PRODUCT SPECIFICATION rec eee eco Coco Peed CS) eo Power Source Cera Penta Cree Ce LCs Creer!
See ey Se eu ance cr) Pay rg Ca Org Poor aay Cred eee Gun Lock 2GIG & Honeywell 345MHZ +/-15KHZ Up to +108m NA 3K~10K bps NA CR2032 Battery Gun Lock Detect 57x36x68mm. 1309 Gun Lock X1 Battery X1 Accessories Xt User ManualX1 LED Status indicator Supervision Battery Detection NA Cet appareil numrique de ta classe [B] est conforme la norme NMB.003 du Canada. Le prsent appareil est conforme aux CNR Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et 2) l'utilisateur lage lage Commission Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation, This equipment generates, uses, and can radiate radio frequency energy and, i not installed and used accordance with the instruction, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If ment does cause harmful interference to radio or television reception, which can be ng the equipment off and on, the user is encouraged to try and correct the jerferene by one of the following measures:
Reorient of relocate the recetving antenna,
: Increase the separation between the equipment and receiver,
- Connect the equipment into and outlet on a circuit different from that to which the receiver is connected.
: Consutt the dealer or an experienced radioiTV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undersired operatior FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.