INSTRUCTIONS FOR REMOTE CONTROLLER Arrow buttons These arrows change the speed of the selected function. Each time you push the arrow, it increases/decreaes the function speed of your current selected light function Blink button Two or more colors will blink alternately. Each time you push the Blink button, the color combination will change. There are a total of 6 color combinations that can happen:
1. Red / green blink 2. Red / white blink 3. Blue/white blink 4. Yellow / purple blink 5. Red / white / blue blink 6. Red/yellow /green /blue/purple blink Fade In/Out button The lights will fade in and out with a pre-programmed color-changing sequence. Chasing button The lights will color chase from the bottom to the top. Each time you push the button, the colors will change. There are a total of 6 color combinations that can happen:
1. Red chasing 2. Green chasing 3. Blue chasing 4. Yellow chasing 5. Purple chasing 6. Light green chasing 7. White chasing Auto Fade button The lights will color chase in a pre-programmed color sequence. Steady on, solid color buttons. 16 total color options FCC STATEMENT :
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. RF warning statement:
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.