Instruction Manual AM-Juno II 2-4 1 5 6 7 8-9 10-11 12 13-16 17 18 19 20 Keep Dry Do not operate in a wet or moist condition. 1 Temperatures sufficiently high to cause burns may occur regardless of the control setting. Do not use on an infant or invalid or on a sleeping or unconscious person. Do not use on insensitive skin or on a person with poor blood circulation. Check the skin in contact with the heated area of the appliance frequently to reduce the risk of blistering. Do Not Crush Avoid sharp folds. Do not use massager in close proximity to loose clothing or jewelry. Keep long hair away from massager while in use. 2 3 4 This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment . 5 ISEDC ISEDC warning This device complies with Innovation, Science, and Economic Development Canad licence-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device. Le prsent appareil est conforme aux CNR d' Innovation, Sciences et Dveloppement conomique Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux conditions suivantes :
(1) l'appareil nedoit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en compromettre le fonctionnement. The device is compliance with RF exposure guidelines, users can obtain Canadian information on RF exposure and compliance. The minimum distance from body to use the device is 20cm. Le prsent appareil est conforme Aprs examen de ce matriel aux conformit ou aux limites dintensit de champ RF, les utilisateurs peuvent sur lexposition aux radiofrquences et la conformit and compliance dacqurir les informations correspondantes. La distance minimale du corps utiliser le dispositif est de 20cm. 6 8 1.PREPARATION contains footrest. This model is come with 2 boxes packing design : Box 1 contains main body and Box 2 Connect the cable to outlet and chair .Switch ON the current,the chair will return back to the original position.(Caution:the assembly for footrest will be easy after the chair had returned to original position.Unplug the cable after the chaire return to original position) 2.Footrest assemble Connect the wire connectors and screw the cap tight.Then connect the air hose. Caution:after the wire connector have been connected the cap must be screwed tight. 9 2.Remove the two circlips on the bolts,then attach the footrest onto the base and lock the circlips. Caution:please attach on the long bolt first. 2.Zip the zipper between the seat pad 2.Connect the chair to a power supply and footrest. turn on the power switch,the chair will be ready to start. 10 11 12 1.Power 5/6.Spot/Zone 3.Time 10.Wake up 9.Healthy 12.Revitalize 16.Arm 15.Shoulder 19.Recline 20.Upright 21.Up 22.Down 2.Pause 7/8. -/+
4.Zero Gravity 13. Classic 11.Relax 14.Stretch 17.Foot Air 18.Vibrate 23.Speed 24.Manual 25.Intensity 26.Width HEALTHY WAKE UP RELAX REVITALIZE CLASSIC STRETCH SHOULDER ARM FOOT AIR VIBRATE RECLINE UPRIGHT UP DOWN SPEED MANUAL INTENSITY WIDTH 13
The power button starts and stops all functions on the massage chair. Press once, the chair is idle mode. Press again, all functions will stop, and massage rollers will return to original position. The pause button will allow all massage functions to stop temporarily. Press once, all the massage functions and timer will be stopped temporarily. Press again to resume the massage session. The timer button controls the length of the massage session. The default time for all massage functions is 15 minutes. Press each time to change the length of the time in the following sequence:
How to Start Function Description 1.Power 2.Pause 3.Time 5.Spot 20>25>30>5>10>15. 4.Zero Gravity Adjust the angle of the massage chair to zero gravity position. Press to achieve position required.Press again to resume to original position. This key with two functions: one is for spot massage and one is for making roller upward. Press once, it will allow users to choose the exact position to massage. Hold the key and dont release, it will move roller upward. When the roller reach the position needed, stop holding the key. This can be applied to all massage selections. 14 This key with two functions: one is for zone massage and one is for making roller Press once, it will allow uses to limit the massage in 12cm long to a particular body Hold the key and dont release, it will move roller downward. When the roller reach the position needed, stop holding the key. Press each time to adjust intensity of Kneading Massage. Rolling and tapping will be activated at the area of mid and low back. Recommended for sore mid and low back. Engages the Snooze Auto Program, based on the waist by Kneading, Shiatsu and other Help to shape up body and relieve stress. Combination of kneading and tapping massage kicks off the full body. With kneading and tapping, start from the head, down to the lower back, and focus on the buttocks. This program focuses on neck, shoulder and hip by Rolling and Kneading, reduction of 6.Zone downward. zone. 7/8.-/+
9.Healthy 10.Wake up techniques. 11.Relax 12.Revitalize body fatigue. 13. Classic Engages the deep tissue massage to loosen up the muscles. 15 This function allows users to adjust the strength of massage. There are total 5 levels for your options. This function activated the air compression on shoulder area. This function activated the air compression on arm area. This function activated the air compression on foot area. This button control the vibration in seat area. Press once to activate vibration.Press again to stop the vibration. 14.Stretch 15.Shoulder 16.Arm 17.Foot Air 18.Vibrate 19.Recline 20.Upright This button controls recline angle of the massaging chair. Press once, the backrest and footrest will move to a horizontal reclining position. This button control incline angle of the massage chair. Press once, the backrest and footrest will move to an upright sitting. Press again to stop the product at your preferred angle. 21.Up Adjust back massage position. Press the button to choose position of massage rollers when a "beep" sound alerts in 10 seconds. Release the button once the desired position is achieved. 16 22.Down Adjust back massage position. Press the button to choose position of massage rollers when a "beep" sound alerts in Release the button once the desired position is achieved. Control the speed of Tapping, Kneading, Swedish, Shiatsu, Kneading and tapping Select a massage function and press to select between 5 speeds. Controls Kneading, Tapping, Swedish, Shiatsu, Kneading and tapping ,Rolling massage. Press once to activate kneading massage of the full back. Each press of button, the massage mode changes in sequence: Tapping>Swedish>
Shiatsu>Kneading and Tapping>Rolling. This button allows users to adjust the intensity of airbag on the calves and feet area. There are five levels for your option. This button allows you to control the width of the rollers. Select a massage function and press to adjust between Narrow, Normal and Wide 10 seconds. 23.Speed massage. 24.Manual 25.Intensity 26.Width widths. 17 18 19 20 AM-Juno II 130W 57.1 29.5 42.9 67.3 29.5 33.5 213.8 177.5 21 4 7 7 Wireless charging 4 7