram, PCB Layout, components and component layout, all electrical construction and mechanical construction, except the different appearance, model number and button. 1) Model No.: Groove II 2) Model No.: Groove II PGA 3) Model No.: Groove II Snap ON 4) Model No.: Heritage Groove II 5) Model No.: Heritage Groove II PGA 6) Model No.: Heritage Groove II Snap ON FCC ID: 2ATKO-GROOVE Sincerely, Clients signature :

Clients name / title : kenny xie / Certification Engineer Contact information / address : No.101,202,Building 1, Microlab Industrial Park, No.2 Baozi South Road, Kengzi, Pingshan District, ShenZhen, China Telephone: 0755-28291111 Fax No.: 0755-28290000