W WLTMS-110 LTE Cat 6 B42_43_48 TD-LTE HE Outdoor CPE Product Specification Version 0.7b Gemtek Technology Co., Ltd. www.gemteks.com No.15-1 Zhonghua RoadIndustrial Park, HuKou Hsiang, HsinChu Hsien,Taiwan, R.O.C. Revision History Revision Date Description May. 11th, 2015 Documents Created Aug. 15th, 2015 Update LEDs Apr. 23th, 2016 Update LEDs / 802.3at Jun. 23th, 2016 Update typo Sep. 19th, 2016 Update typo Jun. 01st, 2017 Correct Dimension July. 01st, 2017 Updated certification Feb. 01st, 2018 Updated B48 0.1 0.2 0.3 0.5 0.6 0.7 0.7a 0.7b Author Louis_Chuang Louis_Chuang Louis_Chuang Louis_Chuang Louis_Chuang Louis_Chuang Louis_Chuang Louis_Chuang Copyright 2005-2006 GEMTEK TECHNOLOGY CO., LTD. This document is copyrighted with all rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language in any form by any means without the written permission of GEMTEK TECHNOLOGY CO., LTD. Notice GEMTEK TECHNOLOGY CO., LTD. reserves the right to change specifications without prior notice. While the information in this manual has been compiled with great care, it may not be deemed an assurance of product characteristics. GEMTEK TECHNOLOGY CO., LTD. shall be liable only to the degree specified in the terms of sale and delivery. The reproduction and distribution of the documentation and software supplied with this product and the use of its contents is subject to written authorization from GEMTEK TECHNOLOGY CO., LTD.. w 2 Contents Revision History ................................................................................................................................ 1 Copyright ........................................................................................................................................... 2 Notice.................................................................................................................................................. 2 CONTENTS............................................................................................................................................. 3 CHAPTER 1 INTRODUCTION ............................................................................................................ 4 Purpose and Scope ........................................................................................................................... 4 Product Features ............................................................................................................................... 4 Definitions, Acronyms and Abbreviations...................................................................................... 4 References ......................................................................................................................................... 4 CHAPTER 2 HARDWARE REQUIREMENT....................................................................................... 5 General Specification ........................................................................................................................ 5 ID design ............................................................................................................................................ 5 Unit Interface_ODU ........................................................................................................................... 6 LED Indicators _ODU ........................................................................................................................ 6 Architecture _ ODU ........................................................................................................................... 7 HW / Radio Specification_ODU ........................................................................................................ 7 Environmental Specification_ODU .................................................................................................. 8 Regulatory Specification_ODU CE .................................................................................................. 8 Regulatory Specification_ODU FCC ................................................................................................ 8 Reliability Specification .................................................................................................................... 