V900 REMOTE CONTROL USER MANUAL Thank you for purchasing V900 remote control. Completely operation and product function information refer in this manual. 1 V900 remote control suits for V900 GSM remote camera. 2 V900 remote control instruction 1. Antenna 2. Indicator light 3. Set defense key (Arm) 4. Cancel defense key (Disarm) 5. Emergency key 3 Operation guide 3.1 Add remote control to V900 GSM remote camera Press the set key on the rear board of the camera host and the camera indicator turn to flash slowly with orange color. Then press any key of the remote control. When the camera host receives the new wireless remote control signal, a Di tone will be heard and the camera indicator will turn green for 2 seconds then turn to orange, flash slowly. It can continue to load new remote control in this time. The camera will automatically exit from the learning status after 15 seconds, or press the set key of the camera to exit directly. 3.2 Arming the V900 remote camera (Set defense) When press the Set defense key, the camera indicator will turn constant green, and the camera enter the defense state. If the wireless detector or motion detection be activated, the camera will alarm to dial or send alarm information via SMS/MMS. 3.3 Disarming the V900 remote camera (Cancel defense) When press Cancel Defense key, the camera indicator turn green and flash slowly, and the camera enter the state of cancel defense. In these statues, the camera can alarm only by pressing the Emergency key. 3.4 Emergency alarm When press the Emergency key, the camera indicator will turn to flash green quickly and the camera will dial the master and the emergency numbers orderly. Live voice can be heard by answering the calling. It will call master and all emergency numbers three times unit answered, then exit dialing automatically. A Di tone can be heard from the camera by pressing any remote control key. 4 Technical specification Power sourceDC12VAAA Standby current0uA Frequency315MHz Frequency error75kHz Working current2mA Modulation modeASK RF-output power0dBm FCC Warning:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.