Manifold Controller Quick Start Guide The Warmboard Manifold Controller (MC) communicates with the Warmsource and Actuators to control the flow of heat to each zone. Installing the MC involves a minimal amount of labor, but its important to pay attention to the details. Follow these simple steps and refer to the complete installation guide for additional information as needed. Declaration of Conformity 47 CFR 2.1077 Compliance Information Warmboard Manifold Controller // FCC ID: 2ASM7-WMC01 Responsible Party U.S. Contact Information Warmboard Inc. 8035 Soquel Drive, Suite 41 Aptos, California 95003 USA 877.338.5493 // warmboard.com FCC Compliance Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. When using this device, a distance of 20cm to the user should always be maintained. This radio transmitter (24839-WMC01) has been approved by Industry Canada to operate with the antenna types listed below with the maximum permissible gain and required antenna impedance for each antenna type indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device. When using this device, a distance of 20cm to the user should always be maintained. Le prsent metteur radio (24839-WMC01) a t approuv par Industrie Canada pour fonctionner avec les types dantenne numrs ci-dessous et ayant un gain admissible maximal et limpdance requise pour chaque type dantenne. Les types dantenne non inclus dans cette liste, ou dont le gain est suprieur au gain maximal indiqu, sont strictement interdits pour lexploitation de lmetteur. Lors de lutilisation de cet appareil, une distance de 20 cm par rapport lutilisateur doit toujours tre maintenue. Dipole, 3dBi, 50ohm Each MC is labeled with the location where it should be installed. Manifold Controllers install inside each manifold cabinet and require their own 120V outlet. Typically, they should be fastened in place above the manifold. Review the Plan Sets to ensure each manifold cabinet is sized and constructed properly based on our specifications prior to installation of the MC. 1 2 3 4 Remove the Manifold Controller from the box and make sure the antenna is firmly attached. Double check the label and make sure the MC is being installed into the correct manifold cabinet. Fasten the MC to the plywood in the manifold cabinet using 4, screws. Plug in the MC to the power outlet, and adjust the antenna as needed. Review the Plan Set, then connect the actuators to the proper ports on the right side of the MC. The color-coded stickers should make this easy. Warmboard, Inc. 8035 Soquel Drive, Suite 41 Aptos, California 95003 1.877.338.5493 warmboard.com