8 CHAPTER 3 SOFTWARE REQUIREMENT ....................................................................................... 9 LTE ...................................................................................................................................................... 9 Networking ......................................................................................................................................... 9 Device Management .......................................................................................................................... 9 Security ............................................................................................................................................ 10 System/Debug Utility ...................................................................................................................... 10 Pole Mount ....................................................................................................................................... 11 APPENDIX A - SUPPLEMENTS .......................................................................................................... 11 Supplements .................................................................................................................................... 11 Installation Quick Guide ................................................................................................................. 11 Packaging ........................................................................................................................................ 11 w 3 w Chapter 1 Introduction Purpose and Scope The purpose of this document is to define product specification of 3GPP Rel10/11 Compliant LTE Cat 6 HE Outdoor CPE, support carrier aggregation, and Giga PoE Ethernet. It describes the HW and SW requirements of the following products:
Company Model Name Product Name Gemtek WLTS- 110_424348 WLTS-110 LTE Cat 6 B42_43_48 TD-LTE HE Outdoor CPE Product Features
- Support TDD-LTE Mode Band 48
- Support 3GPP Release 10 compliant (Support Cat 6; 40MHz Carrier Aggregation) / Future Rel 11
- Support up to UE LTE Category 6 PHY Rate
- Support 1.8V and 3V SIM and USIM card for LTE Mode
- Support 1TX/2RX with TX switched diversity
- Supports Dynamic Host Configuration Protocol
- Built-in web server for web-based configuration
- Password protected access and configuration
- Supports IEEE 802.3, IEEE 802.3u, IEEE 802.3ab (10/100/1000 Mbps )
- Support Power over Ethernet of Outdoor WAN port {802.3 at}
- Supports VPN pass-through
- Support IP67 Environmental Proof
*B48 certification is in roadmap
** TDD Cat 6 with 40MHz carrier aggregation peak throughput is around 220Mbps @ TDD Config 2 SSF 7 Definitions, Acronyms and Abbreviations LTE QoS MIMO OTA RSRP RSRQ RSSI CINR SINR Long Term Evolution Quality of Service Multi-input Multi-output Over the Air Reference Signal Received Power Reference Signal Received Quality Received Signal Strength Indicator Carrier to Interference plus Noise Ratio Signal to Interference plus Noise Ratio References Date Author Document 4 w Comments Sequans Communication Sequans Communication Sequans Communication Mediatek Pin header Removed in production unit In Indoor Chapter 2 Hardware Requirement General Specification Description No. Feature SQN3220 SQN3242 x 2 64MB 4Mb MT7621A 128MB 128MB LTE BB ASIC LTE RF ASIC RAM (Embedded) SPI Flash Host DDR2 NAND Flash Ethernet LAN port One RJ-45 port LED Indicators Console 10/100/1000 auto-sensing, auto-MDX Signal Strength / LAN / SIM TTL signal Reset/Reboot button Power supply Tact switch Input: Universal range 100~240VAC Output: 56VDC ID design Physical Size ODU Size ODU Weight Description 250 (L) 250 (W) 55(H)mm w/o mounting rib 1.2kg 5 Unit Interface_ODU w Connector LAN RJ 45 USIM Slot Lightening Grounding Screw Description The LAN port allows you to connect Modem to indoor power over Ethernet injector to support power / data Support standard 1.8V / 3V USIM LED name Location Color LED Behavior Status Indication LED Indicators _ODU LED List MAIN power Blue Ethernet status Yellow Steady ON Detect Ethernet Device Connected ON OFF Power On Power Off Blinking N/A OFF No Ethernet action Steady ON SIM Detected Blinking when On-
hook PUK / PIN Code OFF No SIM Detected When CPE is power on, each LED indicates each link status Red Steady ON SINR < 11dB Red/
