FCC ID: H8N-ASK-NCM1100E 5G NR Sub 6 WiFi 7 Router

44.3 90.45 MODEL/SKU: ASK-NCM1100E ICCID: 12345678901234567890 SN: XXX10700001 IMEI: 350627350000010 ITE, 188325 Designed in New York Made in Vietnam Factory ID: 7 Rating: 12V === 5A FCC ID: H8N-ASK-NCM1100E Indoor Use Only

[ Letter Head]

Date: December 12, 2023 TO:

Federal Communication Commission Equipment Authorization Branch 7435 Oakland Mills Road Columbia, MID 21046 Regarding FCC ID: H8N-ASK-NCM1100E To whom it may concern:

We, the undersigned, hereby authorize Jim Chang, SGS Taiwan Ltd. to act on our behalf in all manners relating to application for equipment authorization with respect to the FCC ID above, including signing of all documents relating to these matters. Any and all acts carried out by the agent on our behalf shall have the same effect as acts of our own. We, the undersigned, hereby certify that we are not subject to a denial of federal benefits, that includes FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C. 862. Further, no party, as defined in 47 CFR 1.2002 (b), to the application is subject to denial of federal benefits, that includes FCC benefits. We also declare that the information provided to the FCC is true and correct to the best of our knowledge

(47 CFR 2.911(d)) and we have been informed of the grantee responsibilities (47 CFR 2.909) with regard to certified equipment. This authorization is valid until further written notice from the applicant. Sincerely, Signature: ____________________ Printed Name /Title: Jack Po / Director Company Name: Askey Computer Corporation

U.S. Agent for Service of Process Attestation To the attention of Federal Communications Commission Authorization and Evaluation Division U.S. Agent Company Name: Askey International Corp. Contact Name: John Chen Address: 4017 Clipper Court, Fremont CA 94538 Telephone No: (510) 415-2767 Email: john6_chen@askey.com FRN: 0033593484 This letter is to confirm that we have accepted the responsibility to act as the designated U.S. Agent for service of process as required by 2.911(d)(7) on behalf of the Applicant noted below. U.S. Agent Signature: Deus Ch Date: 2023-10-06 Signed by (Printed Name/Title): John Chen / Director Applicant Company name: Askey Computer Corp FRN: 0033533316 FCC ID: H8N Contact Name: Jack Po Street Address: 10F, No. 119, JIANKANG RD. ZHONGHE DIST. City/Province/Zip: New Taipei City, 23585 Country: Taiwan Telephone No: 886 2 2228-7588 #18734 Email: jackpo@askey.com This letter is to confirm that the Applicant has designated the U.S Agent noted above for the purpose of accepting service of process on their behalf as required by 2.911(d)(7). The Applicant further acknowledges acceptance to maintain an agent for no less than one year after the grantee has terminated all marketing and importation or the conclusion of any Commission-related proceeding involving the equipment. Applicant Signature: HQ?

Date: 2023-10-06 Signed by: Jack Po, Manager

[ Letter Head]

Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 USA Date: December 12, 2023 Ref: Attestation Statements Part 2.911(d)(5)(i)&(ii) Filing FCC ID: H8N-ASK-NCM1100E Statement for 47 CFR section 2.911(d)(5)(i)

[Askey Computer Corporation] (the applicant) certifies that the equipment for which authorization is sought is not covered equipment prohibited from receiving an equipment authorization pursuant to section 2.903 of the FCC rules. Statement for 47 CFR section 2.911(d)(5)(ii)

[Askey Computer Corporation] (the applicant) certifies that, as of the date of the filing of the application, the applicant is not identified on the Covered List as a specifically named entity or any of its subsidiaries or affiliates that producing covered equipment. Sincerely, Signature: ____________________ Printed Name /Title: Jack Po / Director Company Name: Askey Computer Corporation

[ Letter Head]

