RayNeo Ring user manual Understand the product Charging touchpoint Silicone finger cover Touchpad (supports pressing) Return key Box contains Controller x 1 Charging cable x 1 Silicone finger cover x 2 User manual x 1 Charging Connect the magnetic suction line to the controller charging touchpoint for charging Connect the magnetic wire For charging Wear Remove the controller, wear it as shown, use the thumb to control the buttons, Do not push hard to the end of the finger Silicone Finger Cover Replacement If the controller rotates during control, the small silicone finger cover can be replaced and used Power on Wake up with any key In the shutdown or sleep state, press any key to wake up the controller Sleep and shutdown After the controller has no operation for 30s, it will enter a sleep state, and you can continue to use it by pressing any key. Wake up with any key Disconnect Touchpad and return key are simultaneously pressed for 3s to disconnect the Bluetooth connection, and the controller is turned off Product Information Product nameRayNeo Ring Product modelARRF60 Wireless connection: Bluetooth Battery capacity30mAh FCC ID :2ACCJN066 FCC Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference.
(2)This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. Note:This equipment has been tested and found to comply with the limits for a class B digital device,pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequence energy and,if not installed and used in accordance with the instructions,may cause harmful interference to radio communications.However,there is no guarantee that interference will not occur in a particular installation.if this equipmemt does cause harmful interference to radio or television reception,which can be determined by turning the equipment off and on,the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an autlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.