UBUDU SAS 22 rue Tourlaque 75018 Paris, France Limited Module Approval Request Letter 2020-01-23 To:
Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD Subjects: Limited Module Approval Request Letter The Device,FCC ID: 2AVNZ-07, is seeking FCC authorization as a modular transmitter. The EUT meets the requirement for modular approval as detailed in FCC Public Notice DA 00-
1407. Compliance to each of the requirement is described below:
(a) The radio elements must have the radio frequency circuitry be shielded. Physical/discrete and tuning capacitors may be located external to the shield, but must be on the module assembly. The modular without a shield.
(b) The module shall have buffered modulation/data input(s) (if such inputs are provided) to ensure that the module will comply with the requirements set out in the applicable FCC standard under conditions of excessive data rates or over-modulation. Yes.
(c) The module shall have its own power supply regulation on the module. This is to ensure that the module will comply with the requirements set out in the applicable standard regardless of the design of the power supplying circuitry in the host device which houses the module. The modular has an onboard 3.3V regulator(integrated in nRF52811).
(d) The module shall comply with the provisions for external power amplifiers and antennas detailed in this standard. The equipment certification submission shall contain a detailed description of the configuration of all antennas that will be used with the module. The modular has a External antenna which comply with the antenna requirement of Section 15.203.
(e) The module shall be tested for compliance with the applicable standard in a stand-alone configuration, i.e. the module must not be inside another device during testing. The modular was tested in a standalone configuration apart from host units.
(f) The module shall comply with the Category I equipment labeling requirements and CFR 15.212(a)(1)(vi). UBUDU SAS 22 rue Tourlaque 75018 Paris, France The modular has its own FCC ID number.
(g) The module shall comply with any applicable FCC RF exposure requirement which are based on the intended use/configurations. Yes RF cexposure evaluation performed at 20cm.
(h) The modular transmitter complies with all applicable FCC rules. Instructions for maintaining compliance are given in the user instructions. Yes If you have any questions, please feel free to contact us at the address shown below Sincerely, Name/Title Monika Slugocka / Manager Company:
Address:
Phone:
Fax:
E-Mail:
KINGRAY ELECTRONICS Co., LTD 22 rue Tourlaque 75018 Paris
+852 2786 1678 68533881843 monika.Slugocka@ubudu.com