Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
ONN Wireless Mouse
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Radiation Exposure Statement:
The product comply with the FCC portable RF exposure limit set forth for an uncontrolled environment and are safe for intended operation as described in this manual. The further RF exposure reduction can be achieved if the product can be kept as far as possible from the user body or set the device to lower output power if such function is available. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. PRODUCT GUIDE BATTERY WARNING STATEMENT Wal-Mart Stores,|nc., Do not mix old and new batteries. Bentonville, AR 72716 Do not mix alkaline, standard (carbon-zinc), Hotline: 1-800-925-6278 CAUTION: To use this product properly, please read the user's guide before installation or rechargeable (ni-cad, ni-mh, etc) batteries. Ver.01 Rev.10/25/19 Ver.01 Rev.10/2519 Functional Introduction AAA Battery Setup the Connection between the Receiver and the Mouse 1. Insert the batteries into the mouse, then follow the steps below. 2. In the meantime, to open the mouse under the cover, take the nano 1. Left button 7. Battery cover receiver out. 2. Right button 5. Backward 8. Connect button 3. Plug the Nano receiver into the USB port on your computer. 3. Scrolling wheel 6. Nano receiver 9. OFF/ON switch 7 Forward Press this button to view the next page in your Internet browser. Backward Press this button to view the previous page in your Internet browser. 4. If the mouse does not work, please put it into pairing mode. 5. Pairing: Re-plug the receiver into the USB port on your computer, then press the connect button on the mouse. If the mouse does not work after 10 seconds, pair them again. Keep the mouse closer to the Step 1: Take the battery cover off. receiver while in pairing mode. Step 2: Insert the batteries as shown inside the battery compartment. @
Step 3: Replace the cover. LED Indicator Red LED is on for 10 Sec. Ye Installing the batteries
\ Power On
+ ina:
Warning: Red LED Blinking for 10 Sec.
*Please insert the battery with the correct position according to the instruction Low Battery Warning Me labeled on the mouse. Red LED Blinking Pairing (LED OFF when paired or failed after 10 sec.) Ver.01 Rev.10/25/19 Ver.01 Rev.10/2519