FCC ID: 2AUVZ-TX-RC-1 Smart remote controller

Smart remote controller/TX-RC-1 User Guide/Warranty Thank you for choosing EZCon Smart remote controller TX-RC-1. This Quick Instruction Manual explains the basic installation and using procedures. For the introduction of detailed product installa-

tion and troubleshooting, please visit the official website at www.teamyoung.com.tw for downloading. Package contains Smart remote controller Quick Instruction Manual USB Cable AAA Battery The product complies with NCC Administrative Regula-

tions on Low Power Radio Waves Radiated Devices Article 12Without permission granted by the NCC, any company, enterprise, or user is not allowed to change frequency, enhance transmitting power or alter original characteristic as well as performance to an approved low power radio-frequency devices. Article 14The low power radio-frequency devices shall not influence aircraft security and interfere legal communications; If found, the user shall cease operating immediately until no interference is achieved. The said legal communications means radio communi-

v cations is operated in compliance with the Telecommu-

nications Act. The low power radio-frequency devices must be susceptible with the interference from legal communications or ISM radio wave radiated devices. To avoid the danger of electric arc to user and damage of electrical switch contact, please do not plug or unplug powered-on RX products. Please download EZCon_PC-tools file in advance on Team Young official website at www.teamyoung.com.tw. For the first time of use, please select File/New, or select File/Open file that has already been edited. After your layout of each specified layer is edited, please save the file. After file has been edited, please use USB Cable to connect laptop/PC with Smart remote controller and press SET button to enter into the transmission mode. Then write the IP data of terminal points to TX-RC-1. Screen Battery indicatorRed light indicates insufficient battery level and suggests changing the battery. Signal indicatorBlue light indicates that control signal is transmitting. OFFTurn off ONTurn on Button LeftSwitch to left RightSwitch to right UpSwitch upward DownSwitch downward STOPEmergently stop Button L/FTurn off local luminaires L/NTurn on local luminaires IPause(roll-up doors/curtains) IILock(roll-up doors) SET Entering setting mode Functional settings and hotkeys of TX-RC-1 Short press SET button to display the version of TX firmware. Long press SET button for 5 sec. to enter into setting mode select a specific operating mode A. Data transmission/importing mode - transmit data to the PC

(Hotkey: SET + Up direction button) B. RX Burning - Connect to RX & write IP of terminal points to RX (Hotkey: SET + Down direction button) C. TX-RC-1 authorizing remoter - Transmit the layout of major TX-RC-1 to other minor TX-RC-1 (Hotkey: SET +Left direction button) D. TX-RC-1 receiver - Receive the layout of major TX-RC-1(Hot-

key: SET +Right direction button) E. Other modeFor setting sleep time, brightness of screen, TX control range parameter, RX control range parameter etc.. Press ON button to confirm & execute the command. Press STOP button to return to the menu of layout. USB port-Micro-B-female connector

(For receiving) USB port-Type-A-female connector

(For transmitting) Precautions for safe use Components of TX-RC-1 Power Key Product Name/Model Product specifications the product exceeding the rated voltage/current. D. Failure and damage caused by transportation, movement, Smart remote controller / TX-RC-1 dropping, and collision of product after purchasing. Country of Origin Made in Taiwan Rated Voltage DC 3V(AAA Battery*2) Radio Frequency 433.92MHz Range of working Temperature 0~40 Net Weight Dimension 65g(without battery) 88g(with battery) H132.5 * W55.5 * D16.5mm

* If the information of RoHS Compliance Declaration is required, please visit our website at www.teamyoung.com.tw

* The Republic of China (R.O.C.) Patent No.I63439

* The mercury content of this product complies with the regulation of the Environmental Protection Administration Verification No.05129-AR4. Please recycle used batteries CC AK18LP2440 T0 Warranty term & product guarantee certificate With this product guarantee certificate, this product is subject to limited one-year free repair service since the date of purchase, but the warranty does not include consumables (e.g. battery). Within the warranty period, damage caused by the following conditions is not included under warranty. If repairing is required, Team Young Technology Co., Ltd. or authorized distributors will charge the material, inspecting, repairing, and administrative costs:

A. Without following the instruction of this Quick Instruction Manual to install and operate the product or use unap-

proved accessories for the product. B. Damage caused by irresistibly natural disaster, pest, rodent, and human negligence. C. Damage caused by misuse, abuse, vandalism, poor temperature/humidity environment, without following instructed power supply under rated voltage/current, or v E. Damage resulted from unauthorized disassembling of EZCon related products, which is not executed by authorized distributors and technicians of manufacturer. F. Using product in extreme environment of corrosion is also excluded from warranty, such as in high temperature and humidity, in sulfur areas, at the beach, and on the ship etc.. Product Guarantee Certificate Product Model Smart remote controller / TX-RC-1 912-1800000053 Product Batch

