FCC ID: 2A767-SWT0007 RF Remote

1. " LOW, MED, HI" buttons:

These three buttons are used to set the fan speed as follows:

or

= Low speed or

= Medium speed or

= High speed 2. button: This button turns the fan off. 3. button:This button will make forward or reverse the fan. 4. The button turns the light ON or OFF . Press and release the button to turn the light ON or OFF 5.The button turns the light ON or OFF . Press and release the button to turn the light ON or OFF 6.5.This CCT button changes the color temperature of the light IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, no change to the antenna or the device is permitted. Any change to the antenna or the device could result in the device exceeding the RF exposure requirements and void users authority to operate the device. Notice: The changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. FCC Caution: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. This device complies with Industry Canada RSS for license-free radio equipment. Operation is allowed under the following two conditions: (1) the equipment shall not produce interference, and (2) the equipment user must accept any radio interference, even if the interference may endanger the operation of the equipment. The term IC: before the radio certification number only signifies that Industry Canada Technical specifications were met. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Importante: para satisfacer con los requisitos sobre cumplimiento de exposicin de radiofrecuencia de FCC, prohibe hacer el cambio en antenas o dispositivo. Cualquier cambio en la antena o el dispositivo puede hacer al dispositivo a violar los requisitos de exposicin a radiofrecuencia y privandole al usuario el derecho a operar el dispositivo. Nota: los cambios o modificaciones que no hayan sido aprobado explcitamente por las partes responsables causarn privaci n de derecho a operar el equipa los usuarios. Advertencia de FCC: este dispositivo est cumplido con artculo 15 de las reglas de FCC. La operacin debe cumplir las siguientes dos condiciones: (1) el dispositivo no se genera interferencias dainas, y (2) el dispositivo debe compartir con cualquier interferencia recibida, incluidas las interferencias que pueden causar operaciones inesperadas. Este dispositivo se satisface como el equipo de radio sin licencia de la RSS del Ministerio de Industria de Canad. Se permite la operacin en las siguientes dos condiciones: (1) el dispositivo no se genera interferencia, y (2) el usuario del dispositivo debe compartir con cualquier interferencia de radio, incluso si la interferencia puede perjudicar el funcionamiento del dispositivo. El trmino "IC" antes del nmero de certificacin de radio: "se significa el cumplimiento con las especificaciones tcnicas industriales canadienses. La operacin debe cumplir las siguientes dos condiciones: (1) el dispositivo no se genera interferencias dainas, y (2) el dispositivo debe compartir con cualquier interferencia recibida, incluidas las interferencias que pueden causar operaciones inesperadas. REMARQUE IMPORTANTE: Pour se conformer aux exigences de conformit de la FCC RF en matire dexposition , aucune modification de lantenne ou de lappareil nest autorise. Tout changement apport lantenne ou l appareil pourrait entraner le dpassement des exigences dexposition aux RF et annuler lautorisation de lutilisateur de faire fonctionner lappareil. Avis : Les changements ou modifications non expressment approuvs par la partie responsable de la conformit pourraient annuler lautorisation de lutilisateur dutiliser lquipement. Attention FCC : Cet appareil est conforme la partie 15 des rgles de la FCC. Le fonctionnement est soumis aux deux conditions suivantes : (1) Cet appareil ne doit pas causer dinterfrences nuisibles, et 2) cet appareil doit accepter toute interfrence reue, y compris les interfrences pouvant causer un fonctionnement indsirable. Cet appareil est conforme aux Industry Canada RSS pour lquipement radio sans licence. Le fonctionnement est autoris dans les deux conditions suivantes : (1) lquipement ne doit pas produire de brouillage et (2) lutilisateur de l quipement doit accepter tout brouillage radio, mme si le brouillage peut mettre en danger le fonctionnement de l quipement. Le terme IC avant le numro de certification radio signifie seulement que les spcifications techniques dIndustrie Canada ont t respectes. Le fonctionnement est soumis aux deux conditions suivantes : (1) cet appareil ne doit pas causer dinterfrences, et (2) cet appareil doit accepter toute interfrence, y compris les interfrences qui peuvent causer un fonctionnement ind sirable de lappareil.

