FCC ID: 2AEIM-1849171 TPMS sensor

Tire pressure warning. The pressure of a tire is out of range. If a fault with the Tire Pressure Monitoring System (TPMS) is detected, the indicator flashes. View tire pressures in the

"Cards" area, located below the touchscreen's car status area, as described in Touchscreen Overview on page 4. For a TPMS fault, contact Tesla. See Tire Care and Maintenance on page 155. TPMS User Manual Reset TPMS Sensors: Reset the TPMS sensors after replacing a wheel (see Manually Resetting TPMS Sensors on page 158). The Tire Pressure indicator light does not immediately turn off when you adjust tire pressure. After inflating the tire to the recommended pressure, you must drive over 15 mph (25 km/h) for more than 10 minutes to activate the Tire Pressure Monitoring System (TPMS), which turns off the Tire Pressure indicator light. If the indicator light flashes for one minute whenever you power on vehicle, a fault with the TPMS is detected (see TPMS Malfunction on page 159). Note: Display tire pressures in the "Cards" area, located toward the bottom on the left side of the touchscreen, as described in Touchscreen Overview on page 4. You can If you replace a wheel, the TPMS (Tire Pressure Monitoring System) sensors need to be reset to ensure they provide accurate warnings when tires are under- or over-inflated (see Automatic Reset of TPMS Sensors on page 158). For the specification of the original wheels and tires installed on vehicle, see Wheels and Tires on page 178. Warning: For your safety, use only tires and wheels that match the original specification. Tires that do not match the original specification can affect the operation of the TPMS. Warning: Never exceed the speed rating of your vehicle's tires. The speed ratingis shown on the sidewall of your tires (see Understanding Tire Markings on page 180). Tire Pressure Monitoring Each tire should be checked monthly when cold and inflated to the recommended pressures that are printed on the Tire and Loading Information label located on the drivers door pillar (see Maintaining Tire Pressures on page 155). If your vehicle has tires of a different size than the size indicated on the vehicle placard or tire inflation pressure label, determine the proper tire inflation pressure for those tires. As an added safety feature, your vehicle has been equipped with a TPMS that displays a tire pressure telltale (Tire Pressure Warning) on the touchscreen when one or more of your tires is significantly under- or over-inflated. Accordingly, when the Tire Pressure indicator light displays on the touchscreen to alert you about tire pressure, stop and check your tires as soon as possible, and inflate them to the proper pressure (see Maintaining Tire Pressures on page 155). Driving on a significantly under-inflated tire causes the tire to overheat and can lead to tire failure. Under- inflation also reduces range efficiency and tire tread life, and may affect the vehicle's handling and stopping ability. If vehicle detects a fault with the minute whenever you power on vehicle. TPMS, this indicator flashes for one Note: Installing accessories that are not approved by Tesla can interfere with the TPMS. Warning: The TPMS is not a substitute for proper tire maintenance, including manually checking tire pressures and regularly inspecting the condition of tires. It is the driver's responsibility to maintain correct tire pressure, even if under- or over-inflation has not reached the level for the TPMS to trigger the Tire Pressure Warning on the touchscreen. Automatic Reset of TPMS Sensors After replacing one or more wheels (but not after replacing a tire or rotating wheels), the TPMS sensors are reset to ensure tire pressure warnings are accurate. TPMS sensors reset automatically after driving over 15 mph

