Certification Exhibit ISED Canadas Radio Standards Specification: RSS-247 FCC ID: 2AB7YDPBTLE24 IC: 20699-DPBTLE24 FCC Rule Part: 15.247 ACS Project Number: 16-3030 Manufacturer: Viper Design, LLC Model: DPBTLE24D Manual 2320 Presidential Drive, Suite 101, Durham, NC 27703 USA Voice: 919-381-4235 DPBTLE24D DPBTLE24D DPBTLE24D Users Guide Users Guide Applications Applications Battery Chargers Battery Chargers Power Supplies Power Supplies Features 2.5Ghz Wireless Link:
2.4Ghz - 2.5Ghz Wireless Link UART/SPI interfaces UART/SPI interfaces Support for both mains Support for both mains-powered and battery-powered devices devices Operating Voltage: 3.3V Operating Voltage: 3.3VAC to 30VAC typical Temperature Range:
Temperature Range: -40C to +85C Integrated Networking Stack Stack Integrated power management Integrated power management Integrated wireless Link Integrated wireless Link DPBTLE24D Note Warning: Changes or modifications to this device not expressly approved by Viper Design LLC could void the users authority to operate the equipment. Class B Device NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
connected. Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is Consult the dealer or an experienced radio/TV technician for help. RF Exposure This equipment complies with radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with Maximum distance 20 cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Cet quipement est conforme aux limites d'exposition aux radiations dans un environnement non contrl. Cet quipement doit tre install et utilis distance minimum de 20 cm entre le radiateur et votre corps. Cet metteur ne doit pas tre co-localises ou oprant en conjonction avec tout autre antenne ou transmetteur. Viper Design LLC 125 Glancy St Goodlettsville, TN 37072 Phone: 615-325-0966 Version 0.2 Page 2 of 4 DPBTLE24D Low Power License-Exempt Device This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le prsent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en compromettre le fonctionnement. Labels Host Device must contain the following label on the outside of the unit:
Contains FCC ID: 2AB7YDPBTLE24 Contains IC: 20699-DPBTLE24 Viper Design LLC 125 Glancy St Goodlettsville, TN 37072 Phone: 615-325-0966 Version 0.2 Page 3 of 4 DPBTLE24D 3.0VAC to 30VAC
-40C to +85C SPECIFICATIONS Operational Supply Voltage:
Operating Temperature:
Radio 2.4GHz:
Communication Interface:
UART (2 wire: TX, RX) Line interface options: Logic level, RS-232, or RS-485 Data Format: 8 data bits, 1 stop bit, configurable parity bits Baud Rate: Configurable up to 115.2k SPI (4 wire logic level: SS, SCLK, MISO, MOSI) Data Format: 8 data bits Data Rate:
Viper Design LLC 125 Glancy St Goodlettsville, TN 37072 Phone: 615-325-0966 Version 0.2 Page 4 of 4