AXM-9300 Wireless Optical Mouse User Manual AXM-105 Users Guide 1. Connecting with Computer:
The first time you take out this mouse and receiver from the packing, Factory Preset ID enables Plug and Play function. Plug the Receiver into PC USB Port . Under Win2000 or higher , wait for the OS to detect the RF device. Under Win98 or lower installation a of driver for the device is :
necessary. |
Insert the batteries into the mouse and move it for a while , then it starts working . 2. Inserting Batteries:
A. Press gently inwards on battery cover with Open sign and pick it up from the compartment . B. Insert 2 AAA batteries Into compartment with correct orientation . C, Slide the battery cover into the compartment and close the cover 3. ID Link:
When Factory ID has been changed or wish to be changed , link ID as below :
A, Press the ID button on the bottom of the mouse and the led on it starts blinking . B, Press the ID button on the top of the receiver. When blinking of that led tums faster , ID Link is OK . ID linking should be completed within 10 seconds or connection would be failed!
4. Power Saving Mode:
A, Suspend Mode :
Keep mouse stationary for 10 minutes, mouse will be automatically set to Suspend Mode. Press left button to wake up the mouse again. B. Power Off Mode :
When you wish to set the mouse to power off mode, press mouse ID for 3 seconds . The Optical Led will flash once and then fade out showing mouse power is already off. Press ID switch for waking up again . 5. Trouble Shooting:
A, When mouse doesnt respond, check the battery power status, and replace new batteries if they are low power . B. Make sure the batteries are in right orientation and Led of the mouse lightens normally when you move the mouse. C. Check if Led of the receiver blinks when you move the mouse . D. When Led of the receiver doesnt blink even you move the mouse , do linking ID again. ID Switch Receiver Nemko Notice This device complies with EMC Directive 89/336/EEC, Low Voltage Directive 76/2/EEC and R&TTE Directive 995/5/EEC This product has been approved for upper Directives and covers the following countries Austria Belgium Cypress Czech Denmark Estonia Finland France Germany Greece Hungary Ireland Ttaly Latvia Lithuania Luxembourg Macedonia Netherlands Poland _ Portugal Slovenia Slovakia Spain Sweden Switzerland UK. FCC Note :
This equipment has been tested and comply with the limits for a lass B digital device, pursuant to Part 15 of the FOC Rules. These limits are designed to provide reasonable protedion. This equipment generates, uses and can radiated radio frequency energy and, if not installed and wed in aecordance with the instructions, may cause harmful intererence to radio oormmunications. However, there is no guarantes that interferenos will not ooour in a particular installation if this equipment does cause harmful interferenos to radio or television reception, which oan be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the reosiving antenna. Increase the separation between the equipment and receiver
-Connect the equipment into an outlet on a circuit different trom hat to which the reosiver is connected
~Consult the dealer or an experienced rado/TV technician for help. Changes or modifications not expressly approved by the party responsible for complianos could void the user's authority to operate the equipment, The antenna(s) used for this transmitter must not be colocated or operating in conjunction with any other antenna or transmitter IMPORTANT ECC REQUIREMENT. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, FCC ID: HQXAXM-9300 including interference that may cause undesired operation.