ADSL Wireless Router For AWR-2410/AWR-2440 Package Contents:
AWR-2410/2440 CD-ROM containing Manual Ethernet Cable (CAT5 UTP Straight-Through) ADSL Cable (Standard telephone cable) Power Adapter Quick Installation Guide hardcopy Splitter (Optional) Connect Hardware AWR-2410 Splitter (optional and changes depending on country specification) RJ-11 ADSL port connect ADSL cable here AWR-2440 RJ-45 Ethernet port connect Ethernet cable here Factory reset button USB CABLE Power Adapter Power cord connect here Splitter (optional and changes depending on country specification) Factory reset button RJ-45 Ethernet port connect Ethernet cable here Power Adapter Power cord connect here RJ-11 ADSL port connect ADSL cable here 1. Select Obtain an IP Address automatically: by clicking once in the circle. Click OK button to confirm and save your changes, and the close the Control Panel. 2. Release IP 3. Renew IP 4. Check Default Gateway:
192.168.1.1. Device Configuration 1. Launch your PC web browser and enter the URL: http://192.168.1.1. 2. In the Username prompt type Admin and in the Password prompt type Admin then click OK button coming setup page. 3. When you see this web page. You have finished login. Note: for more complete information on the device, please see the full manual which is included on the CD. Hereby, Well Communication Corp., declares that this device is in compliance with the essential requirements and other relevant provisions of the R&TTE Directive 1999/5/EC. This device will be sold in the following EEA countries: Austria, Italy. Belgium, Liechtenstein. Denmark, Luxembourg. Finland, Netherlands. France, Norway. Germany, Portugal. Greece, Spain. Iceland, Sweden. Ireland, United Kingdom. FEDERAL COMMUNICATIONS COMMISSION This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiated radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help. Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not be less than 20cm (8 inches) during normal operation.