FCC ID: SWX-U6EP Digital Transmission Radio

Il ost i nt by 11 Q Dmm _

(@1/4")

@18mm

(@11/16") 9

(O11/

1

G18mm \\

16) \

Ay A) Internet Y Gateway PoE+

E-Label User Information FCC ID: SWX-U6EP IC ID: 6545A-U6EP Ubiquiti Inc. will be incorporating the E-Label procedures per FCC KDB 784748-D02. The information below is what will be included in the E-Labeling. E-label and warning statements can be found in the device/controller GUI under Device >

Settings > About. Detailed compliance information including Declaration of Conformity is available at the following internet address: ui.com/compliance FCC Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions. 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generated, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operations of this equipment in a residential area is likely to cause harmful interference in which case the user bill be required to correct the interference at his own expense. FCC regulations restrict the operation of this device to indoor use only. The operation of this device is prohibited on oil platforms, cars, trains, boats, and aircraft, except that operation of this device is permitted in large aircraft while flying above 10,000 feet. Operation of transmitters in the 5.925-7.125 GHz band is prohibited for control of or communications with unmanned aircraft systems. ISED Canada CAN ICES-3 (A) / NMB-3 (A) This device complies with ISED Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:

1. This device may not cause interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. CAN ICES-3 (A) / NMB-3 (A) Le prsent appareil est conforme aux CNR dISDE Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes:

1. Lappareil ne doit pas produire de brouillage;

2. Iappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement. RF Exposure Warning The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be located or operating in conjunction with any other antenna or transmitter. Les antennes utilises pour ce transmetteur doivent tre install en considrant une distance de sparation de toute personnes dau moins 20 cm et ne doivent pas tre localis ou utilize en conflit avec tout autre antenne ou transmetteur.

Date: 09/29/2021 TIMCO Engineering, Inc. 849 N.W. State Road 45 P.O. Box 370 Newberry, Florida 32669 RE: Request for Confidentiality In reference to the application under FCC ID: SWX-U6EP, and pursuant to Sections 0.457(d)1(ii) and 0.459 of the Commissions Rules, Ubiquiti Networks hereby requests permanent confidential treatment of the accompanying information as outlined below:

Software Security Theory of Operation The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these matters might be harmful to Ubiquiti Networks and provide unjustified benefits to its competitors. It is our understanding that all measurement test reports, FCC ID label format and correspondence during certification review process cannot be granted as confidential documents and that information will be available for public review once the grant of equipment authorization is issued. Ubiquiti Networks understands that pursuant to Rule 0.457(d)(1)(ii), disclosure of this application and all accompanying documentation will not be made before the date of the Grant for this application. Sincerely, Mark Feil Ubiquiti lnc. Compliance Manager 685 3RD AVE. NEW Y0RK, NY 10071 www.ui.com

Date: 29 September 2021 Federal Communications Commission 7435 Oakland Mills Rd. Columbia, MD 21046 RE: Request for Class II Permissive Change FCC: SWX-U6EP It is hereby requested that Ubiquiti Inc. obtain FCC Class II Permissive Change certification of a radio apparatus on the Ubiquiti Inc. product U6-Enterprise. The associated FCC: number is listed above. The Class II Permissive Change certification is to add U-NII-2a and U-NII-2c frequencies bands. The U6-Enterprise is a four-stream WiFi 6 access point that provides up to 2.4 Gbps aggregate radio rate with 5 GHz (MU-MIMO and OFDMA) and 2.4 GHz (MIMO) radios. The U6-Enterprise has a Bluetooth management radio, an Ethernet port for data transfer, and is powered from a PoE Adapter. Sincerely, Mark Feil Ubiquiti lnc. Compliance Manager 685 3RD AVE. NEW Y0RK, NY 10071 www.ui.com

