USB USB
APP APP APP HPRT M11 USB Reset PC USB CCC Reset 12 400-766-7666 96 www.hprt.com.cn
After-sales WeChat Product Introduction Appearance and Components Product Introduction LED Indicator Status Paper Loading App Download Scan the QR code to download App. Battery Charging General Q&A FCC WARNING When the battery power is low, the red LED indicator will ash slowly. Please charge it by the exclusive USB cable in time. If you continue printing it may power o automatically. When the printer crashes, how to deal with it?
This device complies with part 15 of the FCC Rules. Operation is subject to the following
-- Connect the equipment into an outlet on a circuit dierent from that to which the Open the upper cover, lightly hold down the [Reset] button with two conditions: (1) this device may not cause harmful interference, and (2) this device receiver is connected. a pin so that the printer will be o, and then restart the printer. must accept any interference received, including interference that may cause undesired
-- Consult the dealer or an experienced radio/TV technician for help. Thermosensitive Layer Connection and Printing Charge via PC operation. Any changes or modications not expressly approved by the party responsible for can be used in portable exposure condition without restriction. compliance could void the user's authority to operate the equipment. FCC ID2AUTE-PLP The device has been evaluated to meet general RF exposure requirement. The device Cover-opening Button Paper Outlet Tear Bar Power Button &
LED Indicator USB Interface Packing List Printer USB Cable Quick Start Guide ON: Error (Paper jam/Paper end/Cover opened) Red LED Error Status Quick Flash: TPH is over temperature Slow Flash: Low power Green LED Basic Status ON: Charging nished/Printer is ready Slow Flash: Charging Red and green LED ash alternately Firmware updating Button Operation Hold down the power button for a few seconds: Turn on/o the printer Press the power button: Position and calibrate the location of thermal label paper and heating line Slide the cover-opening button as shown in the gure to open the upper cover. Load the paper as shown in the gure and make sure the thermosensitive layer faces down. Close the upper cover and pull some extra paper. Turn on Bluetooth on your mobile phone, then open App, click Device Connection, select HPRT M11. Select Scan to get the template, then scan the QR code on the paper core to recharge consumables mileage and get the templates. Edit the label as need, and then click Print after editing. Charge via AC Adapter Note: The printer can be charged via computer USB port or AC adapter. Please note that the AC adapter is not supplied. Reset Button NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver. HPRT M11