Packing List Appearance and Components Front View Display Power Buon Printer Cover Front Cover Rear View USB Port
(Type A) USB Port
(Type B) your choice. Inside View Status Indicator Feed Buon Cover Open Buons Power Receptacle Ethernet Port Moveable Roll Holders Quick Start Guide iT4R Printer AC Adapter Power Cord Label Roll Ribbon Spindles Ribbon CD Quick Start Guide USB Cable Note: The views above are for your reference. Ports vary by Xiamen Hanin Electronic Technology Co.,Ltd. ADD: Room 305A, Angye Buildling, Pioneering Park,Torch High-techZone,Xiamen E-mail: support@idprt.com Web: www.idprt.com Empty Ribbon Core Note: The packing materials are actually based on the order. Locking Tab 2 Loading the Roll 1.Press to open the printer cover and mechanism. 3.Pass the labels through label guides and adjust label guides to labels width. Quick Start Guide 1 Front Label Sensor USB Connecon 1.Connect the AC adapter to power receptacle. 2.Connect the power cord to AC adapter. 3.Connect the other end of power cord to the outlet. 2.Pull the roll holders open and place the roll between them.Press down the locking tab. Mechanism Lock Printer Mechanism Back Label Sensor Moveable Label Guides Platen Varies by regions 3 4 5 Loading the Ribbon 1.Install the ribbon module. Sckup Ribbon Supply Spindle Ribbon Rewind Spindle 2.Insert the le part of supply spindle and then the right part spindle. 3.Press down the printer mechanism. 4.Insert the le part of rewind spindle and then the right part. FCC Warning 5.Wind the core 2~3 circles unl the ribbon is pulled ghtly. 6.Press down the mechanism and close the cover. 6 7 8 Note: Please refer to windows driver installaon in iT4R User Manual. of the following measures:
This device complies with part 15 of the FCC Rules. Operaon is subject to the following two condions:(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operaon. Any Changes or modicaons not expressly approved by the party responsible for compliance could void the user's auth-
ority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protecon against harmful interference in a residenal installaon. This equip-
ment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruc-
ons, may cause harmful interference to radio communicaons. However, there is no guarantee that interference will not occur in a parcular installaon. If this equipment does cause harmful interference to radio or television recepon, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more
- Reorient or relocate the receiving antenna.
- Increase the separaon between the equipment and receiver.
- Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. FCC RF exposure statement:
The equipment complies with FCC radiaon exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance between 20cm the radiator your body. FCC ID2AUTE-IT4R