Sunitec Enterprise Co., Ltd FCC ID: 2AMX3BMS001 To the certification reviewer:
We are hereby applying for full modular approval of the above-referenced FCC ID, based on compliance with all of the criteria as detailed below. Sincerely, Yan Shum .
[signature]
[Yuanshun Li]
[General manager]
Part 15 Unlicensed Single Modular Transmitter Approval Justification per 15.212 Requirement per 15.212 reference
(i) The radio elements of the modular | The module must be installed in Bluetooth speaker transmitter must have their own RF | set and Bluetooth speaker have shielding. shielding.
(ii) | The modular transmitter must have buffered | All modulation and data inputs are buffered by modulation/data inputs (if such inputs are | circuitry on the transmitter chip. provided.
(iii) | The modular transmitter must have its own | RF voltage regulation is handled on the module. power supply regulation.
(iv) The modular transmitter must comply with | The modular with permanently antenna. the antenna and transmission system requirements of 15.203, 15.204(b) and 15.204(c).
(v) | The modular transmitter must be tested in a | Testing was performed with the module extended stand-alone configuration, i.e., the module | outside of the host on a special extender board, as must not be inside another device during | shown in the test setup photos. testing for compliance with Part 15 parameters.
(vi) The modular transmitter must be equipped | A sample of the host label is provided as an exhibit, with either a permanently affixed label or must be capable of electronically displaying its FCC identification number. If the FCC ID is not visible when the module is installed inside another device, then the outside of the device into which the module is installed must also display a_ label referring to the enclosed module. showing the FCC identifier of the module.
(vii) The modular transmitter must comply with any specific rules or operating requirements that ordinarily apply to a complete transmitter and the manufacturer must provide adequate instructions along with the module to explain any such requirements. A copy of these instructions must be included in the application for equipment authorization. The module complies fully with the operating requirements of Part 15 section C as demonstrated in the test report exhibit.
(viii) The modular transmitter must comply with any applicable RF exposure requirements in its final configuration. Yes, Please see the SAR TEST EXCLUSION EVALUATION REPORT, the modular meets exclusion evaluation of FCC 47 CFR Part 2.1093.