FCC ID: 2ADM5-EP-0701 TWS AUTO SENSOR BEAN BLACK

Date: OCT 24 2023 Product: EP-0701 IM Size: 222.75(W) x 105(H)mm ZEEVA INTERNATIONAL FRONT SIDE BASS JAXX SLEEK WIRELESS EARBUDS INSTRUCTION MANUAL Thank you for purchasing the Sleek True Wireless Earbuds. This manual provides more information about the wireless earbuds, please read the instructions before using. Product Overview 1. USB Type-C Charging Port 2. Auto Lifting Sensor 3. Charging Case LED Indicator 4. Earbuds LED Indicator 5. Touch Control On/Off Button/ Play/ Pause Music/ Answer/End Call 6. Built-in Microphone Package Contents 1(One) Pair Earbuds 1.29in. x 0.67in. x 0.73in. (3.3cm x 1.7cm x 1.9cm)each 1(One) Portable Charging Case 2.93in. x 2.22in. x 1.09in. (7.4cm x 5.6cm x 2.8cm) 1(One) USB Type-C Charging Cable 11.8in. (30cm) 1(One) Instruction Manual Specifications Driver Diameter: 10 mm Impedance: 32 Ohms Frequency Response: 20 Hz - 20 kHz Sensitivity: 96 dB +/- 3 dB Power Supply: Li-ion Battery 3.7V 35 mAh Per Earbud Playtime: 10 Hours Charging Time: 2 Hours Bluetooth Range: 32.8 Feet Bluetooth Version: 5.3 Charging Case Battery Capacity: 300 mAh USB Type-C Charging Cable Included USB Type-C Charging Cable Rating 5V/1A Max. Open/ Close Main Compartment Double tap Auto Lifting Sensor (2) to open main compartment automactically. Double tap Auto Lifting Sensor (2) to close main compartment automactically. Z\ WARNING: Do not put your finger in the Main Compartment during closing. Note:

Holding the lower part of the charging case during open or close the main compartment. Do not block the main compartment. Do not push or pull the main compartment. Power On/Off Power On Press and hold down the ON/OFF Button of earbuds for 3 seconds and the LED will flash. Power Off Press and hold down the ON/OFF Button of earbuds for 4 seconds and the LED will turn off. Pair the wireless earbuds with your mobile device 1. Keep the distance between the earbuds and mobile device within 32.8 feet. 2. De-activate the Bluetooth function on your mobile device. 3. Put the earbuds into the charging case before use. Take both earbuds out from the charging case and wait for 3 to 5 seconds for auto pairing. The earbud has indicator blinking in Red and Blue. Another earbud will stop blinking when auto pairing is done successfully. 4. Activate the Bluetooth function on your mobile device and select EP-0701 TWS from the list shown. 5. After pairing is successful, both earbuds LED will stop blinking.

*Attention: If the auto pairing is not successful, manual pairing between earbuds is essential by following below procedures:

1. Make sure the earbuds are charged. 2. De-activate the Bluetooth function on your mobile device. (if you had been paired the earbuds to some other mobile device(s) nearby, please sure to de-activate those device(s) too). 3. Power on both earbuds simultaneously by pressing the ON/OFF buttons for 3 seconds and wait for 3 to 5 seconds for auto pairing. (Keep the Bluetooth function off on your mobile device before this operation.) 4. Activate the Bluetooth function on your mobile device and select EP-0701 TWS" from the list shown. 5. After pairing successfully, both earbuds LED will stop blinking. Reconnect the wireless earbuds to your mobile device When powered on, the wireless earbuds will automatically connect with the last successfully paired device. BACK SIDE Disconnect the wireless earbuds from your mobile device Power off the wireless earbuds; or Switch off the Bluetooth on your mobile phone; or Leave the earbuds 60ft away from your mobile phone or further. Answer / Reject a call When receive a call, press the ON/OFF Button once ( on either earbud) to accept the call, or answer the call normally via your mobile phone. Press and hold 2 seconds to reject it. End a call To end the call, just press ON/OFF button at any side of earbud with Beep sound to end it. Functions Pause / Play Music: Short Press on ON/OFF Button Go back to previous song: Double click left ON/OFF button. Advance to next song: Double click right ON/OFF button. Voice Assistant: Press and hold ON/OFF button for 2 seconds. Charging your Earbuds 1.Double tap to open the main compartment. 2.Insert the Earbuds into the charging case. 3.The earbuds will start the charge automatically. 4.LED indicator light of the Earbuds will be turned on when charging. 5.Once fully charged, the LED will be off. Note: If the charging is not start, take out both earbuds from the charging case and insert again after few seconds. Recharge Charging Case A For your safety, please always use appropriate 5V output charger/Adapter to charge the product. DO NOT USE Quick Charging USB Adapter to charge the product, as it might damage the product. 1. Double tap to close the main compartment. 2. Use the USB Type-C charging cable provided with the packaging. 3. Connect the USB plug to a USB port on a computer or wall adapter, then connect the USB Type-C plug to the USB Type-C charging port on the charging case to begin charging 4. The Charging Case LED Indicator will be flashing in Red during charging. 5. Once fully charged, the Charging Case LED Indicator will stop flashing. 6. The Charging Case LED Indicator will be flashing in Blue during the earbuds are charging and will be off after fully charged.

*Make sure the main compartment is closed before charging. NOTE:

+ You must select a qualified charger from a regular manufacturer.

+ You must charge the charging case and earbuds if it has been not used for more than 6 months. Ly USB Plug Z|

USB Type-C Plug A\ CAUTION: The USB Type-C charging cable included with this item is intended for use with this product. Only use the included USB Type-C charging cable to charge this product. FAQ If the wireless earbuds cannot be paired with your device, please try the following:

Ensure that your earbuds are in pairing mode or reconnection mode Ensure that Bluetooth search function of your mobile device is activated. If the wireless earbuds will not turn on:

Make sure the earbuds are fully charged. Can | change the battery for the earbuds and the charging case?

The wireless earbuds and the charging case use a built-in non-detachable battery which cannot be removed. If the charging case cannot be recharged:

If you use a power outlet, ensure that the power supply is connected securely and the outlet works. If you use a computer, ensure that it is connected and the USB port is powered. A Safety instructions for the lithium battery and charging the product

-The input voltage to the product is 5V 1A.

-In order to charge the product in safe manner and reliable conditions, please only adopt certified appropriate charger/ adapter for charging the product.

-Only charge the product at ambient temperatures between 10 C/ 50 F and 40 C/104 F.

- Do not heat above 70 C/158 F, eg. Do not expose to sunlight or throw into fire.

-Switch off the product after use.

-Please note that we won't take any responsibility for any wrong operation (eg. Voltage higher than 5V) as this may result in severe injury or loss of property, and we cannot control the operating process during the time the user using this product.

-In extreme cases, abuse or misuse of Lithium battery pack can lead to explosion, heat generation, fire development or smoke development. FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference.

(2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help. RF warning statement:

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by 1616 Holdings, Inc. is under license. Other trademarks and trade names are those of their respective owners. FE FCC ID: 2ADMS5-EP-0701 Keep all relevant information for future reference ITEM# EP-0701 Distributed by 1616 Holdings, Inc. 701 Market Street, Suite 200 Philadelphia, PA 19106 Made in China

EP-0701 Batch Print Ke Battery Capacity(Earbuds):

Battery Capacity(Charging Cas FCC ID: 2ADM5-EP-0701 Batch: ZE112523 Input: DC5V/1A Made in China BIKA 3.7V 35mAh ion 3.7V 300mAh RAEI OCT 05 2023 PO#5870: ZE112523 PO#5892: ZE122323 FCC ID: 2ADMS-EP-0701 FC Batch: ZE112523 Input: DCSV/1A Battery Capacity(Earbuds): Li-ion 3.7V 35mAh Battery Capacity(Charging Case): Li-ion 3.7V 300mAh Made in China

