BM-101 User Manual Before Use Charge the battery as follows:
1. Connect the USB Cable to your computers USB port. Connect the 2mm jack on the other end into the Headset. 2. The red LED will light up during charging. 3. When charging is complete, the red LED will turn off. If you are experiencing any static or problems with operation, the battery is probably low and needs to be re-charged. Power On and Power Off the Bluetooth Headset 1. Press the button for 1 second. An alert tone will beep once and the blue LED will blink in sequence (1 second on, 1 second off). button for 3 seconds. An alert tone will beep and the red LED will flash twice and 2. Press the then go off. Pairing the Bluetooth Headset with a Mobile Phone Make sure your mobile phone is Bluetooth-enabled. Specific pairing steps may vary with different cell phones. Refer to the User Guide for your mobile phone for further information. The general pairing steps are as follows:
1. Keep the Bluetooth Headset close to your mobile phone. 2. Press and hold the button over 6 seconds. The alert tone will beep twice and the red and blue LED lights will quickly blink in an alternating pattern. The Bluetooth Headset is in pairing mode at the moment. 3. Search for the Bluetooth Device under the pairing mode in the mobile phone. 4. Once the search is completed, BM101 will appear in the Bluetooth device list. 5. Select BM101 to connect and enter the matching code 0000. 6. Pairing will then complete and the blue LED of the Bluetooth Headset will blink in sequence. Note:
If pairing is unsuccessful, switch off the Bluetooth Headset and repeat the pairing procedure. If pairing is successful, the paired devices will remember each other. Unless the pairing information is deleted, because of a new pairing, there is no need to go through the pairing procedure again when using the same devices next time. When power on and not done any pairing, the Bluetooth Headset wait for 10 minutes will power off automatically to save the power. button to play or pause music. Playing Music Under the paired and connected status, the function will be as follows:
1. Press the 2. Press the + button once to increase the volume level one step. 3. Press the - button once to reduce the volume level one step. 4. Press and hold the + button to skip to the next track. 5. Press and hold the - button to skip to the previous track. button once to receive the call. button once again to end the call. Receive Calls and End Calls Under the paired and connected status, when there is an incoming call from your mobile phone, you will hear an alert tone from the Headset and you can receive a call as follows:
1. Press the 2. Press the Notice:
The blue LED will blink twice every second when not pairing or connected. The blue LED and red LED will blink quickly, in an alternating pattern, during pairing status. The blue LED will blink once every 3 seconds when connected to the Mobile phone. The red LED will turn on during charging and turn off after charging is complete. When the battery is low, the RED LED will blink once every 30 seconds and you will hear three beeps to remind you to recharge the battery. FCC STATEMENT Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user authority to operate the equipment. FCC ID: T5HBM101KIJAKA This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation. This equipment complies with FCC RF radiation exposure limit set forth for an uncontrolled environment. This transmitter must not be co-located or operated in conjunction with any other antenna or transmitters.