Wireless Water Detector Product Information and Manuals Model NumberWWD3LWU 1Product Overview WWD3 is a low-power wireless sensor terminal that integrates leak detection, motion monitoring and long-distance LoRa communication functions. The device is battery-powered and supports -20~70 industrial environment operation. Key features include: Microampere standby current Touch interaction and sound and light alarm Support SWD wireless firmware upgrade 2Technical specifications category Power Power consumption Wireless Communications Sensor Type interface Mechanical Dimensions parameter 2AA battery (2.8-3.6V) Working Mode18mA 3VSleep Mode1.5A
(STM32WLE5CC)stand by 868/915MHz Leak Detection23-axis accelerometer(LIS3DH) SWD debug interfaceUART Data Interface 8.2X4.5X2.5cm 3Mechanical Dimensions 1Power system Power supply mode:
Main power supply: 2 AA batteries connected in series (BAT1) 2 Soc SocSTM32WLE5CC (ARM Cortex-M4) Resource Allocation:
Pinout Function Signal PA0/PA1 LED Control PB7 PC13 ADC1/2/3 Battery/leak detection BAT_LEVEL/LEAK_SG Buzzer control Touch key input LED1/LED2 BUZZER KEY_OUT 3 Sensor system Leak detection:
Detection principle: Electrical impedance change monitoring Interface: Spring contact (LEAK_SG_1/2) Response time: < 500ms Motion detection:
Chip: LIS3DH (2g~16g adjustable) Wake-up threshold: Software configurable 4. RF system RF front end: PE4259 antenna switch 5. User Interaction LED Indication:
state LED1(green) LED2(red) Normal operation 0.5Hz flicker Leakage Alert Low battery Off 1Hz synchronous flashing 1Hz synchronous flashing Off 2Hz flashing reasonable frequency harmful FCC Warnning:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide protection againstharmful interference in a residential installation. This equipment generates, with energy uses and can radiateradio and, maycause interference the there thatinterference occur is equipment cause determined by turning the equipmentoff interference Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is harmfulinterference to radio or television reception, which can be user in communications. installation. instructions, guarantee does accordance However, this If thefollowing measures:
radio a encouraged if to in particular installed correct more used one and and will not not the on, the try no by or to to of is connected. Consult the dealer or an experienced radio/TV technician for help. Any Caution:
could void your authority to operate this equipment. modications changes this or to device not explicitly approved by manufacturer 15 part with complies device This conditions:
(1)This interference received, including interference that may cause undesired operation. interference, Operation harmful subject device device Rules. cause may and FCC this not the
(2) to of is the following two must accept any complies equipment FCC This environment. should between the radiator and your body. equipment with This radiation be installed exposure and limits operated set with forth for an minimum uncontrolled 0cm distance English:
Development Canadas licence-exempt RSS(s). This device contains licence-exempt transmitter(s)/receiver(s) that ISED Statement comply with Innovation, Science and Economic Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device. conformes aux CNR exempts de licence dInnovation, Sciences et Canada. Le fonctionnement est soumis aux deux conditions suivantes :
(1) Cet appareil ne doit pas causer dinterfrences.
(2) Cet appareil doit accepter toute interfrence, y compris les interfrences susceptibles de provoquer un fonctionnement indsirable de lappareil. French:Cet appareil contient des metteurs/rcepteurs exempts de licence qui sont Dveloppement conomique equipment This environment. complies with Canada radiation exposure limits set forth for an uncontrolled be and with should installed operated This equipment radiator & your body. Cet quipement est conforme Canada limites d'exposition aux radiations dans un environnement non contrl. Cet quipement doit tre install et utilis avec une distance minimale de 0 cm entre le radiateur et votre corps. minimum between distance 0cm the