Date: December 12, 2023 Federal Communication Commission Equipment Authorization Branch 7435 Oakland Mills Road Columbia, MID 21046 REQUEST FOR CONFIDENTIALITY - FCC FCC ID: H8N-ASK-NCM1100E Pursuant to Sections 0.457(d) and 0.459 of the Commissions Rules and FCC Guidance document 726920, we hereby request permanent confidential treatment of exhibits identified as such in the table below and request they are permanently withheld from public review based on the documents containing trade secrets and proprietary information not customarily released to the public. The public disclosure of this information might be harmful to the applicant and provide unjustified benefits to its competitors. We also request short-term confidentiality on certain exhibits until the intended date of marketing as outlined below. We request the exhibits be withheld from public view for a period of 180 days. We attest marketing of the product will only commence after the period of short-term confidentiality expires, or if marketing is to commence before the requested number of days listed above, the grantee will inform the TCB to release the Short-Term Confidentiality information withheld on the FCC equipment authorization website. Exhibit Block Diagrams Operation Description Software defined radio & security info Parts List & Placement/BOM Tune-Up Procedure Schematic Diagrams External Photos Internal Photos Test Setup Photos Users Manual Type of Confidentiality Requested Permanent Permanent Permanent Permanent Permanent Permanent

Permanent*

Permanent*

Short Term Short Term

Short Term Short Term Short Term Short Term Short Term Short Term Short Term The asterisked items (*) require further information to be provided in this justification letter before permanent confidentiality will be extended to these exhibits. Please refer to FCC KDB 726920 D01 found at:

https://apps.fcc.gov/oetcf/kdb/forms/FTSSearchResultPage.cfm?switch=P&id=41731 and review section II, 3) regarding specific information that must accompany these requests. Note: any documents held under the Short-Term confidentiality will automatically become public after the requested time if an appropriate extension request has not been received. Any exhibits (i.e., schematic diagrams) that may have already been requested to have Permanent confidentiality as shown above need not be repeated under Short-Term confidentiality request. Sincerely, Signed:

Printed name: Jack Po Title: Director Company Name: Askey Computer Corporation

Referencing Test Data Attestation Letter Dear Examiner Date: December 14, 2023 We, Askey Computer Corporation, declare that the device references the data the following:

Reference Device Variant Device:

Key Difference:

FCC ID:

FCC ID:

1. Removing Bluetooth components. H8N-ASK-NCM1100 H8N-ASK-NCM1100E 2. Adding external dipole antennas for 4GLTE &

5GNR, when using the external antenna, the internal monopole antennas are disabled. 3. Replacing one ethernet chip RTL8221B-VB-

CG (U1201) by RTL8366U to transmit and receive Ethernet packets over RJ45 cable without changing the PCB layout and the product form factors. The referenced device of the above has been granted by FCC. The purpose of this application is to apply the above variant FCC ID via reusing radio parameter test data from the original device per KDB484596 D01. WLAN 2.4GHz FCC Rules Description Of Test 15.207(a) AC Power Line Conducted Emission 15.247(b) (3) Peak Output Power 15.247(a)(2) Emission Bandwidt 15.205 15.209 15.247(d) Radiated & Conducted Band Edge and Spurious Emission 15.247(e) Power Spectral Density Data Referencing Test report number: TERF2310002501E2 N Y Y Y Y Fully tested for changing I/O interfaces Fully leveraged with Spot check worst-case scenarios to demonstrate compliance. Fully leveraged Fully leveraged with Spot check worst-case scenarios to demonstrate compliance Fully leveraged WLAN 5GHz FCC Rules Description Of Test 15.207 15.407(e) 15.407(a) 15.407(a) AC Power Line Conducted Emission Emission Bandwidth Maximum Conducted Output Power Power Spectral Density Data Referencing Test report number: TERF2310002502E2 N Y Y Y Fully tested for changing I/O interfaces Fully leveraged Fully leveraged with Spot check worst-case scenarios to demonstrate compliance Fully leveraged 15.205 15.209 15.407(b) 15.407(c) DFS Master Undesirable Radiated Emissions Transmission in case of Absence of Information Y N Fully leveraged with Spot check worst-case scenarios to demonstrate compliance Verifying to demonstrate compliance FCC Rules Description Of Test 15.407(h) FCC KDB 905462 D02 WLAN 6GHz TPC and DFS Measurement Data Referencing Y Test report number: TERF2310002504E2 Fully leveraged with Spot check 10 trials for the widest BW mode of each radar waveform. FCC Rules Description Of Test Data Referencing Test report number: TERF2310002503E2 15.207 15.407

