Suga Electronics Limited 802.11b/g/n (2T2R) WLAN AP/Router Module User Manual Model: SWP23MA-2 Version: 1.0 18 Jul 2013 Contents 1.1 FCC Caution... 2 1.2 FCC Radiation Exposure Statement...... . 2 1.3 IC Warning....... . 2 2.0 Hardware Installation........................... 3 2.1 Hardware Installation Guide .......... 3 3.0 Software Installation............................ 4 3.1 Booting up.......... 3 3.2 Operation Mode Configuration........ 5 3.3 Local Area Network (LAN) Settings. 6 3.4 Basic Wireless Settings... 7 3.5 Advanced Wireless Settings... 8 3.6 Wireless Security/Encryption Settings..... 9 3.7 Station List.. 10 4.0 Device Labelling .... 11 5.0 Disclaimer.... 11 Suga Electronics Ltd. All Rights Reserved. Information in this document is subject to change without prior notice P. 1 Suga Electronics Limited 1.1 FCC Caution:
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. IMPORTANT NOTE:
1.2 FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment .This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. 1.3 IC WARNING:
RSS(Category I Equipment):
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device. Le prsent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux conditions suivantes :
(1) l'appareil nedoit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en compromettre le fonctionnement. Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication. Conformment la rglementation d'Industrie Canada, le prsent metteur radio peut fonctionner avec une antenne d'un type et d'un gain maximal (ou infrieur) approuv pour l'metteur par Industrie Canada. Dans le but de rduire les risques de brouillage radiolectrique l'intention des autres utilisateurs, il faut choisir le type d'antenne et son gain de sorte que la puissance isotrope rayonne quivalente (p.i.r.e.) ne dpasse pas l'intensit ncessaire l'tablissement d'une communication satisfaisante. Suga Electronics Ltd. All Rights Reserved. Information in this document is subject to change without prior notice P. 2 Suga Electronics Limited Suga Electronics Ltd. All Rights Reserved. Information in this document is subject to change without prior notice P. 3 Suga Electronics Limited 2.2 The SWP23MA-2 WLAN module will be installed into the embedded system user various operation systems(OS) such as Windows 2000/XP/CE or Linux.In this OEM manual,we will use Window XP as an example to show you how to install the driver on the OS. The SWP23MA-2 setup Wizard will guide you through the installation procedure.This Wizard will also guide you installing the utility and drivers. Note :The comments and conditions for other OS platform may be different from this chapter. 3.0 Software Installation 3.1 Booting up Connect the power adapter to two 2x 8pin-2.0mm pitch connectors to power up the module, Connect the Ethernet port to the PC, then enter http://10.10.10.254 into Internet Explorer to open the AP/router home page. As below:
Suga Electronics Ltd. All Rights Reserved. Information in this document is subject to change without prior notice P. 4 Suga Electronics Limited 3.2 Operation Mode Configuration Select Operation Mode to configure the operation mode to fit you environment, in this menu, there are four options, please follow the description to choose the option you needed. If you want the module to act as an AP and Client, you should select AP Client mode and enable then click Apply. Suga Electronics Ltd. All Rights Reserved. Information in this document is subject to change without prior notice P. 5 Suga Electronics Limited 3.3 Local Area Network(LAN) Settings Select LAN option to set your home page IP, subnet mask, default gateway etc. the default IP is 10.10.10.254. Suga Electronics Ltd. All Rights Reserved. Information in this document is subject to change without prior notice P. 6 Suga Electronics Limited 3.4 Basic Wireless Settings You could configure the minimum number of Wireless settings for communication, such as Network Name (SSID), Network Mode (802.11b/g/n) and Channel. The Access Point can be set simply with only the minimum setting items. Suga Electronics Ltd. All Rights Reserved. Information in this document is subject to change without prior notice P. 7 Suga Electronics Limited 3.5 Advanced Wireless Settings Use the Advanced Setup page to make detailed settings for the Wireless. Advanced Setup includes items that are not available from the Basic Setup page, such as Beacon Interval, Control Tx Rates and Basic Data Rates. Suga Electronics Ltd. All Rights Reserved. Information in this document is subject to change without prior notice P. 8 Suga Electronics Limited 3.6 Wireless Security/Encryption Settings Setup the wireless security and encryption to prevent from unauthorized access and monitoring. Suga Electronics Ltd. All Rights Reserved. Information in this document is subject to change without prior notice P. 9 Suga Electronics Limited 3.7 Station List You could monitor stations which associated to this AP here. Suga Electronics Ltd. All Rights Reserved. Information in this document is subject to change without prior notice P. 10 Suga Electronics Limited Suga Electronics Ltd. All Rights Reserved. Information in this document is subject to change without prior notice P. 11 Suga Electronics Limited Contain FCC ID: VZFSWP23MA2 and Contain IC ID: 10609A-SWP23MA2
(1). Make the module label visible so that the FCC/IC ID is visible in the end construction.
(2). Label the end product with the FCC ID and IC ID of the module. For example 4.0 Device Labelling The host device containing this module must either:
5.0 Disclaimer Suga Electronics Limited assumes no responsibility for errors or omissions in the materials available on this Document. THESE MATERIALS AND INFORMATION ARE PROVIDED AS IS WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESS OR IMPLIED , INCLUDING BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, OR NON-INFRINGEMENT. Suga uses reasonable efforts to include accurate and up-to-date information on this Document;
it does not, however, make any representations as to its accuracy or completeness of the information, text, graphics, links or other items contained within these materials. Your use of this Document is at your own responsibility. Suga, its suppliers, and other parties involved in creating and delivering this Documents contents shall not be liable for any special, indirect, incidental, or consequential damages, including without limitation, lost revenues or lost profits. Suga Electronics Ltd. All Rights Reserved. Information in this document is subject to change without prior notice P. 12