FCC ID: 2AQK5-WAVOPRO1 Bluetooth Microphone

HVIN: WAVO PRO, WAVO PRO1 FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/ TV technician for help. That changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated without restriction. ISED Statement English: This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canadas licence-exempt RSS(s). Operation is subject to the following two conditions:

(1) This device may not cause interference.

(2) This device must accept any interference, including interference that may cause undesired operation of the device. The digital apparatus complies with Canadian CAN ICES-3 (B)/NMB-3(B). French: Cet appareil contient des metteurs/rcepteurs exempts de licence qui sont conformes aux RSS exempts de licence d'Innovation, Sciences et Dveloppement conomique Canada. L'exploitation est soumise aux deux conditions suivantes :

(1) Cet appareil ne doit pas provoquer d'interfrences.

(2) Cet appareil doit accepter toute interfrence, y compris les interfrences susceptibles de provoquer un fonctionnement indsirable de l'appareil. l'appareil numrique du ciem conforme canadien peut - 3 (b) / nmb - 3 (b). This device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS 102 RF exposure, users can obtain Canadian Information on RF exposure and compliance. cet appareil est conforme l'exemption des limites d'valuation courante dans la section 2.5 du cnr - 102 et conformit avec rss 102 de l'exposition aux rf, les utilisateurs peuvent obtenir des donnes canadiennes sur l'exposition aux champs rf et la conformit. The device is compliance with RF exposure guidelines, users can obtain Canadian information on RF exposure and compliance. Le prsent appareil est conforme Aprs examen de ce matriel aux conformit ou aux limites d'intensit de champ RF, les utilisateurs peuvent sur l'exposition aux radiofrquences et la conformit and compliance d'acqurir les informations correspondantes.

jem 2 34 ]

MERE

67.8 9 10 Hai 8 4

; ! ! i {

SS Py Vii} 4 \

(FCC ID: 2AQK5-WAVOPRO1 c 2H MAVOrRO eats XXX-XXXXXX XXXXXXXXXXXXXX A CMIIT ID: xxxxxxxxx -R-R-021-WAVOPRO S/N:00001 JB01715-BWW MADE IN CHINA WAVO PRO

| Videndum Media Solutions Spa jem 2 34 ]

MERE

67.8 9 10 Hai 8 4

; ! ! i {

SS Py Vii} 4 \

(FCC ID: 2AQK5-WAVOPRO1 c 2H MAVOrRO eats XXX-XXXXXX XXXXXXXXXXXXXX A CMIIT ID: xxxxxxxxx -R-R-021-WAVOPRO S/N:00001 JB01715-BWW MADE IN CHINA WAVO PRO1

| Videndum Media Solutions Spa

C5266091_X24_Ed.1 Attestation Statements TO:

Office of Engineering Technology Federal Communications Commission 7435 Oakland Mills Road Columbia, MD 21046 The Commission adopted rules that prohibit equipment authorization for covered telecommunications equipment and video surveillance equipment produced by entities identified on the Commissions Covered List!, which is periodically updated. See the Covered List for more details. This Attestation Statement is to confirm that we follow the Section 2.911(d)(5)(i)-(ii) Applicant Company name: Videndum Media Solutions Spa Grantee code: 2AQK5 FCC ID: 2AQK5-WAVOPRO1 Contact Name: Diego Selmin Address: Via Valsugana 100, I-36022 Cassola (VI); Italy Telephone No: +390424555815 Fax No: +39 0424 808 999 Email: diego.selmin@videndum.com i. Videndum Media Solutions Spa (the applicant) certifies that the equipment for which authorization is sought is not covered equipment prohibited from receiving an equipment authorization pursuant to section 2.903 of the FCC rules. The applicant must sign this certification. ii. Videndum Media Solutions Spa (the applicant) certifies that, as of the date of the filing of the application, the applicant is not identified on the Covered List as an entity producing covered equipment. The applicant must sign this certification. Date: 2023/02/15 Applicants Name: Selmin Diego Title: Quality Systems and Assurance Manager Signature \_ C.F. 09719310154 - P.l. 02084740246 1 The Commissions Covered List is published by the Public Safety and Homeland Security Bureau and posted on the Commissions website. This Covered List, which is periodically updated, identifies particular equipment, produced by particular entities, that constitutes covered equipment. https://www.fcc.gov/supplychain/coveredlist 1/1

C5266091_X10_Ed.2 Videndum Media Solutions Spa Office of Engineering Technology Federal Communications Commission 7435 Oakland Mills Road Columbia, MD 21046 Date: 2022-12-19 Subject: Request for Confidentiality FCC ID: 2AQK5-WAVOPRO1 To Whom It May Concern, Pursuant to the provisions of Sections 0.457 and 0.459 of Commission's rules

