FCC ID: 2ADK3-XO-9771 Powerbank with wireless charger

SIZE:148*210MM High Sierra 10000 mAh Solar Fast Wireless Power Bank FCC ID: 2ADK3XO-9771 Specications:

Powerbank:

USB- C input:DC5V/ 2A,9V/ 1.67A USB- A output:DC5V/ 2A Max. USB- C output:DC5V/ 2A Max. Battery:10000mAh / 37Wh. Wireless Output:compatible with 5W/7.5W/10W fast charge,. Eciency:

70%. FOD/NTC included. Solar panel:

Input 5V/150mA. Features:

1. Powerbank;

2. Wireless charging pad;

3. Flash light;

4. Solar panel;

5.Carabiner;

LED Indication :

* When the powerbank is connected to the power source,the charging LED indicator will ash in Blue,if the LED no display, please press the button.LED will light in blue

* Short press the button,the wireless charger LED will ash in red one time then o,place the enabled device on the surface of the wireless charging pad If the phone or other device just support 5W, the LED will light in red. If the phone or other device support 10W , the LED will light in green. How to use 1. Charging the powerbank:

Using a quick charge AC adapter (9V/1.5A or more),connect the cable.the powerbank is being charged.If the LED no display, please press the button one time. 2. Wireless charging powerbank:

Short press the button, turn on the fast wireless charger,you can charge your smartphone by laying your phone on the powerbank. Please put the wireless charger on at place then put your device on the wirless chager, keep 20CM distance when charging. 3. Use powerbank:

You can also charging your phone or other devices with a USB cable. 4. Use the torch Press the button and hold 2 seconds to turn on the torch, quick press the button 2 times to turn o the torch. Remark:

1.If the powerbank is charging other devise by cable, the wiress charger only can support 5W charging. 1.If the powerbank is being charged, can not use cable to charge other device, also can not use wireless charger. No output current when the powerbank is being chaged. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct theinterference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help Changes or modications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired operation. RF Exposure Warning Statements:

This equipment complies with FCCradiationexposure limits set forth for an uncontrolled environment.This equipment shall be installedand operated with minimum distance 20cm between the radiator & body.

Powerbank with wireless charger Instruction Manual XO-9771 m m 9

. 8 8 Features:

Wireless Charging Surface 1. LED Indicators 2. Flashlight 3. Solar Panel 4. ON/OFF Button 5. Type-C Input 6. USB A Output 7. Whats included:

1 x 10000 mAh Fast Wireless Power Bank 1 x USB to Type C Charging Cable 1 x Instruction Manual Battery: 10000mAh/37Wh Type-C Input: DC5V/2.4A; 9V/1.67A USB A Output/Type C Output: DC5V/2.4A max Wireless Output: 5W/7.5W/10W Fast Charge Solar Panel Input: 5V/150mA LED Indicators:

ON/OFF Button: Press once to view the remaining power capacity. There is a total of 5 LED indicators, starting showing remaining capacity(30%-65%-100%). The remaining 4th and 5th LEDs shows the wireless charging for 10W and 5W devices. INSTRUCTIONS:

1. Charging the Powerbank:

Charge the powerbank fully before usage. Connect the provided charging cable to a quick charge AC adapter and to the Type-C charging port on the powerbank(6). Once connected the LED Indicator will 2. 3.

4. fully charged LED will turn solid BLUE. Charging mobile phones and other electronic devices:

Connect the charging cable to your mobile phone/device using the appropriate connector. Connect the USB part of the cable into USB A Output(7) or Type C tip into Type C input (6). LED indicator will illuminate when charging. Remove the USB cable from your mobile device when it is fully charged. Wireless Charging Function:

To turn on the wireless charging function, Press the ON/OFF button(5), the 5th LED indicator will glow RED, then 4th one glows GREEN. Place wireless charging supported mobile device on the charging surface(1). If the device supports 5W, LED indicator displays RED; If the device supports 10W, LED indicator displays GREEN. Phone will begin to charge automatically. Note: When wireless charging, if the LED between the device and charging surface interfering with the charging process. Activate Flashlight Function(3):

ON/OFF button untill the light turns ON. Press and hold to turn OFF the light.