FCC: SWX-U6EP Expedite Review Required Information Parameters FCC ID Technology: (i.e.; 802.11x, frame based, MIMO, smart antenna, etc.) Bandwidth information and differences FCC ID(s) of Previously Granted DFS Devices SWX-U6PROR 802.11 a/n/ac/ax 4x4 MIMO FCC ID of New Application SWX-U6EP 802.11 a/n/ac/X 4x4 MIMO 20/40/80/160 supported 20/40/80/160 supported Antenna information and Brand Name: UBNT Brand Name: UBNT differences for the minimum gain Type: Internal Antenna Type: Internal Antenna antennas Gain: 6 dBi Gain: 5.3 dBi Differences in DFS functioning, Chip: IPQ5018 + QCN9024 Chip: IPQ5018 + QCN9024 Chipset, circuitry, software, etc. The DFS function, chip, circuitry, The DFS function, chip, circuitry, and software are the same. and software are the same. Differences between the Output power products such as TX power, U-NII-2A: 0.2455 W modulation, receivers, processing U-NII-2C: 0.2455 W Output power U-NII-2A: 0.2438 W U-NII-2C: 0.2495 W circuitry, etc. Names of the test labs for the various Grants Technology - Is the same. Bandwidth - No differences. Unified Compliance Laboratory Unified Compliance Laboratory Antenna - The original grant SWX-U6PROR has an available 6 dBi internal antenna and the new grant SWX-U6EP has an integrated 5.3 dBi internal antenna DFS - No differences.

Power of Attorney Date: 2021/01/20 Dear Sir or Madam, I hereby have entrusted the following entity to be an authorized agent regarding application for Type Certification. Ubiquiti Inc. also authorizes the following entity to be a proxy to handle all certification matters. Unified Compliance Laboratories Address : 427 W 12800 South Draper Utah 84020 e-mail : ucl@ui.com Applicant : Ubiquiti Inc. Address : 685 Third Avenue ,New York NY 10017 United States Of America Name and Job Title. : Mark Feil / Compliance Director E-mail : compliance@ui.com Tel. : 385-200-1617

15.247, 15.407, UNII-1, UNII-3, UNII-5, UNII-6, UNII-7, UNII-8 15.407(f) Test Requirement(s):

RF Exposure Requirements:

RF Radiation Exposure Limit:

Maximum Permissible Exposure 15.407(f): U-NII devices are subject to the radio frequency radiation exposure requirements specified in 1.1307(b), 2.1091 and 2.1093 of this chapter, as appropriate. All equipment shall be considered to operate in a general population/uncontrolled environment. 1.1307(b)(1) and 1.1307(b)(2): Systems operating under the provisions of this section shall be operated in a manner that ensures that the public is not exposed to radio frequency energy levels in excess of the Commissions guidelines. 1.1310: As specified in this section, the Maximum Permissible Exposure

(MPE) Limit shall be used to evaluate the environmental impact of human exposure to radiofrequency (RF) radiation as specified in Sec. 1.1307(b), except in the case of portable devices which shall be evaluated according to the provisions of Sec. 2.1093 of this chapter. MPE Limit:

EUTs operating frequencies 15.247 Bluetooth @ 2402 2480 MHz; 15.247 Wi-Fi @

2412 2462 MHz; 15.407 UNII-1 @ 5180 5240 MHz; 15.407 UNII-3 @ 5745 5825 MHz; 15.407 UNII-5 @ 6115 6395 MHz; 15.407 UNII-6 @ 6435 6505 MHz;

15.407 UNII-7 @ 6535 6875 MHz; and 15.407 UNII-8 @ 6895 7115 MHz Limit for Uncontrolled exposure: 1 mW/cm2 or 10 W/m2 Equation from page 18 of OET 65, Edition 97-01 S = PG / 4R2 or R = (PG / 4S) where, S = Power Density (mW/cm2) P = Power Input to antenna (mW) G = Antenna Gain (numeric value) R = Distance (cm) Test Results:

Frequency

(MHz) Con. Pwr.

(dBm) Con. Pwr.