Summer Wind International Ltd 2023.06.02 Eurofins Electrical and Electronic Testing NA, Inc. 914 W. Patapsco Avenue Baltimore, MD 21230 USA RE: LETTER OF AGENT AUTHORIZATION To Whom It May Concern:

We, the undersigned, hereby authorize Shenzhen BCTC Testing Co., Ltd to act on our behalf in all matters relating to application for equipment authorization, including the signing of all documents relating to these matters. We also hereby certify that no party to the application authorized hereunder is subject to the denial of benefits, including FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C.853(a). This agreement expires one year from the current date. Sincerely, Clients signature:

Clients name / title : Deon chen /Manager Contact information / address: No.39, Jinou Road, Jianghai District, Jiangmen City, Guangdong Province, China.

Summer Wind International Ltd 2023.06.02 Eurofins Electrical and Electronic Testing NA, Inc. 914 West Patapsco Avenue Baltimore, MD 21230 RE: Attestation Statements Part 2.911(d)(5)(i) request for 2A767-SWT0007

[Summer Wind International Ltd] (the applicant) certifies that the equipment for which authorization is sought is not covered equipment prohibited from receiving an equipment authorization pursuant to section 2.903 of the FCC rules. Sincerely,

(Applicant signature)

(Applicant printed name): Deon chen Summer Wind International Ltd 2023.06.02 Eurofins Electrical and Electronic Testing NA, Inc. 914 West Patapsco Avenue Baltimore, MD 21230 RE: Attestation Statements Part 2.911(d)(5)(ii) request for 2A767-SWT0007

[Summer Wind International Ltd (the applicant) certifies that, as of the date of the filing of the application, the applicant is not identified on the Covered List as an entity producing covered equipment. Sincerely,

(Applicant signature)

(Applicant printed name): Deon chen

Summer Wind International Ltd 2023.06.02 Eurofins Electrical and Electronic Testing NA, Inc. 914 W. Patapsco Avenue Baltimore, MD 21230 USA RE: CONFIDENTIALITY REQUEST FOR EUT NAME: RF Remote Trademark: N/A MODEL: SW-T0007-01, SW-T0007-02 FCC ID:2A767-SWT0007 To Whom It May Concern:

This letter serves as an official request for confidentiality under sections 0.457 and 0.459 of CFR 47. We have requested that the

- Block Diagram

- Schematics

- Operational Description required to be submitted with this application be permanently withheld from public review. The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these materials may be harmful to the applicant and provide unjustified benefits to its competitors. Please contact me if there is any information you may need. Sincerely, Clients signature:

Clients name / title : Deon chen /Manager Contact information / address: No.39, Jinou Road, Jianghai District, Jiangmen City, Guangdong Province, China.

Summer Wind International Ltd Model Difference 2023.06.02 RE: LETTER OF MODEL DIFFERENCE EUT NAME: RF Remote Trademark: N/A MODEL: SW-T0007-01, SW-T0007-02 FCC ID:2A767-SWT0007 There are differences in appearance between the two models, the RF chip and pcb layout remains unchanged. Model: SW-T0007-01 Model: SW-T0007-02 Regards Sincerely Clients signature Clients signature:

Clients name / title : Deon chen/ Manager Contact information / address: No.39, Jinou Road, Jianghai District, Jiangmen City, Guangdong Province, China.

Summer Wind International Ltd U.S. Agent Designation for Service of Process

(Applicant and U.S. Agent are Separate Parties) TO: Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046, USA ATTENTION: FCC Certification Section 2.911(d)(7) Information Designated U.S. Agent Company Name: Baihetian Innovative Solutions FRN: 0033401605 Contact Name: Kenneth Young Street Address: 6837 Chase Rd City/Province/Zip: Dearborn, MI 48126 Telephone No: 313-395-3113 Email: ken.young@baihetiansolutions.com This letter is to confirm that we (the Designated U.S. Agent) have accepted the responsibility to act as the Designated U.S. Agent for Service of Process as required by section 47 CFR 2.911(d)(7) on behalf of the Applicant noted below. U.S. Agent Signature:

Date:

Signed by (Printed Name/Title):

The Applicant acknowledges that they must maintain an agent for no less than one year after terminating all marketing and importation OR the conclusion of any Commission-related proceeding involving the equipment. The applicant further acknowledges their responsibility to inform the FCC whenever the Designated U.S. Agent information above changes. Applicant Company name: Summer Wind International Ltd Grantee Code: 2A767 FCC ID:2A767-SWT0007 Contact Name: Deon chen Street Address: No.39, Jinou Road, Jianghai District, Jiangmen City, Guangdong Province, China.Telephone No: +86 0750-7360988 Email: Lbkj1169@163.com Applicant Signature:

Date: 2023-06-06 Signed by (Printed Name/Title): Deon chen /Manager