Table of Contents Whats in the Box Whats Required for Installation?
Installation Replacing the Power Connector Notice Customer Service 02 02 03 03 05 07 WHATS IN THE BOX INSTALLATION Step 1. Fix the Power Connector to the Doorbell Chime. A. Place the Power Connector over the Chime in the direction the arrows indicate. B. Align the raised slots of the Power Connector with the notch on the base of the Doorbell Chime. C. Rotate clockwise to lock the Power Connector in place. Doorbell Chime Power Connector Model: T8740
(Pin type may vary in different regions) Doorbell Chime USB Dongle for HomeBase 2 Model: T8741 WHATS REQUIRED FOR INSTALLATION?
This Doorbell Chime is an accessory exclusive to the eufy Security Video Doorbell 2K
(Battery-Powered). The USB dongle enables eufy HomeBase 2 to connect to doorbell chimes. One USB dongle can control up to 4 doorbell chimes. The USB dongle can only work with HomeBase 2 when a eufy video doorbell is connected to this HomeBase 2 and the doorbell is pressed. Step 2. Plug the Doorbell Chime into an AC power supply at your desired location. Step 3. Plug the USB dongle into the USB port on the back of the HomeBase 2. 01 English Step 4. In the eufySecurity App, go to Doorbell Settings - Indoor Chime. Follow the onscreen instruction to add the Chime to your existing Video Doorbell. English 02 Step 5. You may select the ringtone and adjust the volume level by using the Music and Volume buttons located on the side of the Doorbell Chime. There are 8 ringtones and 3 volume levels selectable. Each Chime can play a different ringtone according to your setting. NOTICE This product complies with the radio interference requirements of the European Community. Declaration of Conformity Hereby, Anker Innovations Limited declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU.For the declaration of conformity, visit the Web site https://www.eufylife.com/. Do not use the Device in the environment at too high or too low temperature, never expose the Device under strong sunshine or too wet environment. The suitable temperature for the product and accessories is 0C - 45C. RF exposure information: The Maximum Permissible Exposure (MPE) level has been calculated based on a distance of d=20 cm between the device and the human body. To maintain compliance with RF exposure requirement, use product that maintain a 20cm distance between the device and human body. 433MHz Frequency Range:433.92MHZ;433MHz Max Output Power:7.303dBm The following importer is the responsible party (contact for EU matters only) Importer: Anker Technology (UK) Ltd Importer Address: Suite B, Fairgate House, 205 Kings Road, Tyseley, Birmingham, B11 2AA, United Kingdom This product is designed and manufactured with high quality materials and components, which can be recycled and reused. This symbol means the product must not be discarded as household waste, and should be delivered to an appropriate collection facility for recycling. Proper disposal and recycling helps protect natural resources, human health and the environment. For more information on disposal and recycling of this product, contact your local municipality, disposal service, or the shop where you bought this product. FCC Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. English 04 REPLACING THE POWER CONNECTOR 1. Press the Lock button and twist the Power Connector counterclockwise at the same time to remove it from the Doorbell Chime base. 2. Install the new Power Connector onto the Doorbell Chime following the same procedure mentioned at the start of the guide. 03 English Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: (1) Reorient or relocate the receiving antenna. (2) Increase the separation between the equipment and receiver. (3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. (4) Consult the dealer or an experienced radio/TV technician for help. FCC Radio Frequency Exposure Statement The device has been evaluated to meet general RF exposure requirements. The device can be used in fixed / mobile exposure condition. The min separation distance is 20cm. The following importer is the responsible party Company Name: POWER MOBILE LIFE, LLC Address: 400 108th Ave NE Ste 400, Bellevue, WA 98004-5541 Telephone: 1-800-988-7973 This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device."
Le prsent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux conditions suivantes:
(1) l'appareil nedoit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en compromettre le fonctionnement."
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. CUSTOMER SERVICE Warranty 12-month Limited Warranty Call Us United States +1 (800) 988 7973 Mon-Fri 9AM-5PM (PT) United Kingdom +44 (0) 1604 936 200 Mon-Fri 6AM-11AM (GMT) Germany +49 (0) 69 9579 7960 Mon-Fri 6:00-11:00 Email Us Customer Support: support@eufylife.com Anker Innovations Limited Room 1318-19,Hollywood Plaza,610 Nathan Road,Mongkok,Kowloon,Hong Kong 05 English English 06