(25 km/h) for longer than 10 minutes. Note: After replacing a wheel, false tire pressure warnings may display before you've driven 15 mph (25 km/h) for longer than 10 minutes. Manually Resetting TPMS Sensors To accommodate aftermarket tires and specific off-highway driving situations (such as track events), you can reset the TPMS sensors to trigger an alert based on the currently set tire pressure instead of the default factory tire pressure. To do so, touch Service > Reset TPMS Sensors and follow the onscreen instructions. Note: Resetting TPMS sensors may be especially helpful when using Track Mode, but remember to restore the factory TPMS setting when returning to normal driving. Warning: If your vehicle is equippedwith aftermarket tires that differ in size from those printed on the Tire and Loading Information Label (see Vehicle Loading on page 171), it is the driver's responsibility to determine the correct tire pressure. Do not drive on public roads when tires are not inflated to the correct pressure. Warning: Do not depend on TPMS sensors to accurately determine pressures and trigger alerts. It is the driver's responsibility to maintain correct tire pressures (see Maintaining Tire Pressures on page 155). Over or under-inflated tires can result in loss of control or tire damage, which can lead to serious injury. Replacing a Tire Sensor If the Tire Pressure warning indicator displays frequently, contact Tesla to determine if a tire sensor needs to be replaced. If a non-Tesla Service Center repairs or replaces a tire, the tire sensor may not work until Tesla performs the setup procedure. TPMS Malfunction Vehicle has also been equipped with a TPMS malfunction indicator to indicate when the system is not operating properly. The TPMS malfunction indicator is indicator light. When the system detects a malfunction, the indicator flashes for approximately oneminute after vehicle powers on, and then remains continuously lit. This sequence continues upon subsequent vehicle start-ups as long as the malfunction exists. When the TPMS malfunction indicator is on, the system might not be able to detect or signal under- and over-inflated tires as intended. combined with the tire pressure TPMS malfunctions can occur for a variety of reasons, including installing replacement or alternate tires or wheels that prevent the TPMS from functioning properly. Alwayscheck the TPMS malfunction indicator light after replacing one or more tires or wheels on your vehicle to ensure that the replacement tires or wheels allow the TPMS to continue to function properly. Note: If a tire has been replaced or repaired using a different tire sealant than the one available from Tesla, and a low tire pressure is detected, it is possible that the tire sensor has been damaged. Contact Tesla to have the fault repaired as soon as possible. FCC and IC Certification Component Manufacturer Model Operating Frequency

(MHz) Pillar Endpoint Center Console Fascia Endpoint Tesla 1509518 13.56 Tesla 1089774 Tesla 1509516 2400-2483.5 13.56 2400-2483.5 2400-2483.5 Key fob Tesla 1133148 2400-2483.5 TPMS Tesla 1472547G 2400-2483.5 FCC ID IC ID 2AEIM-150951 8 20098-150951 8 2AEIM-10897 74 20098-10897 74 2AEIM-150951 6 20098-150951 6 2AEIM-113314 8 20098-113314 8 2AEIM-147254 7G 20098-14725 47G Radar Continental ARS 4-B 76000-77000 OAYARS4B 4135A-ARS4B Homelink Gentex ADHL5C 286-440MHz NZLADHL5C 4112A-

ADHL5C CarPC Tesla 1506277

YZP-RBHP-

B216C RI7LE940B6N A RBHP-B216C 5131A-

LE940B6NA The devices listed above comply with Part 15 of the FCC rules and Industry Canada's license- exempt RSS Standard(s) and EU Directive 2014/53/EU. Operation is subject to the following two conditions:

1. 2. This device may not cause harmful interference; and This device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by Tesla could void your authority to operate the equipment. Radio Frequency Information This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician to help. Note: FCC Radiation exposure: All equipment complies with FCC and IC RSS-102 radiation exposure limits for an uncontrolled environment and the radio device and antennas operating at more than 20cm distance from user. Caution: This equipment and its antennas must not be co-located or operated with another antenna or transmitter. Canada CAN ICES-3 (B)/NMB-3(B) Le prsent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radioexempts de licence. L'exploitation est autorise aux deux conditions suivantes : (1) l'appareilne doit pas produire de brouillage, et

(2) l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en compromettre lefonctionnement. Cet quipement est conforme aux limites dexposition aux rayonnements IC tablies pour unenvironnement non contrl. Cet quipement est conforme aux limites d'exposition RF d'Innovation, Science et Dveloppement conomique Canada tablies pour un environnement non contrl. Cet quipement doit tre install et utilis de manire assurer un espacement d'au moins 20 cm avec toute personne en tout temps. Mexico La Operacin de Este Equipo no est Sujeta a las dos condiciones siguientes:

1. 2. Es Posible Que Este Equipo o Dispositivo no causar interferenciaperjudicial. Este Equipo o Dispositivo debe Aceptar Cualquier interferencia. Incluyendo La Que Pueda causar do Operacin no Desead NCC

oe ew es Tw DGaLARVIELW!

| | Label Location Tesia, Inc. Jf AAndo!+10A0171 J FCCID: ZAEINI- 1047 1/1 1 10-90002.129240171

\ 1G p_p_Te3-19240171

\af( VVVVVVVY' = a vyvYyYVvYy FNISSAININ

Federal Communications Commission Office of Engineering & Technology Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Via Electronic Filing Date: April 28, 2021 Re: Authorized Personnel for Grantee Code 2AEIM To Whom It May Concern:

