DC-NXU-6101-A AWARNING APPLICATION and PERFORMANCE SPECIFICATION HAZARDOUS VOL TAGE DISCONNECT ALLINPUT POWER FORE INSTALLING OR MAINTAINING Description: Electronic fluorescent ballast for Lamp (2)
+ Line Voltage: 120Vac,60Hz. * Rapid-Start
* Low Power Factor * Lamp Connection:2 Lamps In Paratlel
*Endosed fodure: watlage may change depending on fiture type Application and Performance Specification Information Subject to Change without Notification Performance:
+ Operating Frequenoy Range:20-35kHz
* Abnormal protection Circuit
* Auto-Reset Shutdown Circult
-lamp(s)should be replaced at end of lamp life
- Lamp relights upon insertion in socket Application: Physical Parameters
* Minimum Starting Temperature: 5 F (-15C)
*MaximumAmbient Temperature: 122 F (50C) Overall Length(L): 3.78 *( 96 mm)
+ Maximum Case Temperature(@tc): 167 F (75C) Width(W): 2.8(71mm)
* Sound Rated: A Mounting(M): 3.35"(85mm) Height(H): 1.26 *(32mm) Weight: 0.43 Ibs(0.195kg) 4 1 ne Install in accordance with local electrial code. Ballast must be grounded. Performance and characteristic:
Can work oroperly in range 130-280V High power,can sane electricity 30%, last 8000 hours. No flash or noise,perform stably. Apply anti-interfernce to TV set and radio. Not suitable dank, flammability explosive,site suing. Accensione immediata. Made in China Electronic ballast installation menu AWWARNING HAZARDOUS VOL TAGE DISCONNECT ALLINPUT POWER BEFORE INSTALLING OR MAINTAINING 1, Make sure input wire s location and then fix the ballast by using the 4mm screws 2. After the ballast is fixed please rfer to wire drawing on the label.Connect the output wire to the lamp hoklderacc ording to the wire drawing on the label. 3. After the lamp holder is connected and fixed connect the white wite from the ballast to the white wire from thewiring box, Connect the black wire from the ballast to thblack wire from the wiring box, Connect the ground wirefrom the fixture to the ground wire from the wiring box. Name:Electronic Ballast Model: DC-NXU-6101-A This device compiles with Part 18 of the FCC Rules This product may cause interference to radio equipmet and should not be installed near maritime safety communications equipment or other critical navigation or communication equipment operating between 0.45-30Mhz. This equipment has been tested and found to comply with part 18 of the FCC Rules. These limits are designed to provide rea sonable protection against harmful interference in a residential installation. This equipment generates ,usea and can radiate radio frequmency energy and,if not installed and used in accordance with the instructions,may cause harmful interference to radio communications, However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,the user is encouraged to try to correct the interference by one or more of the following measures Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. NOTE: The manufacturer is not responsible for any interference caused by unauthorized.modifications to this equipment.Such modifications conld void the User's authority to operate the equipment. Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. NOTE: The manufacturer is not responsible for any interference caused by unauthorized modifications to this equipment .Such modifications conld void the User's authority to operate the equipment.