International Certifications Link 6020 Wireless Telephones Canada
(Safety) 1 CAN/CSA-C22-2 No. 60950-1 Canada Industry Canada RSS-210 IC: 2128B-602X United States United States 2 UL 60950-1 Part 15, IYG602X 1 TUV Rheinland of North America is a Nationally Recognized Testing Laboratory (NRTL) in the United States and is accredited by the Standards Council of Canada to test and certify products to Canadian National Standards. Clients can demonstrate compliance for both U.S. and Canadian markets through a single mark (cTUVus) on their product(s) which denotes compliance to U.S. and Canadian National Standards. Regulatory Model Number Model Link 6020 Link Base Station Registered Under 602X RCC400 RCC410 RCO400 RCO410 RCH400 RHO400 Notes and Warnings HACThis equipment is Hearing Aid Compatible (HAC). Handset Operation Normal PositionHold the handset as you would any other tele-
phone, with the earpiece to your ear and speak into the microphone. The internal antenna is then positioned properly. Handset Operation Body-Worn PositionTo maintain compliance with RF energy exposure guidelines, if you wear a handset on your body when transmitting, always use the handset with a SpectraLink-supplied accessory as described in the user guide for this handset. SpectraLink supplies belt clips, holsters and lanyards for body-worn operation. Use of accessories not supplied by SpectraLink may cause the handset emissions to exceed RF energy exposure guidelines. The user should not make changes or modifications not expressly approved by Spec-
traLink. Any such changes could void the users authority to operate the equipment. WarningThe earpiece/mouthpiece region on the handset can attract and retain small objects. Trademark Information Information in this document is subject to change without notice and does not represent a commitment on the part of SpectraLink Corporation. SpectraLink Link Are trademarks and registered trademarks of SpectraLink Corporation. The SpectraLink logo is a registered trademark in the United States of America and in other countries. REGULATORY INFORMATION Link 6020 Wireless Telephone Link WTS Base Stations P/N: 72-1401-00-A SpectraLink Corporation 5755 Central Avenue Boulder, CO 80301 303 440 5330 800 676 5465 www.spectralink.com FCC Information Industry Canada (IC) Notice Specific Absorption Rate (SAR) Information Wireless Telephones Link 6020: FCCID IYG602X This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Base Stations This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
! SpectraLink recommends the use of shielded cable for all external signal connections in order to maintain FCC Part 15 emissions requirements. Wireless Telephones Link 602X This device complies with RSS-210 of Industry Canada. Operation is subject to the follow-
ing two conditions: 1) this device may not cause interference, and 2) this device must accept any interference, including interference that may cause undesired operation of the device. This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful inter-
ference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interfer-
ence at his own expense. This Class A digital apparatus complies with Canadian ICES-003. Certification Number IC: 2128B-602X Base Stations RCC400 RCC410 RCO400 RCO410 RCH400 RHO400 This device complies with RSS-210 of Industry Canada. Operation is subject to the follow-
ing two conditions: 1) This device may not cause interference, and 2) this device must accept any interference, including interference that may cause undesired operation of the device. This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful inter-
ference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interfer-
ence at his own expense. This Class A digital apparatus complies with Canadian ICES-003. Certification Number IC: 2128 101 416A Your Wireless Telephone is a low-power radio transmitter and receiver. When it is ON, it receives and also sends out radio frequency (RF) signals. In August 1996, the Federal Communications Commissions (FCC) adopted RF exposure guidelines with safety levels for hand-held wireless telephones. Those guidelines are consistent with the safety standards previously set by both U.S. and international standards bodies:
ANSI C95.1 (1992) American National Standards Institute NCRPReport 86 (1986) National Council on Radiation Protection and Measure-
ments ICNIRP (1996) International Commission on Non-Ionizing Radiation Protection;
DHWCSafety Code 6 Department of Health and Welfare Canada Those standards were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety mar-
gin designed to assure the safety of all persons, regardless of age and health. The exposure standard for wireless mobile phones employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg.2 Tests for SAR are conducted using standard operating positions specified by the FCC with the telephone trans-
mitting at its highest certified power level in all tested frequency bands. Although the SAR is determined at the highest certified power level, the actual SAR level of the telephone while operating can be well below the maximum value. This is because the telephone is designed to operate at multiple power levels so as to use only the power required to reach the network. In general, the closer you are to a wireless Base Station antenna, the lower the power output. Before a phone model is available for sale to the public, it must be tested and certified to the FCC that it does not exceed the limit established by the government-adopted requirement for safe exposure. The tests are performed in positions and locations (e.g., at the ear and worn on the body) as required by the FCC for each model. While there may be differences between the SAR levels of various telephones and at various positions, they all meet the government requirement for safe exposure. 2 In the United States and Canada, the SAR limit for mobile phones used by the public is 1.6 watts/kg (W/kg) averaged over one gram of tissue. The standard incorporates a substantial margin of safety to give additional protection for the public and to account for any variations in measure-
ments. The FCC has granted an Equipment Authorization for this model phone with all reported SAR levels evaluated as in compliance with the FCC RF emissions guidelines. SAR information on this model phone is on file with the FCC and can be found under the Display Grant section of http://www.fcc.gov/oet/fccid after searching on FCC ID IYG602X. Additional information on SAR can be found on the Cellular Telecommunications Industry Association (CTIA) web-site at:
http://www.ctia.org. The only authorized headsets that may be utilized with the the Link 6020 Wireless Tele-
phone are those obtainable from SpectraLink or its reseller partners. The peak SAR values of the Link 6020 Wireless Telephone are:
Body (0.223 mW/g) Head (0.463 mW/g) SAR: Frequency range 902.4817 927.4826 MHz