The User Manual Of Flip Key 13522778 Company: VAST(China) Co., Ltd Address: 89 East Guangzhou Road, Economic Development Zone,Taicang, China 1. Product information Product Name: Flip key Product Model Number: 13522778 Size (mm): 72.63918.8 (close position); 113.13918.8 (open position) 2. Technical Parametric:
3. Product functional introduction Unlock Lock Unlock: To press unlock button to unlock the doors of the vehicle Lock: To press lock button to lock the doors of the vehicle The key allows you to lock or unlock the doors from a certain distance by pressing the appropriate button on the key. The key does not need to be pointed at the vehicle to activate the system. 4. Battery replacement The recommended replacement battery is CR2032 Battery replacement steps Step1:Remove battery cover with tools as show image1~3 Step2:Remove dead battery with tools as show image4~5 Step3:Insert new battery as show image6 Step4:Assemble battery cover back then complete battery replacement as show image7 Image 1 Image 2 Image 3 Disassembly area with tools Disassembly area with tools Image 4 Image 5 Image 6 Image 7 5. Programming additional keys Programming additional keys may be performed by your authorized dealer. 6. Request for additional keys NOTE: Only keys that are programmed to the vehicle electronics can be used to start and operate the vehicle. Once a key is programmed to a vehicle, it cannot be programmed to any other vehicle. WARNING: Always remove the keys from the vehicle and lock all doors when leaving the vehicle unattended; always remember to place the ignition in the OFF mode. General information The following regulatory statement applies to all radio frequency devices equipped in this vehicle. this device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions 1. this device may not cause harmful interference. 2. this device must accept any interference ,including interference that may cause undesired operation. Note: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. 7. Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. Howev-er, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.