Aroma Diffuser D300 User Manual Product Specification Product Feature Mist Tube ON Indicator Light Mist Level Button Base Add water from the top Air inlet Cover Timer Indicator Lights Timer Button Light Button Splash Guard Max Water Level Adaptor AC Clean Brush DC Plug Air Outlet Ceramic Disc Function Characteristics
1. Long press and the diffuser will start on the low mist level, the ON light will turn on and the buzzer will sound for 1 second. Then short press to use the high mist level. Buzzer will sound twice. Long press again to turn misting off. The ON light will turn off and the buzzer will sound for 1 second. 2. 3. DC Socket
1. 2. 3. Press to adjust timer lengths (1, 3, 6 hours) and to turn the timer off. The diffuser will turn off at the end of the timer. The timer will only be used when mist is turned on.
1. 2. 3. 4. Press and the RGB light will start on the gradient mode. Then press to choose a colour between 7 colors. Continue to press briefly to return to gradient mode and cycle control. Long press to turn the RGB light off.
1. When the diffuser turn off, it will remember your mist and light settings when turned back on.
1. With water shortage detector, when being in operation, it will automaticlly power off if waterless, which can protect the atomizer from being burnt and broken. Operation Approach Please open the top cover. Add around 300mL tap water inside the water tank. Avoid essencial oil or acetone chemicals dropping on the cover surface, in case of the painting peeling off. Please do not exceed the max water line when filling water inside, two or three drops of essential oil is enough for 300mLwater. Insert the adaptor plug into household power socket. E s s e n t i a l o i l Water Close the top cover. Troubleshooting If start up the machine but it doesn't work, please check the followings. Problems Possible Reasons Handling No electricity, not working. Unable to spray mist or spray bad. Power not connected. Power wire broken or adaptor burn out. If the water inside tank is nat enough?
If the water inside tank is too much?
Is the ceramic disc dirty?
Is top cover rightly placed?
If the bottom air inlet is dirty?
Main body is leaking water. If the top cover is rightly covered?
If the room temperature is low or with wet humidity?
Connect the power, press power button. Please contact local retailer. Please fill the water. If the water volume exceeds 300mL(max water line), the mist volume will be very small. Please clean the water trough. Please replace the top cover. Please clean away the dust of bottomair inlet. If top cover is not rightly covered, the water will splash out and fall onto machine body or table. Low temperature and wet humidity may cause machine sweats. FCC WARNING This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruc-
tions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or televi-
sion reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the follow-
ing measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help. To maintain compliance with FCCs RF Exposure guidelines, this equipment should be installed and operated with minimum 20cm distance between the radiator and your body: Use only the supplied antenna.