1)Please take off shoes and socks and keep your bare feet in touch with the electrodes when taking Body Weight, BMI, BFR, Muscle, Moisture, Bone mass, BMR, Visceral fat, Protein rate, Body age, Standard weight, Body Fat measurement. 2).Please check the batteries if the scale malfunctions. Change new batteries if necessary. 3).Please use soft tissue with alcohol or glass cleaner to clean the surface if it is dirty. No soap or other chemicals. Keep it away from water, heat and extreme coldness. 4).The scale is high precision measuring device. Never jump or stomp on the scale or disassemble it and please handle it carefully to avoid breaking when moving it. 5).The scale is for family use only and not suitable for professional use. Body Weight, BMI, BFR, Muscle, Moisture, Bone mass, BMR, Visceral fat, Protein rate, Body age, Standard weight, Body Fat measured are for reference only. You should consult a doctor when you undertake any diet or exercise program. Caution: Slippery when wet ! The scale platform maybe pretty slippery when wet, thus please make sure both the scale platform and your feet are dry before use. Never step on the scale platform with wet foot After the connection is successful, click "Done"
to go to the user selection interface. When the measurement is completed on the device, this interface will display a weight data. Click on" claim" to get your full measured body data. Click to select the user. Set the user's personal information and save your information. Remark:Please kindly fill in the true height, age and gender. Otherwise, the measured data will not be accurate. Click on the" data detail" in the lower left corner to browse to your comprehensive body detail as picture.
weight unit :kg/lb/st If users want to change units, please click <Set up>--<Unit switching> to select
the LED will indicate Err, when scale is over max capacity. Please remove the weight to avoid any damage. Unit button What if the WiFi indicator doesn't flash when the device is connected?
Press the Reset Unit button (Pictured above) for several seconds until Smart body fat scale displays the icon on the right Low Battery : The LED will indicate Lo , Please open the battery cover and replace the new battery with correct way. Faulty Measurement:
Measurement fail indicatesErr1, for below 2 conditions:
1.Body fat percentage is less 5% or over 50%, 2.Unsuccessful test
A.How to measure Body weight If you dont connect WIFI, then stand on the scale, the scale will only measure your body weight. Please follow
1)Please use the scale on the hard & flat surface. Dont use on the carpet or soft surface. 2)Carefully step on the platform of the scale. Stand as stationary as possible until the weight reading is shown and locked on the LED 3)The scale will be automatically off if without further operation FCC Caution This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.