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired operation. 208.5 mm 5. Charging with the Solar Panel:

Place power bank in bright/consistent sunlight. Power bank will begin to charge once exposed to the sunlight. SAFETY PRECAUTIONS:

WARNINGWhen using this product, basic precautions should always be followed, including the following:

Read all the instructions before using the product. Charge the power bank fully before initial use. The units full performance is achieved only after 2 or 3 completed charge and discharge cycles. To reduce the risk of injury, close supervision is necessary when the product is used near children. Do not expose the device to moisture. Do not use the device in excess of its output rating. Overload outputs above 1. 2. 3. 4. 5. 6. 7. Do not use the device if damaged or 8. 9. 10. explosion or risk of injury. Do not disassemble the device. Take it to or repair is required. Incorrect reassembly Do not use or store product in extreme temperatures. Do not leave the product in a vehicle. High Temperatures may shorten the life expectancy of the product or result in overheating and explosion. 11. 12. 13. 14. repair person using only identical replacement parts. This will ensure that the safety of the product is maintained. Do not overcharge Phone. Unit may get hot with excessive use. Remove Phone when it is fully charged. Never charge for more than 7 hours at a time. Attachments on the back of your phone can impede the effectiveness of the wireless charger, and lead to overheating. You must remove attachments from the phone before charging on this device.

Note: In order to charge devices, use only the accessory cable or the cable included with your own device by the manufacturer. FCC Statement:

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

XING DA INTERNATIONAL ELECTRONICS LIMITED Agent Authorization Company: XING DA INTERNATIONAL ELECTRONICS LIMITED Address: #98 LiWu Swan Industrial District, Qiao Tou Town, Dong Guan, Guang Dong, China Product Name: Powerbank with wireless charger Model Number(s): XO-9771 Product Description: Powerbank with wireless charger We authorize MiCOM Labs Inc., 575 Boulder Court, Pleasanton, California 94566, USA, to act on our behalf on all matters concerning the certification of above named equipment. We declare that MiCOM Labs Inc. is allowed to forward all information related to the approval and certification of equipment to the regulatory agencies as required and to discuss any issues concerning the approval application. Any and all acts carried out by MiCOM Labs on our behalf shall have the same effect as acts of our own. Signature:

Name:

Sam Shen Date: 2022-12-02 Sales Title:

Company: XING DA INTERNATIONAL ELECTRONICS LIMITED

XING DA INTERNATIONAL ELECTRONICS LIMITED Office of Engineering Technology Federal Communications Commission 7435 Oakland Mills Road Columbia, MD 21046 USA Subject; Request for Confidentiality FCC ID: 2ADK3-XO-9771 To Whom It May Concern, Pursuant to the provisions of the Commissions rules Title 47 Sections 0.457 and 0.459, we are requesting the Commission to withhold the following attachment(s) as confidential documents from public disclosure indefinitely. Date: 2022/12/02 These documents contain detailed system and equipment descriptions and are considered as proprietary information in operation of the equipment. The public disclosure of these documents might be harmful to our company and would give competitors an unfair advantage in the market. Schematic Diagram Block Diagram Operational Description In additional to above mentioned documents, in order to comply with the marketing regulations in Title 47 CFR 2.803 and the importation rules in Title 47 CFR 2.1204, while ensuring that business sensitive information remains confidential until the actual marketing of newly authorized devices, we request Short Term Confidentiality of the following attachment(s);

User Manual For 45 days, pursuant to Public Notice DA 04-1705. OR For 180 days pursuantto KDB 726920 D01. It is our understanding that all measurement test reports, FCC ID label format and correspondence during the certification review process cannot be granted as confidential documents and this information will be available for public review once the grant of equipment authorization is issued. Sincerely, Signature:

Name: Sam Shen Title: Sales