Yellow Steady ON 11dB < SINR < 18dB Red/
Yellow/
Green Steady ON SINR > 18dB SIM status Green LTE Status LED : Link Status LTE 1 LTE 2 LTE 3 6 Architecture _ ODU w N/A Feature HW / Radio Specification_ODU No
. 1 LTE Supported Bands 2 LTE Channel Band Width 5 LTE Output Power @ 25 Capability Max Typ 48 10/20 Min 23 Unit MHz dBm Comments Band 48 3550MHz~3700MHz oC 6 LTE Transmit Power Dynamic Range 7 Receiver Sensitivity@
63 dB Based on 3GPP 36.524 worst case
-95
-93 dBm Based on 3GPP 36.524 worst case 9 LTE Antenna Support 3400 3800 MHz Comply with 3GPP Release 10 All RF specification should reference with 3GPP Release9 TS 36.101 2 antenna for LTE dBi 21+/-
1dBi 10 W Can be powered by 802.3af / 15W PoE 20MHz 8 Standard Frequency 10 Peak Gain 11 Peak Power Consumption (System) 7 w Comments Environmental Specification_ODU Feature No
. 1 Operating temperature 2 Storage temperature 3 Operating humidity 4 Storage humidity 5 Environmental min
-40
-40 5 5 Capability max 55 60 95 95 Typ IP67 units oC oC
Regulatory Specification_ODU CE No. Feature 1 Radio_LTE Comments 2 3 4 Safety EMC RF exposure Requirement Specification EN 301 908-1 V11.1.1 EN 301 908-13 V11.1.1 IEC 60950-1/EN 60950-1 Draft EN 301 489-52 V.1.1.0 EN 50385:2002 EN 62311:2008 User or Installer require minimum of 50 cm distance from the device Regulatory Specification_ODU FCC No. Feature 1 2 3 4 5 6 Requirement Specification FCC Part 90z FCC part 96 FCC Part 15B IEC 60950-1/EN 60950-1 EN 60950-22 FCC part 2 Radio_LTE Radio_LTE EMC Safety Outdoor RF exposure Comments 3650~3700 only Waiting FCC User or Installer require minimum of 50 cm distance from the device Reliability Specification No. Feature Requirement Specification 300,000 @ 55 oC MTBF ODU Comments 8 Chapter 3 Software Requirement 7 SIM function (1.8V and 3V SIM and USIM card) Multiple APN Manual Configure LTE No Feature 1 3GPP Release 10 & 11 2 MIMO Support 3 UE Cat 6 4 1TX/2RX 5 Full band search 6 APN Configuration 8 PIN/PUK Code Networking IPv4 IPv6 IPv4/v6 dual stack No Feature 1 2 3 4 NAT Mode 5 Bridge Mode 6 Tunnel Mode
- GRE
- L2TP / L2TP w/ IPsec
- PPTP 7 Router Mode 8 DHCP Server in LAN 9 NTP Client 10 DNS Relay 11 DDNS Client 12 VPN Pass-through IPSec/PPTP/L2TP 13 UPNP 14 HTTP(s) Server 15 Dynamic NAT/NAPT 16 ALG Support (FTP/SIP/etc) Device Management No Feature 1 Web Access (Remote/Local) 2 SNMP Agent 3 TR069 4 TR-143 w Comments Detail LTE-A features will be defined with customer
& eNB readiness DL MIMO 2x2 & 4x2 Status Ready with Chipset Ready with Chipset Ready with Chipset Ready with Chipset Ready with Chipset Ready with Chipset Ready with Chipset Ready with Chipset Comments Status Ready Ready Ready Ready Customization Customization Ready Ready Ready Ready Ready Ready Ready Ready Ready Ready For NAT Mode, Supports 253 clients max. For NAT Mode For NAT Mode For NAT Mode For NAT Mode Comments Status Ready Customization Ready for IOT Customization 9 5 OMA-DM 6 FOTA Firmware Upgrade N/A Ready Customization IOT with different network w Security No Feature 1 User Name/Password configuration 2 L2/L3 Firewall
- Basic firewall
- Port Forwarding
- Port trigger
- DMZ
- Remote WAN Ping
- Remote Web Access Control System/Debug Utility No Feature 1 Software reset button 2 Configuration Wizard 3 Time Zone Configuration 4 Networking Debug
- Iperf
- Ping
- Traceroute Status Ready Ready Comments Status Ready Ready Ready Comments Reset to factory default Customized, need customers to provide the configuration procedure 80+ Countries/Cities selection Ready Forward system information to specified network device.
- Supported with special IPK w/ chipset DM tool Switchable Use digital signature to verify the installed firmware 5 System log & Diagnostic & Monitoring Ready 6 Dual Image - Firmware Upgrade fail protection 7 Firmware Verification Ready Ready 8 Multilanguage Customization Default English 10 Pole Mount Appendix A - Supplements Supplements Article Number WLTMS-110 _424348 Package Contents
- 1x Assembled product ODU
- 1x 56 V PoE Injector (30W)
- 1x Quick installer guide
* To be discussion Installation Quick Guide Customization manual Packaging Gift Box, Customization manual, model name, serial number, product name Comments Detail Deliverables need to be defined by customer agreement w 11