Wireless Phone Charger
This wireless phone charger (Model name: WC4) is designed for Tesla Model, which can charge up to 2
Qi-enabled smartphone at up to 15W simultaneously.
Just simply placing the smartphone onto the compartments of the Wireless Phone Charger, it will
automatically start charging when the vehicle is powered on. The smartphone will not continue to
charge if it is left plugged in after the driver exits the vehicle. Tesla Model will not charge the
smartphone if the vehicle’s battery is discharged.
NOTE: The Wireless Phone Charger many not work if the phone case is too large or made of metal. Take
the phone out of the case and place the phone on the charger in the above-mentioned cases.
FCC and IC Certification
Component
Manufacturer Model
FCC ID
IC ID
Wireless Phone Charger
Tesla
WC4
2AEIM-WC4
20098-WC4
Caution: This equipment and its antennas must not be co-located or operated with another
antenna or transmitter.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate this equipment.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
Canada
CAN ICES-3 (B)/NMB-3(B)
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science
and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following
two conditions:
This device may not cause interference.
This device must accept any interference, including interference that may cause undesired
operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR
d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
L’appareil ne doit pas produire de brouillage;
L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
Radiation Exposure Statement:
This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
Cet équipement est conforme aux limites d’exposition aux rayonnements IC établies pour un
environnement non contrôlé. Cet équipement doit être installé et utilisé avec un minimum de
20cm de distance entre la source de rayonnement et votre corps
Mexico
La Operación de Este Equipo no está Sujeta a las dos condiciones siguientes:
Es Posible Que Este Equipo o Dispositivo no causar interferenciaperjudicial.
Este Equipo o Dispositivo debe Aceptar Cualquier interferencia. Incluyendo La Que Pueda causar do
Operación no Deseada.