900MHz Wireless Speaker System Enceintes sans fil de 900 MHz Sistema Inalambrico de Bocinas de 900MHz Fag Pe Are 325ft/100m"
Transmits stereo signal even outside your home!
Emet un signal stro meme aextrieur de la maison!
{Transmite somal estereofnica Incluso afuera de su casal by ein China Chine en China ae Keep your sales receipt to obtain warranty parts and service and for proof of purchase, Attach ithere and record the serial and model numbers. These numbers are located on the product Model No. Serial No. Purchase Date:
Dealer /Address/Phone:
RRs Led Introduction Features 5
(Care and Maintenance 3 Parts 3 Operation Notes. Troubleshooting, Specifications Warranty erate This WSPISS Wireless Speaker system uses the latest 900 MHz RF technology that enables you to enjoy stereo sound anywhere around your homeeven outside on yout deck or patio! Just follow the simple instructions to connect the transmitter to any audio source (CD, DBS, VCR Stereo, Radio or TV) for ful stereo Sound without the need to run wires to your speakers. You may place the speakers anywhere within range (approx. 325 feet) ofthe transmitter to receive the stereo signal
= 900 MH RF technology
+ RF technology allows high degree of freedom for speaker placement
+ Operating distance up to 325 feet
+ No line-of sight limitation ALC and auto ON/OFF control
+ Convenient power, volume and tuning controls located on the speakers TOK With proper care, your speaker system will provide you with years of enjoyment. Here area few guidelines to follow in caring for your system:
+ Always use a soft cloth to clean the speakers and transmitter. If required, you may use a mild detergent and warm water to clean any dirt or dust from the component surfaces. Never use any product Containing alcohol or other solvents as they may damage the surface
+ Use caution when plugging the power transformers in an AC outlet to avoid the risk of electric shock
+ Never expose the speakers or transmitter to rain or moisture as this may cause damage Ifthe speakers are used outside on a deck or patio, make sure you take them indoors inthe event of a rainstorm to prevent possible damage.
+ Dornot operate or store the system in extreme temperatures below 32F (0C) and above 122F (50C), Range may vory by environment sO Ga us See Transmitter Front Transmitter Backe See chr te ptr end wcenrecis2 st | oe el @i=>
Audio inp pag, 3.5 mm/6.35 mm jock adaptor INSTALLATION bsertontstn 5 OG) Speaker Front TRANSMITTER t 1. Plugthe supplied AC power adapter into an electrical outlet near Auto ean to yout audio source. Make sure itis the one for the transmitter Speaker Back (DC 12.5V")the two for the speakers are marked accordingly. say 2. Connect the plug endo he power adapter to the DC ck cated todtleaatle on the back of the transmitter (see diagram). The red LED indicator light on the top panel will glow which indicates the unit is receiving power, Locate the aulio input cord on the back of the transmitter. The 3.5 mm standard plug can be used fo fit most headphone output jacks in audio equipment. If you are connecting to the audio output, jacks from a TV, amplifier, et, then plug the audio input cord into the Y adapter that is provided to adapt standard RCA type audio plugs for the auelio source. 4, Turn on the audio source, The CHANNEL SELECTION CONTROL is located on the back ofthe transmitter. Select the desired channel by sing the switch on the back ofthe transmitter. This channel can later Be Npoeeniby wal be switched to achieve optimal audio reception. This speaker system has automatic ON/OFF control that automatically turns the transmitter on if there isan audio signal detected and the red LED light on the top of the transmitter will glow. Once the audio source is switched off, the ON/OFF control will tun off power and Stop transmitting to the speakers and the red LED will be off (after a 45-90 second timeout period). Boer comport INSTALLATION (continued) This system also features ALC (Automatic Level Controls), ALC
[prevents audible distortion of the input signal and maintains an optimal level ofthe input signal. The ALC prevents overloads that can occur from suddenly raising inpat signal cs -
Back STANDARD RCA CONNECTOR TRANSMITTER
(AUDIO CORD) Pros 1. You may use either the AC adapter or 4-"D" size alkaline batteries
(Gold separately) to power the speaker, Make sure the Volume
(On/Off Control knob is turned to the off position. 2. Ifyou are using the AC adapter, locate the ones marked For Speaker fn the label and plig them into an electrical outlet located near the Tocation for each speaker. Then, inset the plug endl into the DC INPUT jack located on the back ofthe speaker If you are using. batteries, remove the BATTERY DOOR and insert 4-"D size alkaline batteries in each speaker making sure to insert the batteries in the correct polarity as indicated, Once the batteries are inserted correctly replace the battery coor by first inserting the 2 tabs into the back cabinet slots then closing it until it snaps in place atthe bottom tab. Check to make sute itis closed securely before moving the speakers, You can expect the batteries to last approximately 15 hours total when the speakers are played at a mid-volume level, 3. Position the speakers about 20 feet away from the transmitter to perform this tuning setup. Turn on the speakers using the VOLUME control and set them to the desired listening level. Ifyou hear static or noise and the signal is not clear change the
