Wireless Room Sensors for M5 and M5 Classic Smart Thermostats RC7189WS1000 Quick Start Guide 2X AAA (1.5 V each) per sensor 2X AAA (1.5 V chaque) par dtecteur 2X AAA (1.5 V cada una) por sensor Dtecteurs de pice sans l pour thermostats intelligents M5 et M5 Classic RC7189WS1000 Guide de dmarrage rapide Sensores inalmbricos de habitacin para los termostatos inteligentes M5 y M5 Classic RC7189WS1000 Gua de inicio rpido www.resideo.com Resideo Technologies, Inc. 1985 Douglas Drive North, Golden Valley, MN 55422 1-800-633-3991 33-00503EFS07 M.S. 03-20 | Printed in United States 2020 Resideo Technologies, Inc. All rights reserved. The Honeywell Home trademark is used under license from Honeywell International, Inc. This product is manufactured by Resideo Technologies, Inc. and its affiliates. Tous droits rservs. La marque de commerce Honeywell Home est utilise avec lautorisation dHon-
eywell International, Inc. Ce produit est fabriqu par Resideo Technologies, Inc. et ses socits affilies. Todos los derechos reservados. La marca comercial Honeywell Home se utiliza bajo licencia de Honeywell International, Inc. Este producto es fabricado por Resideo Technologies, Inc. y sus afiliados. 33-00503EFS-01 Getting Started - Read before installing. To link the sensor to the thermostat please follow the steps below on the thermostat. 1 2 3 Open the Menu Tap Devices &
Tap Add Sensors 4 Follow the on-screen instructions Placement Tips DO place about 5 feet above the oor. DO place on inside walls. DONT place behind furniture or doors. DONT place in direct sunlight. DONT place above air vents. 5ft 1.5m The operation of this equipment is subject to the following two conditions: (1) this equipment or device may not cause harmful interference, and (2) this equipment or device must accept any interference, including interference that may cause undesired operation. Dmarrage - Lire avant linstallation. To link the sensor to the thermostat please follow the steps below on the thermostat. 1 2 3 Ouvrez le menu. Appuyez sur Devices & Sensors
(Appareils et dtecteurs). Appuyez sur Add (Ajouter). 4 Veuillez suivre les directives lcran. Conseils pour le positionnement Placer environ 1,5 m (5 pi) du plancher. Placer sur un mur intrieur. NE PAS placer derrire un meuble ou une porte. NE PAS placer directement au soleil. NE PAS placer prs de bouches dair. 1,5m 5 pi Lutilisation de cet quipement est soumise aux deux conditions suivantes : (1) cet quipement ou cet appareil ne peut pas causer dinterfrences dangereuses, et (2) cet quipement ou cet appareil doit accepter toute interfrence reue, notamment les interfrences lorigine dun fonctionnement indsirable. Inicio - Leer antes de instalar. Para enlazar el sensor al termostato favor de seguir los siguientes pasos en el termostato. 1 2 3 Abra el men Toque Devices &
Toque Add Sensors
(Aadir).
(Dispositivos y sensores) 4 Siga las instrucciones en la pantalla Ayuda para la ubicacin COLOQUE a unos 1.5 metros (5 pies) del piso. COLOQUE en las paredes interiores. NO coloque detrs de muebles o puertas. NO coloque a la luz solar directa. NO coloque sobre ventilaciones de aire. 5ft 1,5m La operacin de este equipo est sujeta a las siguientes dos condiciones: (1) es posible que este equipo o dispositivo no cause interferencia perjudicial y (2) este equipo o dispositivo debe aceptar cualquier interferencia, incluyendo la que pueda causar su operacin no deseada. FCC Regulations 15CThis device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the manufacturer could void the users authority to operate the equipment. The antenna(s) used for this transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
(15B)This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. FCC RF Exposure Intormation This device complies with FCC RF radiation exposure limits set forth for an uncontrolled enviroment. The antenna(s) used for this transmitter must not be co-located or operating in conjunction with any other antenna or transmitter and must be installed to provide a separation distance of at least 20cm from all persons. Canada Regulations:
This device complies with Industry Canadas licence-exempt RSSs. Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation of the device. Le prsentappareilestconforme aux CNR dIndustrie Canada applicables aux appareils radio exempts de licence. Lexploitationestautorise aux deux conditions suivantes :
(1) lappareil ne doit pas produire de brouillage;
(2) lutilisateur de lappareildoit accepter tout brouillageradiolectriquesubi, mmesi le brouillageest susceptible dencompromettre le fonctionnement. This transmiter must not be co-located or operatng in conjuncton with any other antenna or transmiter. This equipment should be installed and operated with a minimum distance of 20 centmeters between the radiator and your body. Cet meteur ne doit pas tre Co-plac ou ne fonctonnant en mme temps quaucune autre antenne ou meteur. Cet quipement devrait tre install et actonn avec une distance minimum de 20 centmtres entre le radiateur et votre corps.