Adding Alarm Sensor Installing Camera About the Guide
- This quick start guide is for reference only. Minor difference might be found in user interface.
- All the design and software here are subject to change without prior written notice.
- All trademarks and registered trademarks mentioned are the properties of their respective owners.
- Please visit our website or contact your local service engineer for more information.
- If there is any uncertainty or controversy, please refer to our final explanation. Step 4 Wait for booting to be finished, and then the camera indicator flashes with green light. Step 5 Connect your smart phone to your Wi-Fi network, and make sure your smartphone is connected to Wi-Fi network with 2.4 GHz band, and then do the following operations to finish adding camera. Note:
If you have more than one camera, do step 5 to add them one by one. If the Wi-Fi network has changed or the indicator status goes wrong, reset the camera, and then do step 5 to add it again. Note:
-
The alarm sensor is not included by default; you need to purchase it separately if necessary. There are two ways to add alarm sensor.
-
Method 1 Step 1 Press camera reset/pair button for 2 s to enter pairing mode, and then the green light flashes. Step 2 Press the pair button of alarm sensor and the indicator light will flash quickly and continuously. Step 3 The green light of camera will stop flashing if pairing succeeds; the red light will flash if pairing fails. Method 2 Scan the QR code on the sensor with Imou App, and then follow the app guide to operate. Make sure the mounting surface is strong enough to hold at least three times of the device weight. Step1 Drill screw holes on the mounting surface as the positioning plate shows, and then put in the expansion bolts. Step2 Attach the mounting plate to the mounting surface with the self-tapping screws. Step3 Attach the camera to the mounting plate, then power it up, and then, adjust the lens to the ideal angle. Mounting Surface Positioning Map Expansion Bolt Mounting Plate Self-tapping Screw Camera Camera Introduction Quick Start Guide Version 1.0.0 Camera 1 Power Cable 1 Power Adapter 1 QSG 1 Screw Package 1 Mounting Plate 1 Lens Built-in Mic Positioning Map 1 Micro SD Card Slot Power Port Built-in Speaker Ethernet Port Reset/Pair Button Note:
Press the reset/pair button to enter pairing mode. Press and hold the reset/pair button for 10 s to reset the camera. The pattern of the LED indicator is included in the following table. LED Indicator Status Off Red light on LED Indicator Green light flashing Green light on Red light flashing Green and Red light flashing alternately Device Ststus Powered off/LED turned off Rebooting after reset Booting Device malfunction Waiting for network Enter pairing mode Operating properly Network connection failed Pairing failed Firmware updating With Imou App Operating Step 1 Scan the following QR code or search Imou in Google Play or App Store to download and install Imou App. Note: If you have installed the App, update it to the latest version. Step 2 Run Imou App, and then register an account for the first use. Step 3 Connect the camera to power source with the power adapter.