FCC ID: SEAUWBBLE Location Tracking Tag

Wideband Location System UB-Tag Dimension4 UWB+BLE Tag

(D4UWBBLE) Users Manual Written By Andy Ward Ubisense Limited St Andrews House St Andrews Road Chesterton Cambridge CB4 1DL ENGLAND Tel:

Fax:

+44 (0)1223 535 170

+44 (0)1223 535 167 Email:

WWW:

support@ubisense.net http://www.ubisense.net/

Released: September 2021 Copyright 2021 Ubisense Limited, All Rights Reserved Table of Contents Introduction ...................................................................................................................................... 1 Regulatory Information for the United States of America ................................................................ 1 Regulatory Information for Europe .................................................................................................. 2 Regulatory Information for Canada ................................................................................................. 2 Device Specifications ...................................................................................................................... 3 User Information .............................................................................................................................. 4 Copyright 2021 Ubisense Limited, All Rights Reserved 1 Introduction The UB-Tag Dimension4 UWB+BLE tag (model number D4UWBBLE) is a location tracking tag for the real-time location of objects. It transmits wideband pulses which are picked up by a network of basestations (Ubisensors), allowing the 3D position of the tag to be found. The use of wideband technology enables greater positioning accuracy within buildings than other wireless technologies, because it is much less susceptible to multipath interference effects. Applications of the system include healthcare, workplace productivity, security, retail management and manufacturing. This document describes the features and specifications of the UB-Tag Dimension4 UWB+BLE tag and important regulatory information concerning its use. Regulatory Information for the United States of America The UB-Tag Dimension4 UWB+BLE tag is approved under Parts 15.247 and 15.250 of the FCC rules. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications to the equipment not expressly approved by the party responsible for the grant of equipment authorization issued by the FCC could void the users authority to operate the equipment under the grant of equipment authorization, for example:

CAUTION: Any changes or modifications made to the UB-Tag Dimension4 UWB+BLE tag which are not expressly approved by Ubisense Limited could void the user's authority to operate the equipment. IMPORTANT NOTE: FCC Radiation Exposure Statement: This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. The device has been evaluated as safe to use at any separation from the person. Ubisense Wideband Location System UB-Tag Dimension4 UWB+BLE tag Regulatory Information for Europe Hereby, Ubisense Limited declares that the radio equipment type UB-Tag Dimension4 UWB+BLE tag (D4UWBBLE) is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.ubisense.net or from:

2 Ubisense St. Andrew's House St. Andrews Road Chesterton Cambridge CB4 1DL United Kingdom This UWB transmitter must not be installed at a fixed outdoor location or used in flying models, aircraft and other forms of aviation. The device uses the following frequency bands, at the output powers shown:

Radio interface 2.4GHz Wideband Lower frequency

(MHz) 2401.00 6099.742 Upper frequency

(MHz) 2481.75 7025.941 Output power (dBm) 2.1

-44.0 (/MHz) Regulatory Information for Canada The Modular Tag V3.1 is approved under Industry Canada documents RSS-GEN, RSS-102, RSS-247 and RSS-220. Le Modular Tag V3.1 est certifi et approuv conforme selon les documents de lIndustrie du Canada RSS-GEN, RSS-102, RSS-247 et RSS-220. This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le prsent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en compromettre le fonctionnement. This device complies with the safety requirements for RF exposure in accordance with RSS-102 Issue 5 for portable use conditions in uncontrolled environments. Cet appareil est conforme aux exigences de scurit relatives lexposition aux radiofrquences, conformment la norme RSS-102, dition 5, pour systmes portables conditions dutilisation dans des environnements non contrls. Ubisense Wideband Location System UB-Tag Dimension4 UWB+BLE tag 3 Device Specifications Wideband transmitter section Operates under:

FCC Part 15.250 Industry Canada RSS-220 ETSI EN 302065-2 Centre frequency:

-10dB bandwidth:

6.500GHz 0.926GHz 2.4GHz proprietary BLE (Bluetooth Low Energy)-based radio transceiver Operates under:

FCC Part 15.247 Industry Canada RSS-247 ETSI EN 300328 Lowest channel frequency:

Highest channel frequency:

2401.00MHz 2481.75MHz General specifications Dimensions (WxHxD):

Weight:

Power supply:

Operating temperature range:

46mm x 41mm x 18mm 24g Non-replaceable CR2477 lithium coin cell

-20C to +70C Ubisense Wideband Location System UB-Tag Dimension4 UWB+BLE tag User Information The UB-Tag Dimension4 UWB+BLE tag device is shown below:

