#99112 WALKIE TALKIE USER MANUAL HOW TO OPERATE YOUR WALKIE TALKIE 1. Open battery cover and snap in a 9-volt battery. 2. Turn the "ON-OFF" switch to "ON" position. Your Walkie Talkie is new ready to operate. 3. Press the "Push-To-Talk" switch fon transmitting. Release the "Push-To-Talk" switch for receiving. 5. When transmitting, speak clearly in a normal voice, holding the set about 3" from your mouth. 6. Best transmission and reception are obtained when the antenna is held in a vertical position. 7,2 SPARE COVER FOR CHANGEABLE OF THE WALKIE TALKIE IN DECORATION.
CAUTION :
1. Your Transceiver Set has been fully adjusted prior to shipment from the factory. Be sure not to touch the internal components other than replacing the battery. 2. When the sound becomes weak, it is time to change the battery. 3. After use, always return the "ON-OFF" switch to the "OFF" position. 4. Keep your set in a dry and clean place.
- NON-RECHARGEABLE BATTERIES ARE NOT TO BE RECHARGED.
- RECHARGEABLE BATTERIES ARE TO BE REMOVED FROM THE TOY BEFORE BEING CHARGED (IF REMOVEABLE).
- RECHARGEABLE BATTERIES ARE ONLY TO BE CHARGED UNDER ADULT SUPERVISION (IF REMOVEABLE)
- ONLY BATTERIES OF THE SAME OR EQUIVALENT TYPE AS RECOMMENDENCE ARE TO BE USED.
- BATTERIES ARE TO BE INSERTED WITH THE CORRECT POLARITY.
- EXHAUSTED BATTERIES ARE TO BE REMOVED FROM THE TOY.
- THE SUPPLY TERMINALS ARE NOT TO BE SHORT CIRCUITED.
- THE PACKAGING HAS TO BE KEPT SINCE IT CONTAINS IMPORTANT.
- DO NOT USE RECHARGEABLE BATTERIES. Waming: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
o Reorient or relocate the receiving antenna, o Increase the separation between the equipment and receiver. o Connect the equipment into an outlet on a circuit different from that to which the receiver is needed. o Consult the dealer or an experienced radio/TV technician for help.