2023.11.08 Zeeva International Limited Suite 1007B, 10th Floor, Exchange Tower, 33 Wang Chiu Road, Kowloon Bay, Hong Kong, China RE: LETTER OF AGENT AUTHORIZATION To Whom It May Concern:

We, the undersigned, hereby authorize Sam Lv at EMTEK(DONGGUAN) CO., LTD. to act on our behalf in all matters relating to application for equipment authorization, including the signing of all documents relating to these matters. We also hereby certify that no party to the application authorized hereunder is subject to the denial of benefits, including FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C.853(a). This agreement expires one year from the current date. Sincerely, KEVIN TSO

Zeeva International Limited 2023.11.08 Eurofins Electrical and Electronic Testing NA, Inc. 914 West Patapsco Avenue Baltimore, MD 21230 RE: Attestation Statements Part 2.911(d)(5)(i) request for FCC ID2ADM5-EP-0701 Zeeva International Limited certifies that the equipment for which authorization is sought is not covered equipment prohibited from receiving an equipment authorization pursuant to section 2.903 of the FCC rules. Sincerely,

(Applicant signature) KEVIN TSO Zeeva International Limited 2023.11.08 Eurofins Electrical and Electronic Testing NA, Inc. 914 West Patapsco Avenue Baltimore, MD 21230 RE: Attestation Statements Part 2.911(d)(5)(ii) request for FCC ID2ADM5-EP-0701 Zeeva International Limited certifies that, as of the date of the filing of the application, the applicant is not identified on the Covered List as an entity producing covered equipment. Sincerely,

(Applicant signature) KEVIN TSO

2023.11.08 Eurofins Electrical and Electronic Testing NA, Inc. 914 West Patapsco Avenue Baltimore, MD 21230 RE: CONFIDENTIALITY REQUEST FOR

Product Name TWS AUTO SENSOR BEAN BLACK Model Number EP-0701 FCC ID Prepared for Address 2ADM5-EP-0701

: Zeeva International Limited

: Suite 1007B, 10th Floor, Exchange Tower, 33 Wang Chiu Road, Kowloon Bay, Hong Kong, China

) To Whom It May Concern:

This letter serves as an official request for confidentiality under sections 0.457 and 0.459 of CFR 47. We have requested that the (Block Diagram, Schematics, Operational Description) required to be submitted with this application be permanently withheld from public review. SPECIFY REASON FOR REQUEST (The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these materials may be harmful to the applicant and provide unjustified benefits to its competitors.) Please contact me if there is any information you may need. Sincerely, KEVIN TSO

Zeeva International Limited Suite 1007B, 10th Floor, Exchange Tower, 33 Wang Chiu Road, Kowloon Bay, Hong Kong, China Date: [2023.11.01]

Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 FCC ID: 2ADM5-EP-0701 FRN: 0024102113 US Agent Attestation Statement / Part 2.911(d)(7)

[Zeeva International Limited] certifies, that as of [2023.11.01], we have designated FCC US Agent, LLC to accept service of process on our behalf for FCC ID: 2ADM5-EP-0701

[Zeeva International Limited], accepts to maintain an agent of service of process in the United States for no less than one year after her the grantee has permanently terminated all marketing and importation of the applicable equipment within the U.S., or the conclusion of any Commission-

related administrative or judicial proeitceeding involving the equipment, whichever is later. FCC US Agent, LLC, accepts as of the date of the filing of this application, the obligation of being the designated agent for the purpose of accepting service of process on behalf of [Zeeva International Limited] for FCC ID: 2ADM5-EP-0701 Designated Agent Information:

Company Name: FCC US Agent, LLC FRN: 0033402884 Address: 3722 Illinois Avenue, Saint Charles, IL, 60174, USA Contact Person: Tim Payne Phone: 708-571-3148 Email: Support@FCCUSAgent.com Sincerely, Company: [Zeeva International Limited]

Company Representative: [Kevin Tso]

Signature: [Signature]

Designated Agent: FCC US Agent, LLC Designated Agent Representative: Tim Payne Signature: