SPECIFICATIONS/Model:U6-Lite 160x32.65mm without mounting)300g
(with mounting)315g PC 110 + Die casting- ADC 12 PC + SGCC 880 MHz MIPS 1004KEc DDR3 SDRAM 2Gbit Ethernet 1x RJ45 GbE reset White/Brue 802.3af 802.3af 44 to 57VDC 23 dBm 23 dBm 2x2
x
-10C~60C 5 to 95% Noncondensing 802.11a/b/g/Wi-Fi 4/Wi-Fi 5/Wi-Fi 6 WEP, WPA-PSK, WPA-Enterprise (WPA/WPA2/WPA3) MECHANICAL Dimensions Weight Enclosure Characteristics Mounting Characteristics HARDWARE Processor Specs Memory Information Management Interface Networking Interface Buttons LEDs Power Method Power Supply Supported Voltage Range Max. TX Power 2.4 GHz 5 GHz 2.4 GHz 5 GHz MIMO Operating Temperature Operating Humidity SOFTWARE Wi-Fi Standards Wireless Security FCC Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions. 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. The following apply to Class A products This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operations of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. The following apply to Class B products
"This equipment has been tested and found to comply with the limits for a Class B digital device. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a partic-
ular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equip-
ment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help."
ISED Canada CAN ICES-3(A/B)/NMB-3(A/B) This device complies with ISED Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
1. This device may not cause interference, and 2. This device must accept any interference, including interference that may cause undesired operation of the device. The device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems. CAN ICES-3(A/B)/NMB-3(A/B) 1. 2. Le prsent appareil est conforme aux CNR dISDE Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes :
lappareil ne doit pas produire de brouillage;
lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement. Les dispositifs fonctionnant dans la bande 5150-5250 MHz sont rservs uniquement pour une utilisation lintrieur afin de rduire les risques de brouillage prjudiciable aux systmes de satellites mobiles utilisant les mmes canaux. RF Exposure Warning The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be located or operating in conjunction with any other antenna or transmitter. Les antennes utilises pour ce transmetteur doivent tre install en considrant une distance de sparation de toute personnes dau moins 20 cm et ne doivent pas tre localis ou utilis en conflit avec tout autre antenne ou transmetteur.