Thermostats Quick Start Guide The Warmboard thermostats are an integral part of the Warmboard Comfort System. Its very important they are installed correctly to ensure the system operates properly. Follow these simple steps and refer to the complete installation guide for additional information as needed. Thermostats should be installed after texture and paint. Each thermostat will be snapped into a pre-wired J-Box (at least 18 cu. inches). Once the Warmboard thermostats are powered up, they communicate wirelessly, so now additional wiring is required. 1 2 3 4 Each thermostat is labeled by room. Review the Plan Set to confirm where each thermostat should be installed. It is very important to install each thermostat into the proper location. Gripping the sides of the thermostat with one hand, and the with the other, separate the front and back pieces from each other. Wire the back of the thermostat into the J-Box, then fasten with the provided screws. Hold the front portion of the thermostat by the sides, then slide in and reconnect to the back portion of the thermostat. Declaration of Conformity 47 CFR 2.1077 Compliance Information Warmboard Thermostat // FCC ID: 2ASM7-WTS01 Responsible Party U.S. Contact Information Warmboard Inc. 8035 Soquel Drive, Suite 41 Aptos, California 95003 USA 877.338.5493 // warmboard.com FCC Compliance Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. When using this device, a distance of 20cm to the user should always be maintained. This radio transmitter (24839-WTS01) has been approved by Industry Canada to operate with the antenna types listed below with the maximum permissible gain and required antenna impedance for each antenna type indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device. When using this device, a distance of 20cm to the user should always be maintained. Le prsent metteur radio (24839-WTS01) a t approuv par Industrie Canada pour fonctionner avec les types dantenne numrs ci-dessous et ayant un gain admissible maximal et limpdance requise pour chaque type dantenne. Les types dantenne non inclus dans cette liste, ou dont le gain est suprieur au gain maximal indiqu, sont strictement interdits pour lexploitation de lmetteur. Lors de lutilisation de cet appareil, une distance de 20 cm par rapport lutilisateur doit toujours tre maintenue. Dipole, 3dBi, 50ohm Warmboard, Inc. 8035 Soquel Drive, Suite 41 Aptos, California 95003 1.877.338.5493 warmboard.com