ENFORCE
: - e Frequency 433.92MHz Single Channel RF Operates up to 500ft (150m)*
Transmitter Over 68 billion (6.8x10") possible codes e LED transmission indicator SK-939Tx-GxQ1 (433.92MHz) e Includes one 3VDC lithium battery (CR-2032)
. Compact size Installation Manual Compatible with all SECO-LARM SK-series receivers of the same frequency e Also available without logo SK-939T1-GBUQ1 - 433.92MHz
* Actual range will vary depending on the installation and operating environment Dimensions Fe @ 144" (31.5mm) She" (8mm) If Specifications Model SK-939T4-GNUQ1 SK-939T3-GNUQI SK-939T2-GNUQ1 SK-939T1-GBUQ1 SK-939T4-GNQ1 SK-939T3-GNQIL SK-939T2-GNQL SK-939T1-GBQI Power 3VDC battery (CR-2032, included) RF Frequency 433 S2MHz
# of Buttons 1 2 3 4 Channels 1 d 1 1 IP Rating IP 68 Waterproof Possible codes Over 68 billion (6.8x10") Dimensions ia"x2%r6"xShe" (31.5x5x8 mm) California Proposition 6 Warning: These products may contain chemicals which are known to the State of California to cause cancer and birth defecs or other reproductive harm For more information, go to www PE5Warninas.ca.qow WARRANTY: This SECO-LARM product & warranted against defects in material and workmanship while used in normal service far one (I) year fram the date of sale to the original customer, SECO-LARMS obligation is itrited to the repair or replacement of any detective part ifthe unit is returned, transportation prepaid, to SECO-LARM. This Warranty is void i damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair or alteration, improper ar abnormal usage, arfauty installation, orif for any other reason SECO-LARM deterrnines that such equipment is nat operating properly a5 a result of causes ather than defects in material and workmanship, The sole obligation of SECO-LARM and the purchasers exclusive remedy, shall he limited to the replacement or repair only, at SECO-LARMS option. in na event shall SECO-LARM be liable for any special, callateral, incidental, or consequential persanal or property damage of any kind to the purchaser or anyane else NOTICE: The SECO-LARM policy i one of confinual development and improvement. For that reason, SECO-LARM reserves the right to change spectications without notice SECO-LARMis alsa not responsible for misprints, Alltradernarks are the property of SECO-LARM U.S.A., Inc. or their respective owners. Copyright 2023 SECO-LARMUSAA,, Inc Allrights reserved. SECO-LARM U.S.A., Inc. 7 16842 Millikan Avenue, Irvine, CA 92606 Website: www.seco-larm.com wf FITS Phone: (949) 261-2999 | (800) 662-0800 Email: sales@secotarm.com M_sk-s09T1-x@_230314 docx ENFORCER FCC / IC COMPLIANCE STATEMENT FCC ID: K4E919T4G-1 IC ID: 23770-K919T4GNUQL This device complies with FCC Rules Part 15. Operation is subject to the following two conditions:
+ This device may not cause harmful interference.
+ This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the Federal Communications Commission (FCC) rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment causes harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by doing one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Any changes or modifications not expressly approved by the party responsible for compliance could void the user_s authority to operate the equipment. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. To maintain compliance with FCC exposure compliance requirement, please follow operation instruction as documented in this manual. This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada s licence-exempt RSS(s). Operation is subject to the following two conditions:
1. This device may not cause interference. 2. This device must accept any interference, including interference that may cause undesired operation of the device. Cet appareil contient un ou des metteurs/rcepteurs exempts de licence conformes aux RSS exempts de licence d'innovation, Sciences et Dveloppement conomique Canada. Le fonctionnement est soumis aux deux conditions suivantes 1. Cet appareil ne doit pas provoquer dinterfrences. 2. Cet appareil doit accepter toutes les interfrences, y compris les interfrences susceptibles de provoquer un fonctionnement indsirable de l'appareil This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment.The device has been evaluated to meet general RF exposure requirement. Le matriel est conforme aux limites de dose dexposition aux rayonnements noncs pour fac un autre environnement.ce dispositif a t valu a satisfaire l'exigence genrale de l'exposition aux rf. SECO-LARM U.S.A., Inc. 16842 Millikan Avenue, Irvine, CA 92606 Website: www.seco-larm.com afe Prsvil Phone: (949) 261-2999 | (800) 662-0800 Email: sales@seco-larm.com _MLSK-s19T1-Gx4_230314 docx