2AJYB-S1955 FCC IC Instruction For Use_20200110.docx January 10, 2020 3.1 Product labelling requirements Product label must contain following text:
contains FCC ID: 2AJYB-S1955 contains IC: 20504-S1955 See below example for reference 3.2 Instruction for use requirements Instructions for use must contain warnings and customer information, see next two pages for detailed text Declaration of Conformity This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation. This product does not contain any user serviceable components. Any unauthorized product changes or modifications will invalidate warranty and all applicable regulatory certifications and approvals, including authority to operate this device. Warning This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Connect the equipment into an outlet on a circuit different from that to which the receiver Increase the separation between the equipment and receiver. is connected. Consult the dealer or an experienced radio /TV technician for help. Caution:
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Page 6 of 11 StreamUnlimited Engineering GmbH Gutheil-Schoder-G. 10, 1100 Vienna, Austria T +43-1-667 2002, F +43-1-667 2002 4401 2AJYB-S1955 FCC IC Instruction For Use_20200110.docx January 10, 2020 Operations in the 5.15 5.25GHz band are restricted to indoor usage only. RF Exposure Requirements To comply with FCC requirements, a minimum separation distance of 20cm (8 inches) is required between the equipment and the body of the user or nearby persons. Canada:
This Class B digital apparatus complies with Canadian ICES-003 and RSS-247. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation. The installer of this radio equipment must ensure that the product is located such that it does not emit RF field in excess of Health Canada limits for the general population: consult Safety Code 6, obtainable from Health Canadas We site www.hc-sc.gc.ca/rpb. As mentioned before, the installer cannot control the antenna orientation. However, they could place the complete product in a way that causes the problem mentioned above. The device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems. Be advices that high-power radars are allocated as primary users (i.e. priority users) of the bands 5250-5350MHz and 5650-5850MHz and that these radars could cause interference and/or damage to LE-LAN devices. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Cet appareil numrique de classe B est conforme aux normes NMB-003 et CNR-247 en vigueur au Canada. Son fonctionnnement est soumis aux deux conditions suivantes : (1) Cet appareil ne doit pas crer d'interfrences nuisibles. (2) Cet appareil doit tolrer toutes les interfrences reues, y compris les interfrences pouvant entraner un fonctionnement indsirable. L'installateur du prsent matriel radio doit veiller ce que le produit soit plac ou orient de manire n'mettre aucun champ radiolectrique suprieur aux limites fixes pour le grand public par le ministre fdral Sant Canada ; consultez le Code de scurit 6 sur le site Web de Sant Canada l'adresse : www.hc-sc.gc.ca/rpb. Comme indiqu auparavant, l'installateur ne peut pas contrler l'orientation de l'antenne. Il peut nanmoins placer le produit tout entier de manire provoquer le problme dcrit ci-dessus. Les dispositifs fonctionnant dans la bande 5150-5250 MHz sont rservs uniquement pour une utilisation l'intrieur afin de rduire les risques de brouillage prjudiciable aux systmes de satellites mobiles utilisant les mmes canaux. Les utilisateurs de radars de haute puissance sont dsigns utilisateurs principaux (c.--d., qu'ils ont la priorit) pour les bandes 5250-5350 MHz et 5650-5850 MHz et que ces radars pourraient causer du brouillage et/ou des dommages aux dispositifs LAN-EL. Page 7 of 11 StreamUnlimited Engineering GmbH Gutheil-Schoder-G. 10, 1100 Vienna, Austria T +43-1-667 2002, F +43-1-667 2002 4401