I currently serve as Tesla, Incs (Tesla) grantee contact (Grantee Code 2AEIM) for Federal Communications Commission (FCC) equipment authorizations. As prescribed in KDB 852134 Authorized Policy Form 731, I authorize the following personnel to act on Teslas behalf with regard to all matters that relate to FCC equipment authorization (i.e., signing Form 731, attestation letters, and confidentiality request letters). These individuals also are authorized to assign additional persons to act on Teslas behalf as authorized agents. This authorization is valid until further written notice from any of Teslas authorized grantee contacts. Authorized Personnel:

Peng Zhang Cindy Li Sincerely Yours, Sean Lui Sr. Staff Charging Compliance Engineer 3500 Deer Creek Road, Palo Alto, California US 94304 Phone: (650)681-5109 slui@teslamotors.com Tesla, Inc. 3500 Deer Creek Road, Palo Alto, CA 94304 p +650 681 5100 f +650 681 5101

Letter of Authorization Date: January 3, 2023 Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Rd Columbia MD 21046-1609 Subject: Product Certification Representative Authorization Letter FCC ID: 2AEIM-1849171 Product Name: TPMS sensor To whom it may concern:

We the undersigned, hereby authorize following person to act as our agent in the preparation of an application for equipment authorization to the FCC Rules and Regulations. Sporton International Inc. Address :

No.52, Huaya 1st Rd., Guishan Dist., Taoyuan City 333, Taiwan (R.O.C.) Name

: Leo Huang Job Title : Director e-mail

: Leohuang@sporton.com.tw We further certify that neither the applicant nor any party to this application, as defined in 47 CFR Ch. 1.2002(b), is subject to a denial to Federal benefits, that include FCC benefits, pursuant to section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C. 862. This appointment also includes the authority to complete FCC Form 731 on our behalf and sign the application as an authorized agent. Applicant Address

: Tesla, Inc

: 3500 Deer Creek Road, Palo Alto, California 94304, United States Signature

Name and Job Title.

: Cindy Li, Sr Certification Engineer _________________________________ E-mail Tel.

: lqing@tesla.com

: 408-718-7809

Date: January 3, 2023 Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Rd Columbia MD 21046-1609 Subject: declaration of composite/rated equipment for FCC ID: 2AEIM-1849171 To Whom it may concern, We, the undersigned, would like to declare that the composite portion catagorized as Other Class B digital devices & peripherals has been authorized under the Supplier's Declaration of Conformity (SDoC) procedures. Sincerely, Applicant Address

: Tesla, Inc

: 3500 Deer Creek Road, Palo Alto, California 94304, United States Signature

Name and Job Title.

: Cindy Li, Sr Certification Engineer _________________________________ E-mail Tel.

: lqing@tesla.com

: 408-718-7809

Confidentiality Request Letter Date: January 3, 2023 Federal Communications Commission Authorization and Evaluation Division Subject: Request for confidentiality FCC ID: 2AEIM-1849171 To whom it may concern:

Short-term Confidentiality pursuant to Public Notice DA 04-1705, and in order to comply with the marketing regulations in 47 C.F.R. 2.803 and the importation rules in 47 C.F.R. 2.1204 while ensuring that business-sensitive information remains confidential until the actual marketing of newly authorized devices, we are request the Commission grant temporary confidential treatment and not release the following attachments for routine public disclosure until 180 days after the grant date. 1. Internal Photographs 2. External Photographs 3. Users manual 4. Test Set up photos Permanent Confidentiality Pursuant to the provisions of Sections 0.457 and 0.459 of Commissions rules (47CFR0.457, 0.459), we are requesting the Commission to withhold the following attachment(s) as confidential document from public disclosure indefinitely. 1. Block Diagram 2. Schematics 3. Operational Description It is our understanding that test measurement reports and correspondence during the certification review process cannot be granted confidential treatment, and such information will be available for public review once the grant of equipment authorization is issued. Sincerely, Applicant Address

: Tesla, Inc

: 3500 Deer Creek Road, Palo Alto, California 94304, United States Signature

Name and Job Title.

: Cindy Li, Sr Certification Engineer _________________________________ E-mail Tel.

: lqing@tesla.com

: 408-718-7809