CEILING FAN REMOTE CONTROLLER OPERATION AND INSTALLATION INSTRUCTIONS
(Please keep this instruction pamphlet.) IMPORTANT YOU MUST SET CEILING FAN MANUAL SWITCH TO HIGH SPEED AND LIGHT KIT (IF ANY) TO ON POSITION BEFORE OPERATING REMOTE CONTROL. IMPORTANT POINTS TO REMEMBER:
1. Read and save these instructions. 2. 3. The supply to the remote control receiver should be connected through a mains switch, i.e. Please note that all fixed wiring appliances should be installed by a qualified electrician. existing wall switch. 4. Disconnect from power supply at wall switch before working on remote control receiver or ceiling fan. Install receiver into the ceiling fan canopy of the fan to ensure proper protection. 5. 6. This unit is to be used for the control of ceiling fan and in an AC110V/120V 60Hz power supply only. 7. Do not install in damp locations or immerse into water. (For indoor use only.) 8. Do not pull on or cut leads shorter. 9. Do not drop or bump the unit. INSTALLATION INSTRUCTIONS CAUTION: INCORRECT WIRE CONNECTION WOULD DAMAGE THIS RECEIVER. 1. Once the connection has been made, the receiver inserts into the drop rod hanging bracket. The canopy comes up to cover the receiver and bracket. LEARNING PROCESS 1. Open the remote battery cover and install 12V1pcs battery and set the code switch, with the fan power off. 2. The first time use, within 30 seconds of turning AC power to the fan, you must use a ball pen or tool to press fan off button about 5 seconds. Once the receiver has detected the frequency, the receiver will make light flicker once and turn off. If just replace batteries, no need to re-learn. 2. Please note that the transmitter can learn in multiple receiver, when doing learning process please make sure not learn in other receiver. Light function switch For fans with dimmable bulbs, slide the Light Function switch (O/D) to the position marked D. If you are using non dimmable bulbs slide the Light Function switch to the O position FUNCTIONS OF TRANSMITTER
: Indicator LED will flash as for pressing key LIGHT 1 or LIGHT 2:
Press and release immediately to turn on or off the light. Press and hold over 5 seconds to dim or brighten light to the desired level and release. 4 : Turn on the fan at high speed 3 : Turn on the fan at medium speed 2 : Turn on the fan at low speed 1 : Turn on the fan at lower speed FAN OFF : Turn off the ceiling fan. Installation of Transmitter Wall Mount Holder with two screws To assure continued FCC compliance:
FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
--Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV technician for help. CAUTION:
Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to operate the equipment. FCC IDVHNAC9001TG This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.