Xilor Inc. Wireless Keyfob Transmitter DISCLAIMER The information contained here is considered accurate. However, Xilor makes no warranty or guarantee whether expressed or implied regarding the accuracy of the data, the results to be obtained from the use thereof, or that any such use will not infringe upon a patent. User shall determine the suitability of the product for the intended application and assume all risk and liability whatsoever in connection therewith. Under no circumstances shall Xilor be liable for incidental, consequential or other damages arising out of the use or handling of this product or the failure of the device to operate in a specific application. Xilor Inc make no representation, guarantee, or warranty regarding the suitability of use. Our wireless control devices should not be used in applications where safety risks or possible loss of life may occur. The sole liability of Xilor for any claims arising out of the manufacture, use or sale of its products shall be to refund the buyers purchase price provided such products have been demonstrated, in Xilors sole opinion to justify such refund. Xilor Inc. 1400 Liberty Street Knoxville, TN 37909 www.rfmicrolink.com www.xilor.com Tel: (865) 546-9863 Fax: (865) 546-8324 Link series series 4 rev.8/01 1 OVERVIEW Link series remote control is designed for industrial, home, or automotive applications. The series include 2, 4 and 8 channel units.They have been precertified for FCC Part 15 compliance and are available in 418MHz or 433MHz with the former being our standard. The remote is powered with a 3V lithium cell battery and its typical transmission range is 100 feet. Signals can be decoded using our decoder ICs or our RF receiver subassemblies. CODE SYSTEM A unique sequential serial number is factory programmed during manufacturing and therefore there is no need to manually set each transmitter address. CHANNEL ASSIGNMENT
*Numbers are for document labeling purposes only. They do not come on stock units. CONTENTION ISSUES Only one transmitter at a time of a certain carrier frequency can be operated without contention. Two signals of the same frequency can not share the same carrier within the operating range of the other. This results in signal jamming . BATTERY Battery is already factory installed. To replace battery use CR2032 Lithium cell for remote units. Observe polarity when replacing bat-
tery. Battery cell holder has a plus on it indicating which way to install battery. To remove battery use non-metallic object to push battery out of cell holder . 2 2 FCC INFO. FCC ID:PNZ4XX This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference and
(2) This device must accept any interference that may cause unde-
sired operation. _____________________________________________________ This equipment has been tested and found to comply with the limits for a Class-B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or televi-
sion reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
1) Reorient or relocate the receiving antenna 2) Increase the separation between the equipment and receiver. 3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 4) Consult the dealer or an experienced radio/TV technician for help. _____________________________________________________ This equipment has been certified to comply with the limits for a Class-B computing device, pursuant to FCC Rules. In order to main-
tain compliance with FCC regulation s, shielded cables must be used with this equipment. Operation with non-approved equipment or unshielded cables is likely to result in interference to radio and TV reception. Changes and modifications by the user to the equipment without the approval of the manufacture could void the users authority to oper-
ate this equipment. 3