(CHANNEL SELECTION CONTROL on the back of the transmitter and then try to tune the speakers using the AUTO SCAN button on each one. The green LED next to the AUTO SCAN button will illuminate green when a clear signal is being detected. Ifyou still, ddo not receive a clear signal, make certain that other RF devices that use RF frequencies such as cordless phones, cell phones and baby monitors are disabled as they can cause interference, 44, The BASS BOOST switch on the front of the speaker can be used to enhance the sound depending on your own music preferences To improve the bass response ofthe speaker, simply press the button The green LED will illuminate when the BASS BOOST is active 5, Once you have properly followed the setup procedure, you may
;position the speakers in any location within approximately 325 fect of the transmitter to enjoy quality stereo sound OPERATION NOTES Ifyou notice a disruption of the sound or the signal breaks up, press the AUTON SCAN button on the speakers to maximize stereo reception,
|f you hear interference from other sources, select a different channel on the back of the transmitter then re-tune the speakers the same way as described in the setup procedure. You may have to try several settings to find the one that works best in your home. When transmitting or receiving over long distances, the signal from the system will become weak and the stereo indicator light wil go dim. If this occurs, move the speakers to a new location closer to the transmitter to receive a stronger signal. For protection ofthe transmitter and to save power, the transmitter will cut off automatically in approximately one minute if there is no audio Signal, or if the signal is weak. The red LED indicator light will then tum off. Once the audio signal is restored, the transmitter will tum on and the red LED will glow. Eee Cetouin cd PROBLEM ___ SOLUTION
'A) Check that power adapters and /or batteries are connected properly and that power is on. BB). Make sure the control knob on the speaker is ON.
) fusing batteries, they may be too weak to power the speakers. Replace the batteries 1D) Ensure the TV or audio component is on and that the unit receiving an adequate dio signal E) The volume control knob on the speaker is set too low. Adjust the volume if required. No sound Distorted sound A) Ensure the stereo indicator light on each speaker ison. Iinot, adjust the tuning controls for each until the ight is on
'B) Change the position of the CHANNEL SELECTION CONTROL on the transmitter. Then press the AUTO SCAN bution on each speaker ntl the indicator light is on.
) Speaker batteries may be too weak. Replace with fresh batteries. D) The speakers are too far from the transmitter to receive strong signal. Move them closer to the transmitter.
) The input level ofthe audio signal is too low. Tur up the volume on the audio source to increase the signal level so thatthe green LED indicator light on the transmitter glows. are UNE UHF stereo 900 ME Transmitter, 12SV 150mA
(8x "D size Alkaline batteries) 4 per speaker 9V 100mA adapter (optional) Frequency Response 40kHz.125 kHz (+/-3dB) Distortion <M S/N ratio 25048 Separation 220dB Operation distance _325ft*/ 100m"
Range may vay by environment Transmission Mode Cartier Frequency Operation Voltage Speaker, 9Vs NOTE: Changes or modifications to this unit not expressly approved by. the party responsible for compliance could void the user's authority to operate the equipment. Operation is subject to the following two conditions:
1) This device may not cause interference, and 2) this device must accept any interference, including interference that may cause undesired operation of the device, LIMITED ONE YEAR WARRANTY
(ur company (in the US,THOMSON INC. / In Canada, Thomson multimedia Ltc.) warrants that for one year from date of purchase, it will replace this product if found to be defective in materials or workmanship. For a prompt, no charge replacement of equivalent product, return the defective product postage prepaid to the appropriate adress. In the US:
Product Exchange Center 11721 Alameda Avenue Socorro TX 79927 In Canada:
Thomson multimedia Ltd 6200 Edwards Boulevard Mississauga, Ontario Canada LST 2V7 This replacement isthe companys sole obligation under this warranty. THOMSON INC. / Thomson multimedia Ltd, will not be responsible for any incidental or consequential damages or for any loss arising, in connection withthe use or inability to use this product. Some states/provinces do not allow the exclusion or limitation of incidental fF consequential damages, so the above limitation or exclusion may not apply to you. This warranty excludes defects or damage due to misuse, abuse, oF neglect. This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state/province to province