(Year of manufacture) Name of Customer

/Company Place of Purchase Date of Purchase Stamped by Distributor

/ Manufacturer

* The 5th~6th code of Product Batch indicates the year of manufacture, e.g. the year of manufacture for 912-18XXXXXXXX is 2018. 18th Floor, No. 400, Huanbei Road, Zhongli District, Taoyuan City, Taiwan, R.O.C. Tel : +886-3-2805160 Fax : +886-3-2805182 www.teamyoung.com FCC ID: 2AUVZ-TX-RC-1 FCC warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and undesired operation. Notice:

(2) this device must accept any interference received, including interference that may cause Any changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/ TV technician for help.

35mm Smart remote Controller Rated Voltage : DC 3V(AAA Battery*2) Radio Frequency : 433.92MHz Net Weight : 65g(without battery) /

88g(with battery) Dimesion : 132.5 * 55.5 * 16.5mm Country of Origin : Made in Taiwan Year of manufacture & NO. :

FCC ID:2AUVZ-TX-RC-1 23mm A 2.06mm Smart remote Controller Rated Voltage : DC 3V(AAA Battery*2) Radio Frequency : 433.92MHz Net Weight : 65g(without battery) /

88g(with battery) Dimesion : 132.5 * 55.5 * 16.5mm Country of Origin : Made in Taiwan Year of manufacture & NO. :

3mm A

: 2.06mm

: 3mm

RF_ 160, Issue 04

(On manufacturer's company letter heading)

(address) Declaration of Authorization Declare that:

Name Representative of agent: Alice Lin Agent Company name: A Test Lab Techno Corp Address: No. 140-1, Changan Street, Bade District, City: Taoyuan City, 33465 Country Taiwan (R.O.C) is authorized to apply for Certification of the following product(s):

Product description: Smart remote controller Type designation: TX-RC-1 Trademark: EZCon Validity/ expiry date Nov. 14, 2020 on our behalf. Date: Nov. 15, 2019 City; == Taoyuan City 32070 Functions 08 Notes:

(1): Required for FCC application

(2): For FCC it must be the Grantee Code owner or the authorized agent.

FCC, Request for non-disclosure Date: 21-Nov-2018 RF_501, Issue 8 Page 1 of 1 Company Name: TEAM YOUNG TECHNOLOGY CO., LTD. Address: 18F-1, No.400, Huanbei Rd., Zhongli District, City: Taoyuan City 320, Centar TaiwanfROP\

To: Telefication B.V., Dept. FCC TCB Edisonstraat 12A 6902 PK ZEVENAAR The Netherlands Subject: Request for confidentiality FCC 1D: 2AUVZ-TX-RC-1 Reference number: ###H#H#t Vear FOU Cp, 1. Long-Term Confidentiality Pursuant to 47 CFR Section 0.459(a) & (b), we hereby requests non-disclosure and confidential treatment of the following materials submitted in support of FCC certification application:

Bill(s) of Material 1 Block Diagrams I Operational Description KJ Schematic Diagrams (1 Tune-up Procedure Above materials contain secrets. proprietary and technica! information. which would customarily be guarded from competitors under 47 CFR, section 0.457(d)(2). Disclosure or publication or any portion of this company confidential material to other parties could cause substantial competitive harm and provide unjustified benefits for competitors. 2. Short-Term Confidentiality (STC) Fursuant to FuDIC NOUCe VA U4-1/ U0 OF The VLOMMISSION S polcy, in order to comply with the Markeung regulations in 47 CFR 2.803 and the importation rules in 47 CFR 2.1204, applicant hereby requests Short-Term Confidential treatment of the following materials (See notes below):

(& Internal Photos User's Manual &] Test Set-up Photos &) External Photos Justification:

Date: Nov. 15, 2019 Name and signature of applicant: % q af Notes:

1) A document or type of document can only have ONE type of confidentiality!

2) Short-Term confidentiality is in principle for 45 days from date of grant; it can be extended max 3 times (total time 180 days max.)!

The planned date should stated in the RF731 application form. 3) FCC must be informed when marketing begins earlier. 4) Release takes place automatically thus extension must be requested in time. Telefication does not remind you of this!

5) Request for extension or for release must be received by Telefication at least 7 days before date of actual marketing or before expiration of the STC period