FCC ID: 2BBPLPY2PKR KARAOKE-DUET SET-WIRELESS MIC

125g, Please enter FCC ID # and BT ID #, by replacing XXXX 63.5mm Thank you for purchasing the XOPOPPY Karaoke - Duet Set

- Wireless LED Mic. Please read all instructions carefully before using and retain this manual for future use and reference. DIAGRAM 7 8 9 10 m m 3 4 1 1

. PACKAGE CONTENTS 2 Karaoke Wireless LED Mic Micro USB Charging Cable Operation Manual KEY FEATURES Compatible with Bluetooth-enabled devices Built-in rechargeable battery Volume and echo control SAFETY INSTRUCTIONS Keep the unit away from heat sources, direct sunlight, humidity, water and any other liquids. Do not operate the unit of it has been exposed to water, moisture or any other liquids to prevent against electric shock, explosion and/or injury to yourself and damage to the unit. Do not use the unit if it has been dropped or damaged in any way. Repairs to electrical equipment should only be performed by the manufacturer. Improper repairs may place the user at serious risk. Do not puncture or harm the exterior surface of the product in any way. Keep the unit free from dust, lint, etc. Do not use this unit for anything other than its intended use or purpose. Doing so may damage the device. This product is not a toy. Keep out of reach of children. Do not expose batteries, battery pack, or batteries to installed to excessive heat, such as direct sunlight, or open flame. 317.5mm CHARGING THE KARAOKE WIRELESS MIC The Karaoke Wireless LED Mic comes with a built-in rechargeable battery. Before using it for the first time, we recommend you charge the battery fully. Only use the supplied charge cable to charge the speaker. your device. 5. Once you have activated Bluetooth on your device, select the Karaoke Wireless LED MicPY-2PKR from the list of available Bluetooth devices. 6. If required, enter the PIN code "0000" and confirm the entry. Connect the USB end to a computer USB port or a USB wall charger and the micro USB to the charge port on the karaoke mic. The red LED indicator will illuminate while the Karaoke Wireless LED Mic is charging. A full charge of the battery takes around 4 hours. When the battery is fully charged, the LED indicator will turn off. Disconnect the Karaoke Wireless LED Mic at this point. The Karaoke Wireless LED Mic will then be ready for use. When battery lowThe LED indicator will emit two tones everyone everyone minutes When this occursplease recharge the karaoke mic. When using your Karaoke Wireless LED Mic with an iPhone, the top right corner will indicate your karaoke mics battery life. Note: If pairing is unsuccessful, turn off the Karaoke Wireless LED Mic first and re-pair following the steps above. Once you have paired the Karaoke Wireless LED Mic with a device, the Karaoke Wireless LED Mic will remember this device and will pair automatically when the devices Bluetooth is activated and in range. You do not need to re-pair any previously connected devices. OPERATING THE KARAOKE WIRELESS MIC Playing music wirelessly Once the Karaoke Wireless LED Mic is paired to your device, you can stream music wirelessly to the built-in speaker. Select the track you wish to listen to on your device to play through thespeaker.Should you encounter any problems while streaming, please refer to your devices user manual. PROMPT NOTIFICATION Chime Sound - Indicates device is powered on. Low Chime Sound - Indicates device is turning off. Beep Sound - Indicates devices has been successfully paired. Adjust Voice Echo Push the echo switch up or down to adjust voice echo. Adjust Microphone Voice Volume Push the volume switch up or down to adjust voice volume. 1 2 3 4 5 6 11 SPECIFICATIONS Bluetooth Version:

Operating Distance:

Pick Up:

Speaker Output:

Frequency Range:

Sensitivity:

Play Time:

Battery Type:

Battery Capacity:

Charging Voltage:

Charging Time:

Charging Interface:

FCC ID:

V5.3 Up to 16.4ft (5m) Capacitive 5W 150Hz - 18kHz 80db - 115db Up to 2.5 hours Lithium-ion 1200 mAh DC 5V Up to 3 Hours Micro USB 2BBPLPY2PKR CARE AND MAINTENANCE Do not expose the unit to excessive heat or humidity to avoid damage to the product's internal circuitry. Do not use abrasive cleaning solvents to clean the unit. Do not expose the unit to extremely high or low temperatures as this will shorten the life of the electronic device, destroy the battery, and/or distort certain plastic parts. Do not dispose of the unit in fire as they may explode or combust. Do not expose the unit to contact with sharp objects as this will cause scratches and damage. Do not let the unit fall from high places, as doing so may damage the internal circuitry. Do not attempt to disassemble the unit. 12 13 14 1. Microphone 2. Play/Pause 3. Volume Up 4. Funny Voice 5. Volume Down 6. Built-in Speaker, LED Lights 7. Previous Track 8. Next Track 9. Echo Switch 10. Microphone Volume Switch 11. Micro USB Charge Port 12. On / Off / Mode Button 13. Micro TF Card Port 14. USB Media Port PAIRING THE KARAOKE WIRELESS MIC 1. Ensure both Karaoke Wireless LED Mic are turned off before pairing. 2. Turn on both device and click the mode button of the machine both. When you hear the beep sound the True Wireless has been successfully paired. 3. Place the Karaoke Wireless LED Mic and he Bluetooth device to which you would like to pair it within the operating distance. We recommend keeping the two devices no further than 3 feet apart. 4. Ensure Bluetooth is enabled on your device. Refer to the manufacturers instructions for how to enable Bluetooth on Funny Voice Press & Hold: Switch to any 4 funny voice sounds. Press Once: Switch to accompaniment mode.

(Not applicable on TWS mode) FM Radio Press power button once to enter radio mode.Press and hold Play" to enter auto station search.PressPrev" to go to previous station,press Next"to the next station. 1 2 3 4 5 FCC STATEMENT This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC INSTRUCTIONS FOR A CLASS B DIGITAL DEVICE OR PERIPHERAL Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. WARRANTY INFORMATION The condition of this warranty and our responsibilities under this warranty are as follows:

Suppliers warranty is non-transferable. And this warranty is limited to the original purchaser only.

* You must be able to prove the date of original purchase of the unit with a dated receipt.

* The warranty is not applicable if the product has been subject to physical abuse, improper installation, modification or repair by unauthorized third party.

* The responsibility of suppliers products shall be limited to the 6 customer will be invoiced f or a ll re pair and tra nsport co sts. XOPOPPY will not accept any packages that have not first been approved by XOPOPPY by means of an RMA

(Return Material Authorization). Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. RF warning statement:

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. repair of replacement of the product as its sole discretion.

* Specifically exempt from any warranty are limited-life consumable components subject to normal wear and tear such as batteries, decorates and other accessories.

* A supplier will not take any responsibility if the failure of the unit has resulted from accident, abuse, misuse, or any unauthorized repair, modification or disassemble.

* Modification and repair of the unit should be done by authorized and qualified service personnel, Center or returned to the manufacturer.

* This warranty gives you specific legal rights, and you may also have other rights which vary under local laws. The following conditions comprise the requirements and scope of our warranty conditions and do not affect our legal and contractual warranty obligations. We offer a warranty on our products in accordance with the following conditions:

1) XOPOPPY products are covered by a 3 month warranty. We will resolve damages or defects on XOPOPPY products free of charge within 3 months of the purchase date under the following warranty conditions. For any damage or defect determined later than 3 months after the purchase date, proof of a manufacturing fault must be submitted for repair under warranty. 2) The warranty does not cover batteries and other parts, which are considered consumables, parts that break easily such as glass or plastic or defects based on normal wear and tear. There is no warranty obligation in the event of marginal differences compared to the target appearance and workmanship provided these have a negligible effect on the products fitness for use, in the event of damage caused by chemical or electrochemical effects, by water or generally from abnormal conditions. 3) The warranty will be performed in such a way that we shall decide whether to repair the defective parts or to replace them with working parts free of charge. XOPOPPY reserves the right to exchange the product for a replacement product of equal value if the product sent in cannot be repaired within a reasonable time or at a reasonable cost. Requests cannot be made for repairs to be carried out on site. Parts that have been replaced or exchanged become our property. 4) The warranty claim does not apply if repairs or other work is carried out by unauthorized persons or if our products are equipped with additional parts or accessories that are not approved for our product. 5) Warranties that have been activated do not cause the warranty period to be extended, nor do they trigger a new warranty period. The warranty period for any replacement parts installed ends with the warranty period for the entire product. 6) Any other further claims are excluded, especially those for replacement due to damage caused to the outside of the product, provided there is no obligatory legal liability. We therefore accept no liability for accidental, indirect or other consequential damage of any kind, which leads to usage restrictions, data loss, and loss of earnings or interruption to business. Asserting a warranty claim:

