Unaracters will oe cnangeq SUOJECT to the mem Name on tre winGQow Cox RADIO CONTROLLER 1) Open battery compartment on the underside of the radio controller and insert one 9 Volt battery and close cover. 2) Open battery compartment:on the underside of skateboard and insert 4 AAA batteries and close cover. 3) Turn power switch ON the side of radio controller. Red LED light when lit indicates power is ON. 4) Turn power switch ON on the underside of skateboard. 5) Attach magnetic figure to.the center of board. Position figure further forward or backward to perform additional tricks. 6 & 7) Turn wheel to the left or right to turn skateboard left or right. 8 & 9) Move trigger on the underside of radio controller down or up to control forward or backward motion. Tail Spinning Funtion 10) Move trigger down and then up quickly to perform "WHEELIES" tricks. 11) Turn wheel left or right and hold position while moving the trigger down or up to perform tail spinning function. Position bottom of foot as section shown on board for eptimum function &
performance. WARNING:
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note:
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmiul interference to
. radio communications. However, there is no guarantee that interference will not occur in particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the . ~ -
equipment off and on, the user is encouraged to try to correct the - Do not use rechargeable batteries. interference by one or more of the following measures: - Non-rechargeable batteries are not to be recharged.
- Different types of batteries or new and used baiteries are not to be mixed.
* Reorient or relocate the receiving antenna - Only batteries of the same or equivalent type as recommended are to be use Increase the separation between the equipment and receiver - Batteries are to be inserted with the correct polarity. Connect the equipment into an outlet on a circuit different - Exhausted batteries are to be removed from the tov. from that to which the receiver is needed : an ;
. ; ae _ - The supply terminals are not to be short-circuited. Consult the dealer or an experienced radio/TV, technician for help - Do not dispose of batteries in fire. batteries may explode or leak. This device complies with Part 15 of the FCC Rules. - 4 AAA Batteries required for SKATEBOARD {not included). Operation is subject to the fallowing two conditions: - 1 pe 9 Volt Battery required for RADIO CONTROLLER 1) this device may not cause harmful interference, and (not {not included). 2) this device must accept any interference received, ==
including interference that may cause undesired operation. be Z\ CAUTION:
Thread of Screw Contains Functional Sharp Edges. Keep the display box and the manual for future reference, Please retain these details for future reference. Please remove packaging attachments before giving the toy to the child. MADE IN CHINA
*HLK, Office Address: 3/F Li Fung Tower, 888 Cheung Sha Wan Rd., Kowloon, Hong Kong.
+ U.S. Office Address: Toy Island, 7600 Jericho Turnpike, Suite 302, Woodbury, NY 11797. Tel: 1-800-572-1288 CHOKING HAZARD - Small parts Not for children under 3 years.