(mW) Ant. Gain

(dBi) Ant. Gain numeric Limit

(mW/cm2) Margin Result Distance

(cm) 2402 2437 5240 5745 6325 6505 6665 6985 11.36 23.74 28.85 27.57 22.78 23.31 23.62 23.28 13.68 *

236.59 *

767.36 *

571.48 189.67 214.29 230.14 *

212.81 3.2 3.2 5.3 5.3 6.0 6.0 6.0 6.0 FCC Pwr. Density

(mW/cm2) 0.01 0.10 0.52 0.39 0.15 0.17 0.18 0.17 2.09 2.09 3.39 3.39 3.98 3.98 3.98 3.98 1.0 1.0 1.0 1.0 1.0 1.0 1.0 1.0

-0.99

-0.90

-0.48

-0.61

-0.85

-0.83

-0.82

-0.83 20 20 20 20 20 20 20 20 Pass Pass Pass Pass Pass Pass Pass Pass

* The U6-Enterprise may have simultaneously transmission of the 15.247 Bluetooth, 15.247 2.4 GHz WiFi, 15.407 UNII-1 or UNII-3 and 15.407 UNII-5 or UNII-6 or UNII-7 or UNII-8. Asterisk notes the worst case of the possible simultaneously transmitter combinations. Simultaneously Transmitters Summed:

0.01 (Bluetooth)

+ 0.10 (2.4 GHz WiFi)

+ 0.52 (UNII-1)

+ 0.18 (UNII-7)

= 0.80 Limit of 1.0 0.80 (summed value) = -0.20 Margin The safe distance for SWX-U6EP where Power Density is less than the MPE Limit listed above was found to be 20 cm.

Date:06/14/2021

Federal Communications Commission

7435 Oakland Mills Road

Columbia MD 21046

FCC ID: SWX-U6EP

We, Ubiquiti Inc., attest that this device under FCC ID SWX-U6EP complies with device

protocol requirements and operational restrictions: for indoor access point 6ID.

Indoor Access Point 6ID:

1. Protocol attestation statement:

a. An 11ax IEEE device’s Transmit Power Envelope element has information

fields for the power limits for connection client/subordinate devices. The

TPE information is contained in the device signals and used by connecting

client/subordinate to ensure that it knows the regulatory TX powers it is

allowed to transmit at. There is a regulatory info fields in this device beacon

and probe response frames which details this device type when the

client/subordinate associates to this device.

2. Statement acknowledging device restrictions:

a. Low-power indoor Access Point. Access Point operating in the 5.925-7.125

GHz band shall be supplied power from a wired connection, has an

integrated antenna, is not battery powered, and does not have a weatherized

enclosure.

b. This device's operation will not be allowed on oil platforms, cars, trains,

boats, and aircraft, except that operation of this device is permitted in large

aircraft while flying above 10,000 feet.

c. Indoor access points are prohibited for control of or communications with

unmanned aircraft systems, including drones.

Ubiquiti Inc.

Compliance Manager

685 3RD AVE. • NEW Y0RK, NY 10071 • www.ui.com

Date:06/14/2021 Federal Communications Commission 7435 Oakland Mills Road Columbia MD 21046 FCC ID: SWX-U6EP We, Ubiquiti Inc., attest that this device under FCC ID SWX-U6EP complies with device protocol requirements and operational restrictions: for indoor access point 6ID. Indoor Access Point 6ID:

1. Protocol attestation statement:

a. An 11ax IEEE devices Transmit Power Envelope element has information fields for the power limits for connection client/subordinate devices. The TPE information is contained in the device signals and used by connecting client/subordinate to ensure that it knows the regulatory TX powers it is allowed to transmit at. There is a regulatory info fields in this device beacon and probe response frames which details this device type when the client/subordinate associates to this device. 2. Statement acknowledging device restrictions:

a. Low-power indoor Access Point. Access Point operating in the 5.925-7.125 GHz band shall be supplied power from a wired connection, has an integrated antenna, is not battery powered, and does not have a weatherized enclosure. b. This device's operation will not be allowed on oil platforms, cars, trains, boats, and aircraft, except that operation of this device is permitted in large aircraft while flying above 10,000 feet. c. Indoor access points are prohibited for control of or communications with unmanned aircraft systems, including drones. Ubiquiti Inc. Compliance Manager 685 3RD AVE. NEW Y0RK, NY 10071 www.ui.com