1) To make use of the warranty service for hardware issues, you must contact the XOPOPPY Service Center by email at support@sarinagroup.com 2) XOPOPPY will try to diagnose and solve your problem. If it is determined that a warranty claim exists, you will be given an RMA number (Return Material Authorization) and will be asked to send the product to XOPOPPY . IMPORTANT: XOPOPPY will only accept parcels that have an RMA number. Please observe the following when sending the product:

1) Send the product suitably packaged with carriage and insurance paid. Do not enclose any accessories with the product

(cables, chargers, manuals, etc.) unless the XOPOPPY Service Center specifies otherwise. 2) Mark the RMA number on the outside of the package in such a way that it is visible and clearly legible. 3) You must enclose a copy of the sales slip as proof of purchase. 4) Once XOPOPPY has received the product, it will meet its warranty obligations in accordance with the warranty conditions and will return the product to the sender with carriage and insurance paid. Service outside of warranty XOPOPPY can refuse any service claim made that is not covered by the warranty. If XOPOPPY agrees to provide a service outside the warranty, the 7 8 9 Karaoke - Duet Set Wireless LED Mic Operation Manual PY-2PKR FCC ID: 2BBPLPY2PKR MADE IN CHINA

- TRUSTSTONE GROUP, LLC -

Federal Communications Commission Authorization and Evaluation Division Equipment Authorization Branch 7435 Oakland Mills Road Columbia, MD 21046 U.S. Agent Designation 8/21/23

[TRUSTSTONE GROUP, LLC] acknowledges their consent for the following contact located in the United States to act as their agent for service of process for the equipment for which authorization is sought (FCC ID:

[2BBPLPY2PKR]):

Name and company of U.S. agent: TRUSTSTONE GROUP, LLC Physical U.S. address of agent: 1370 Broadway, 9th floor, New York, NY 10018, United States FRN of U.S. agent: 0033900465 Email address of U.S. agent: Compliance@sarina-group.com

[TRUSTSTONE GROUP, LLC] acknowledges their obligation to accept service of process on behalf of

[TRUSTSTONE GROUP, LLC].

[TRUSTSTONE GROUP, LLC] with the FRN [0033900465] accepts its obligation to maintain an agent for service of process in the United States for no less than one year after either the grantee has permanently terminated all marketing and importation of the applicable equipment within the U.S., or the conclusion of any Commission-

related administrative or judicial proceeding involving the equipment, whichever is later. By signing this form, we confirm the above and that we are aware of the application requirements listed under 2.911(d)(7). The information provided in this letter is based on the referenced rule parts of Title 47 of the CFR as well as KDB 986446 D01. An expiration date for this letter does not exist. In case the U.S. agent changes, the grantee is obligated to notify the FCC within 30 days via the granting TCB. Sincerely, Signature

[Marc Faham]

[CEO]

5 0 V

[TRUSTSTONE GROUP, LLC]

, U

) 7

) d

1 1 9

. 2 _ t n e g A _ S U

l e d o m

_ 8 4 Signature

[Marc Faham]

[CEO]

[TRUSTSTONE GROUP, LLC]

- TRUSTSTONE GROUP, LLC -

Federal Communications Commission Authorization and Evaluation Division Equipment Authorization Branch 7435 Oakland Mills Road Columbia, MD 21046 8/21/23 To whom it may concern:

We, [TRUSTSTONE GROUP, LLC], hereby certify that the equipment for which authorization is sought

(FCC ID:

[2BBPLPY2PKR]) is not covered equipment prohibited from receiving an equipment authorization pursuant to 2.903 of the FCC rules. We also certify that, as of the date of the filing of the application, we are not identified on the Covered List (https://www.fcc.gov/supplychain/coveredlist) as an entity producing covered equipment. By signing this form, we confirm the above and that we are aware of the application requirements listed under 2.911(b) and (d)(5) and (6). Sincerely, 2 0 V

, U

) i i

d n a

) i

) 5

) d

1 1 9 2 _ u q E d e r e v o C

l e d o m

_ 2 6 Signature

[Marc Faham]

[CEO]

[TRUSTSTONE GROUP, LLC]

The information provided in this letter is based on the referenced rule parts of Title 47 of the CFR as well as KDB 986446 D01.