FCC ID: ZPD-TSZ9BR30 LED lamp

Self-ballast LED lamp User Instruction Product Features Compact structure and design - small, light weight, stylish Made with high quality parts and materials - high reliability Light-emitting elements and parts produced with new manufacturing technology high lumen output The LED bulbs can't be used in any dimmable circuit Product drawing and dimensions Model Input Power

(W) CCTK Lamp cap TSZ9BR30-LD01 120VAC 50/60Hz 9W 2700-6500K E26 1-CEC Selection and installation instruction 1. Open product packaging and check if product is intact, contact seller if found damaged. 2. Check to confirm product rated voltage is same as local power grid voltage. 3. Switch off light power. 4. Hold bulb by plastic housing and install into light socket. 5. Switch on/off as usual when power is connected. Warning 1. Do not put in dripping-wet environment. 2. Do not touch bulb when switched on as high surface temperature may scorch and injure skin. 3. Lumen output drops when bulb is used beyond rated lumen maintenance period. For better protection of your eyesight, do not use beyond rated period and replace bulb accordingly. 4. Use in Damp Locations only FCC Warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body. ISED Statement English:This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canadas licence-exempt RSS

(s). Operation is subject to the following two conditions:

(1) This device may not cause interference.

(2) This device must accept any interference, including interference that may cause undesired operation of the device. The digital apparatus complies with Canadian CAN ICES3 (B)/NMB3(B). French: Cet appareil contient des metteurs/rcepteurs exempts de licence qui sont conformes aux RSS exempts de licence d'Innovation, Sciences et Dveloppement conomique Canada. L'exploitation est soumise aux deux conditions suivantes :

(1) Cet appareil ne doit pas provoquer d'interfrences.

(2) Cet appareil doit accepter toute interfrence, y compris les interfrences suscept ibles de provoquer un fonctionnement indsirable de l'appareil. l'appareil numrique du ciem conforme canadien peut 3 (b) / nmb 3 (b). This device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS 102 RF exposure, users can obtain Canadian info rmation on RF exposure and compliance. cet appareil est conforme l'exemption des limites d'valuation courante dans la se ction 2.5 du cnr - 102 et conformit avec rss 102 de l'exposition aux rf, les utilisateur s peuvent obtenir des donnes canadiennes sur l'exposition aux champs rf et la con formit. This equipment complies with Canada radiation exposure limits set forth for an unc ontrolled environment. Cet quipement est conforme aux limites d'exposition aux rayonnements du Canada tablies pour un environnement non contrl. This equipment should be installed and operated with minimum distance 20cm betw een the radiator & your body. Cet quipement doit tre install et utilis une distance minimale de 20 cm entre le radiateur et votre corps.

Page 1 of 1 FCC ID: ZPD-TSZ9BR30 IC: 23379-TSZ9BR30 Label and Location LED lamp Model No.: TSZ9BR30-LD011-CEC FCC ID: ZPD-TSZ9BR30 IC: 23379-TSZ9BR30 Size: L: 3.5cm*W: 3.0cm Label Location Shenzhen LCS Compliance Testing Laboratory Ltd. Add: 101, 201 Bldg A & 301 Bldg C, Juji Industrial Park Yabianxueziwei, Shajing Street, Baoan District, Shenzhen, 518000, China Tel: +(86) 0755-82591330 | E-mail: webmaster@lcs-cert.com | Web: www.lcs-cert.com Scan code to check authenticity

Xiamen Topstar Lighting Co., Ltd. 676 Meixi Avenue, Tong'an District, Xiamen, Fujian, China Federal Communications Commission Authorization and Evaluation Division Equipment Authorization Branch 7435 Oakland Mills Road Columbia, MD 21046 2023-12-8 To whom it may concer:

We, Xiamen Topstar Lighting Co., Ltd., hereby certify that the equipment for which authorization is sought (FCC ID: ZPD-TSZ9BR30) is not covered equipment prohibited from receiving an equipment authorization pursuant to 2.903 of the FCC rules. We also certify that, as of the date of the filing of the application, we are not identified on the Covered List (httos://www foc. gov/supplychain/coveredlist) as an entity producing covered equipment. By signing this form, we confirm the above and that we are aware of the application requirements listed under 2.911(b) and (d)(5) and (6). The information provided in this letter is based on the referenced rule parts of Title 47 of the CFR as well as KDB 986446 DO1 Sincerely, Abang Signature Nancy Na Certification Engineer Xiamen Topstar Lighting Co., Ltd.

