FCC ID: 2ADM5-000929 RC FLIP CAR (REMOTE)

8+

Product Overview Instruction Manual Thank you for purchasing the LED Flip Car. This manual provides more information about this RC Car, please read the instructions before using. LED Flip Car Instruction Manual Remote Control Instruction Manual Package Contents LED Flip Car x 1 Remote Control x 1 Instruction Manual x 1 Specifications LED Flip Car Power supply: 4 x AA 1.5V Batteries (Not Included) Remote Power supply: 3 x AAA 1.5V Batteries (Not Included) Frequency: 2.4GHz Remote Standard Control Standard Control Flip Action Note: To avoid losing control, always pay attention when controlling the RC Car. Push Forward Push Left Control LED Flip Car to move forward Control LED Flip Car to turn left Forward / Backward Button Left / Right Button Control LED Flip Car to move backward Control LED Flip Car to turn right Pull Backward Push Right Drive LED Flip Car in front of vertical flat surface, Keep Pressing Forward Button, LED Flip Car will perform 360 Flip Stunt!

Power On/Off Batteries Installation Batteries Installation Performance Tips Warning FCC Statement Power On / Off OFF ON Power On/Off Slide the ON/OFF Switch to ON to turn on the LED Flip Car. Slide the ON/OFF Switch to OFF to turn off the LED Flip Car. To install batteries into the LED Flip Car, unscrew the screws on the battery box cover to open the cover. Insert 4 x AA 1.5V batteries (Not Included) into the battery box. Batteries should be placed as shown on the diagram. Replace the battery box cover and tighten the screws. To install batteries into the LED Flip Car Remote, unscrew the screw on the battery box cover to open the cover. Insert 3 x AAA 1.5V batteries (Not Included) into the battery box. Batteries should be placed as shown on the diagram. Replace the battery box cover and tighten the screw. Notice:

When inserting the batteries, you must insert according to the correct polarity, the LED Flip Car wont function if batteries are reversed. Notice:

When inserting the batteries, you must insert according to the correct polarity, the LED Flip Car Remote wont function if batteries are reversed. 1. Do not drive the LED Flip Car on grass, sand or go through water. 2. Do not drive the LED Flip Car in windy or rainy weather. 3. Do not drive the LED Flip Car into any sharp object. 4. Keep fingers, hair and loose clothing away from LED Flip Car. This product is suitable to be used by people who has operating experience in remote toy or aged no less than 8 years old. Please do not put the product in your mouth to prevent choking hazard of small parts. Care and Maintenance Always use dry and soft cloth to clean this product. Avoid this product from being exposed to sunlight or heat. Please do not put the finger into available interspaces. Please do not play the product in a brutal way such as throwing, crashing or twisting it. Please store the smaller-sized product accessories in places that are out of reach of children, in order to avoid the occurrence of accidents. Avoid immersing these toys in water, otherwise, the electronic parts may be damaged. Avoid placing the batteries in places in high temperatures and avoid exposure to heat. This device complies with the part 15 of the FCC rules. Operation is subject to the following two conditions:(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Caution: changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Check the product regularly. If any damages are discovered, please stop using immediately, until it is completely repaired in good working condition. When young children are operating the product, it shall be ensured that the adults are guiding and making sure the product control is within the viewing range of the controller (or instructor) so that it makes the control of the toy more convenient. Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. IMPORTANT: BATTERY INFORMATION When the product is not in use, please switch off the power supplies of the toy, and remove the batteries from the product. RF warning statement:

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. CAUTION:

1. TO AVOID BATTERY LEAKAGE a. Always follow the instructions carefully. Use only batteries specified and be sure to insert them correctly by matching the + and - polarity markings. b. Do not mix old batteries and new batteries or standard (carbon-zinc) with alkaline batteries. c. Remove exhausted or dead batteries from the product. d. Remove batteries if product is not to be played with for a long time. e. Do not short-circuit the supply terminals. 2. Should this product cause, or be affected by local electrical interference, move it away from other electrical equipment.Reset ( switching ON&OFF again or removing and re-inserting batteries) if necessary. Please note that we wont take any responsibility for any wrong operation as this may result in severe injury or loss of property, and we cannot control the operating process during the time when the user assembles or uses this product. FCC ID: 2ADM5-000929 ITM1901-000929 Once this product is sold, we wont be responsible for any safety responsibility during the time the user operates or uses controls this products. 0-3 F19 Distributed by:

1007B, 10th Floor Exchange Tower, 33 Wang Chiu Road, Kowloon Bay, Hong Kong, China MADE IN CHINA Keep All Relevant Information for Future Reference

EXHIBIT A - FCC ID LABEL AND LOCATION FCC ID Label FCC ID Label Location Information The label shown shall be permanently affixed at a conspicuous location on the device and be readily visible to the user at the time purchase (Labeling requirements per 2.925)

The equipment under test (EUT) is a 2.4GHz transceiver with 25 channels operating at 2410 - 2473 MHz. It is powered by 4.5V DC (3*AAA batteries). Channel List:

2410 2414 2415 2417 2418 2419 2421 2426 2429 2430 2433 2434 2439 2441 2442 2446 2450 2458 2462 2464 2465 2466 2469 2470 2473 Modulation Type: GFSK Antenna Type: Integral antenna TX FUNCTION:

The functions of TX main ICs are mentioned as below.

IC1 acts as MCU for system and gaming control and 2.4GHz RF module. IC2 acts as power regulator.

Zeeva Int Suite 100 Road, Ko Tel: +852 E-mail: a ternational Lim 07B 10th Floo owloon Bay, H 2-2868 0511 |

akshay.butan mited r, Exchange T Hong Kong Fax: +852-25 ni@zeeva.c 524 1986 com Tower, 33 Wa ang Chiu FCC C Author rization 05/2019 DERAL CO thorization a 5 Oakland M umbia, MD OMMUNICA and Evaluat Mills Road D 21046 ATIONS C tion Divisio COMMISSIO on ONS bject: Agent t Authorizat tion whom it ma ay concern:

, Zeeva Inte mpliance La lication for hese matters behalf shal ernational L aboratories Equipment s. All acts c l have the s Limited the u Corporation t authorizati carried out b same effect undersigned n to act on i ion, includin by Bay Area as our own d, hereby au its behalf in ng the signi a Complian action. uthorize Bay n all matters ing of all do nce Laborato y Area relating to ocuments re ory Corpora elating ation on

, the unders signed, here t includes FC CC benefits U.S.C. 862. eby certify th s, pursuant t hat we are n to Section 5 not subject t 5301 of the to a denial o Anti-Drug of federal b Abuse Act enefits, of 1988, s authorizat tion is valid d until furthe er written n otice from t the applican nt. cerely Your rs, nature:

nted Name:

e: Vice Pr FR-170-B Akshay P B resident Butani 10/0 FED Aut 743 Colu Sub To w We, Com app to th our We, that 21 U This Sinc Sign Prin Titl QA-F