4 LED indicator Mounting holes Strapping slot Location of magnetic sensor

(hold magnet on side of tag here to wake up device) Switching on the tag The device is shipped in a quiescent (non-transmitting) deep sleep state. To turn on the tag, bring a magnet next to the side of the tag near the LED light pipe, as shown in the diagram above. The LED on the tag will illuminate. Hold the magnet there until the LED turns off of its own accord the tag LED will then brighten from dim to bright, and will then go out. At this point, the tag is running and transmitting location packets. Typically the tag will flash periodically to show that it is awake (although the precise LED behaviour and tag update rate will depend on the settings pre-programmed into the tag for your site). Troubleshooting In case of problems with your Ubisense location system and tags, please contact support@ubisense.net. Disposal of device The UB-Tag Dimension4 UWB+BLE tag has an exceptionally-long battery lifetime. Note that the battery is not user-replaceable. At the end of the devices lifetime, please either return to Ubisense for recycling or dispose of in an environmentally-conscious manner. Ubisense Wideband Location System UB-Tag Dimension4 UWB+BLE tag

PMN (in manual): UB-Tag HVIN: D4UWBBLE ISED company #: 8673A UPN: UWBBLE 20mm Model:

Modelo:

D4UWBBLE m m 0 2 FCC ID: SEAUWBBLE IC: 8673A-UWBBLE View from rear of device Please Note Due to size limitations the following declarations will be made in the manual, rather than on the device:

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: [1]

this device may not cause harmful interference, and [2]

this device must accept any interference received, including interference that may cause undesired operation. Actual Size

UBISENSE AMERICA LLC 999 18th Street Suite 901 Denver CO 80202 United States 5th September 2021 Telecommunication Certification Body UL International (UK) Ltd. Unit 1-3, Horizon Kingsland Business Park Wade Road Basingstoke Hampshire RG24 8AH United Kingdom Subject: Authorisation Letter To whom it may concern This is to certify that Ubisense America LLC hereby authorises UL International (UK) Ltd. to act as the TCB for the application of the Dimension4 UWB+BLE tag (model number D4UWBBLE), FCC ID: SEAUWBBLE to the FCC. We certify that we are not subject to a denial of Federal benefits, that include FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C. 862 because of a conviction for possession or distribution of a controlled substance. See 47 CFR 1.2002(b) for the definition of a "party" for these purposes. Yours faithfully, Dr Andy Ward FREng Chief Technology Officer Ubisense Limited and Ubisense America LLC

UBISENSE AMERICA LLC 999 18th Street Suite 901 Denver CO 80202 United States 6th September 2021 Telecommunication Certification Body UL International (UK) Ltd. Unit 1-3, Horizon Kingsland Business Park Wade Road Basingstoke Hampshire RG24 8AH United Kingdom RE: Dimension4 UWB+BLE Tag (D4UWBBLE) FCC ID SEAUWBBLE To Whom It May Concern:

The attached application is for a transmitter that is both a 6 to 7 GHz wideband device (WBT) operating under Part 15.250 and a Part 15.247 (DTS) device operating in the region 2401 to 2481.75MHz. The device has only integral antennas. Previously, similar devices from this applicant were certified as Part 15.250/15.249 composite devices (e.g. FCC ID: SEAMOD30), and we are again following the FCCs guidance relating to previous certifications, which directed us to submit test reports for both the wideband and conventional transmitters under a single FCC ID. Should you have any questions or require any further information with regards to this, please feel free to contact me. Yours faithfully, Dr Andy Ward FREng Chief Technology Officer Ubisense Limited and Ubisense America LLC

UBISENSE AMERICA LLC 999 18th Street Suite 901 Denver CO 80202 United States 6th September 2021 Telecommunication Certification Body UL International (UK) Ltd. Unit 1-3, Horizon Kingsland Business Park Wade Road Basingstoke Hampshire RG24 8AH United Kingdom Subject: Permanent Confidentiality Request Certification Application FCC ID: SEAUWBBLE To whom it may concern Pursuant to Sections 0.457(d) and 0.459 of CFR 47, Ubisense America LLC request that the following information, provided to support the FCC application for the Dimension4 UWB+BLE Tag (model number D4UWBBLE), FCC ID: SEAUWBBLE be held permanently confidential:

Schematics (D4UWBBLE Schematic.pdf) Block Diagram (D4UWBBLE Block Diagram.pdf) Operational Description (D4UWBBLE Operational Description.pdf) The above material contains trade secrets not customarily released to public that are judged to have the potential to cause detriment to the applicant and provide unjustified benefits to its competitors. This information should not be available for public disclosure for an indefinite period of time. Yours faithfully, Dr Andy Ward FREng Chief Technology Officer Ubisense Limited and Ubisense America LLC