CONFIDENTIALITY REQUEST for Certification Service in USA Federal Communication Commission Equipment Authorization Division, Application Processing Branch 7435 Oakland Mills Road Columbia, MD 21046 Date:<2023-12-8>

Pursuant to Paragraphs 0.457 and 0.459 of the Commission's Rules (47 C.F.R.) and Section 552(b)(4) of the Freedom of Information Act, we requests confidentiality for the following products:

FCC ID Model name ZPD-TSZ9BR30 TSZ9BR3|

)-LD011-CEC For the product stated above, we request that the following information be held confidential;

Long-Term Exhibits Confidentiality Short-Term Confidentiality Short-Term Confidentiality Days Extemal Photos Internal Photos. Block Diagram Schematics Test Setup Photos:

User's Manual Parts List Tune Up BoOkOAaRRoOo Operational Descriptions:

Dopooo0ol The long-term confidentiality exhibits contain our trade secrets and proprietary information that could be of benefit to our competitors. The short-term confidentiality on the basis of ensuring that business sensitive information remains confidential until the actual marketing of our new device. If you have any questions, please feel free to contact me at the address shown below. Sincerely, Abort Nancy Na/Certification Engineer Xiamen Topstar Lighting Co., Ltd. 676 Meixi Avenue, Tong'an District, Xiamen, Fujian, China

(0592-7263847 nsq@topstar.com.cn

Xiamen Topstar Lighting Co., Ltd. 676 Meixi Avenue, Tongan District, Xiamen, Fujian, China Date: 2023-128 FCC ID: ZPD-TSZ9BR30 Model Number: TSZ9BR30-LD011-CEC To:

Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD To Whom It May Concern, We, Xiamen Topstar Lighting Co., Ltd., declare that this FUT (FCC ID: ZPD-TSZ9BR30) doesnt have Ad Hoe mode function on non-US/Canada frequencies. In addition. The frequency selection feature is disabled by firmware for devices marked to the US/Canada. For DTS part of this device, only channels 1-11 will be used in North America, Country code selection is disabled. Should you have any questions or comments regarding this matter, please have my best attention. Sincerely, Abort Name/Title: Nancy Na/Certification Engineer Company: Xiamen Topstar Lighting Co., Ltd. Address: 676 Meixi Avenue, Tong'an District, Xiamen, Fujian, China Phone: (0592-7263847 Fax E-mail: nsq@topstar.com.cn

Xiamen Topstar Lighting Co., Ltd.

(676 Meixi Avenue, Tong'an District, Xiamen, Fujian, China Federal Communications Commission Authorization and Evaluation Division Equipment Authorization Branch 7435 Oakland Mills Road Columbia, MD 21046 2023-12-8 To whom it may concer:

We, the undersigned, hereby authorize Eurofins Product Service GmbH to act.on our behaffin all matters relating to applications for equipment authorization FCC ID: ZPD-TSZ9BR30 including the signing of all documents related to these matters. Any and all acts carried out by Eurofins Product Service GmbH on our behalf shall have the same effect as acts of our own. By signing this application form, we agree to Eurofins current valid General Terms and Conditions

(AGB),Testing and Certification Regulations (PZO) which can be viewed on following website www.eurofins de/ee or retrieved on request. We also hereby certify that no party to this application is subject to a denial of benefits, including FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C. 862. Sincerely, Abagre Name/Title: Nancy Na/Certification Engineer Xiamen Topstar Lighting Co., Ltd. 676 Meixi Avenue, Tong'an District, Xiamen, Fujian, China 0592-7263847 nsq@topstar.com.cn

Xiamen Topstar Lighting Co., Ltd. Federal Communications Commission Authorization and Evaluation Division Equipment Authorization Branch 7435 Oakland Mills Road Columbia, MD 21046 U.S. Agent Designation 12/5/2023 Xiamen Topstar Lighting Co., Ltd. acknowledges their consent for the following contact located in the United States to act as their agent for service of process for the equipment for which authorization is sought (FCC ID:

ZPD-TSZ9BR30):

Name and company of U.S. agent:

Chargenetic, INC Physical U.S. address of agent:

10010 Nicollet Lake Ln, Katy, TX 77494, USA FRN of U.S. agent:

0033431669 Email address of U.S. agent:

Vince.lonestar@gmail.com Chargenetic, INC acknowledges their obligation to accept service of process on behalf of Xiamen Topstar Lighting Co., Ltd Xiamen Topstar Lighting Co., Ltd. with the FRN 0020969929 accepts its obligation to maintain an agent for service of process in the United States for no less than one year after either the grantee has permanently terminated all marketing and importation of the applicable equipment within the U.S., or the conclusion of any Commission-related administrative or judicial proceeding involving the equipment, whichever is later. By signing this form, we confirm the above and that we are aware of the application requirements listed under 2.911(d)(7). The information provided in this letter is based on the referenced rule parts of Title 47 of the CFR as well as KDB 986446 D01. An expiration date for this letter does not exist. In case the U.S. agent changes, the grantee is obligated to notify the FCC within 30 days via the granting TCB. Sincerely, Signature Nancy Na Certified engineer Xiamen Topstar Lighting Co., Ltd. Signature Vincent Shao CEO Chargenetic, INC 5 0 V

, U

) 7

) d

1 1 9

. 2 _ t n e g A _ S U

l e d o m

_ 8 4