(47CFRO.457, 0.459), we are requesting the Commission to withhold the following attachment(s) as confidential document from public disclosure. Confidentiali Confidentiality NOTE 2 Test Report

[| No

[| Nod

| No Test Setup Photos

| No

| No Internal Photos NOTE 1 Parts List / Tune Up RF Exposure Info Operational Description SDR Software / Security Info NOTE 1: Long-Term Confidentiality may be permitted under special conditions (See II. LONG-TERM CONFIDENTIALITY, Section 3 of KDB 726920, use last in force) NOTE 2: Short-Term Confidentiality can be requested for a maximum of 180 days from the date of the grant. Above mentioned document contains detailed system and equipment description are considered as proprietary information in operation of the equipment. The public disclosure of above documents might be harmful to our company and would give competitor an unfair advantage in the market. In case of short-term Confidentiality, the applicant requests the exhibits selected above are withheld from public view for a period of days from the date of the Grant of Equipment Authorization and prior to marketing. It is our understanding that all measurement test reports, FCC ID label format and correspondent during certification review process cannot be granted as confidential documents and those information will be available for public review once the grant of equipment authorization is issued. Sincerely, Signature: WDtego a Name: Diego Selmin Title: Quality System & Assurance Manager 1/1

Videndum Media Solutions Spa Declaration on model difference We the undersigned hereby confirm that any of our production units bearing the following model numbers are identical in circuitry and electrical, mechanical and physical construction; the only differences are the Battery Management Chip(U17) is different. The details are:

Product Name: Bluetooth Microphone Model No.: WAVO PRO use Chip DW07D Model No.: WAVO PRO1, use Chip AP9211SA-AN-HAC-7 Therefore, differential testing was performed for this situation in the test report. The chip DW07D(U17) and chip AP9211SA-AN-HAC7(U17) has the same basic function. The modification not effect RF parametet & configuration and meet the requirements of KDB 178919 D01 III. Confirmed by Authorized Signature:

Date : 2023-2-8 Page 1 of 1 page

C5266091_X8_Ed.1 Letter of Authorization Company: Videndum Media Solutions Spa Address: Via Valsugana, 100 -36022 Cassola (VI), Italy Product Name: Bluetooth Microphone Model Number: WAVO PRO, WAVO PRO1 FCC Identifier: 2AQK5-WAVOPRO1 We authorize LGAI Technological Center S.A., Ronda de la Font del Carme, s/n, 08193 Bellaterra, Spain, to act on our behalf on all matters concerning the above named equipment. Any individual within LGAI Technological Center S.A. is authorized to act on our behalf and take action on the application. We declare that authorize LGAI Technological Center S.A., Ronda de la Font del Carme, s/n, 08193 Bellaterra, Spain, is allowed to forward all information related to the approval project to the Federal Communication Commission and to discuss any issues concerning the approval application. Any and all acts carried out by LGAI Technological Center S.A. on our behalf shall have the same effect as acts of our own. Name: Diego Selmin Date: 2022-12-19 Title: Quality System & Assurance Manager Signature of applicant:

1/1

US Agent for Service of Process LETTER OF ATTESTATION C566091_X23_Ed1 TO:

Office of Engineering Technology Federal Communications Commission 7435 Oakland Mills Road Columbia, MD 21046 US Agent for Service of Process:

Company Name: Videndum Media Distribution Us Inc FRN: 0033449034 Contact Name: Matteo Marcante Address: 50 Boulevard STE 205- Woodcliff lake, NJ 07677 Telephone

+1 (201) 818-9500 Email: matteo.marcante@videndum.com This letter is to confirm that the US Agent for Service of Process accepts responsibility to act as a local representative on behalf of (Videndum Media Solutions Spa). The US Agent for Service of Process is aware of and agrees to comply with the requirements outlined in the FCC Equipment Authorization Program, Report and Order FCC 22-84, and clause 2.911. Applicant:

Company name: Videndum Media Solutions Spa Product Description: Bluetooth Microphone 2AQK5 Grantee code:

2AQK5-WAVOPRO1 FCC ID:

Contact Name: Diego Selmin Address:

Telephone No: +390424555815 Email:

diego.selmin@videndum.com Via Valsugana, 100 -36022 Cassola (VI), Italy The Applicant is aware of and agrees to comply with the requirements outlined in the FCC Equipment Authorization Program, Report and Order FCC 22-84, and clause 2.911. This Agreement is valid until (March 6, 2028). Date: 2023/02/16 Applicants Name: Diego Selmin Title: Quality System & Assurance Manager Signature US Agent for Service of Processs Name:

Matteo Marcante Title: Officer Signature 1/1