(a)(10) 2.1049 AC Power Line Conducted Emission Emission Bandwidth 15.407(a)(4~8) Maximum Conducted Output Power 15.407(a)(4~8) Power Spectral Density 15.407(b)(6) In-band emission 15.205 15.209 15.407(b)(5),(b)(

8),(b)(9) 15.407(d)(6) 15.407(a)(7)(8) 15.407(c) Undesirable Radiated Emissions contention-based protocol Test Demonstration of Proper Power Adjustment based on Associated AP Transmission in case of Absence of Information N Y Y Y Y Y Y Y Y Fully tested for changing I/O interfaces Fully leveraged Fully leveraged with Spot check worst-case scenarios to demonstrate compliance. Fully leveraged Fully leveraged Fully leveraged with Spot check worst-case scenarios to demonstrate compliance Fully leveraged N/A, the device is only associated with indoor AP. Fully leveraged Multi-Link Operation WLAN 2.4GHz & 5GHz & 6GHz FCC Rules Description Of Test Data Referencing 15.205 15.209 15.407(b) Undesirable Radiated Emissions Y Test report number: TERF2309002275E2 Fully leveraged

(The test report of the referenc FCC ID is submitted in full without change) 4G LTE & 5GNR FCC Rules Description Of Test Data Referencing Test report number:

ZEWM2306000856RG01 ZEWM2306000856RG02 ERP/ EIRP measurement Y Fully leveraged with spot check worst-case scenarios to demonstrate compliance. Peak to Average Ratio 99% & 26dB Occupied Bandwidth Out of Band Emissions at Antenna Terminals and Band Edge / Emission mask requirements Y Y Y Fully leveraged Fully leveraged Fully leveraged Field Strength of Spurious Radiation Y Fully tested to demonstrate compliance. Frequency Stability Y Fully leveraged 2.1046(a) 22.913(a)(5) 24.232(c) 27.50(b)(10) 27.50(d)(4) 27.50(j)(3) 27.50(k)(3) 96.41 22.913(d) 24.232(d) 27.50(d)(5) 27.50 (k)(4) 96.41 2.1049(h) 2.1051 22.917(a) 24.238(a) 27.50(c)(5) 27.53(c) 27.53(h) 27.53(l)(2) 27.50(n)(2) 96.41 2.1053 22.917(a) 24.238(a) 27.53(c) 27.53(f) 27.53(h) 27.53(l)(2) 27.50(n)(2) 96.41 2.1055(a)(1)(b) 2.1055(d)(1) 22.355 24.235 27.54 96.41 Sincerely Yours, Printed Name: Jim Chang Title: RF Manager On behalf of: SGS Taiwan Ltd. Email: jim.chang@sgs.com

Letter Head ATTESTATION Date: December 19, 2023 RE: Attestation of Indoor Access Point Operation (6ID) FCC ID: H8N-ASK-NCM1100E Dear Examiner, We, Askey Computer Corporation, attest that this device under FCC ID: H8N-ASK-NCM1100E complies with device protocol requirements and operational restrictions for Indoor Access Point Devices (6ID). 1. The method used by this indoor access point to control the associated client/subordinate power control is as follows: This indoor access point can act as a master as defined in Section 15.202, allowing it to transmit without receiving an enabling signal. This mode can select a channel and initiate a network by sending enabling signal to client devices and subordinate devices. 2. This Low-power Indoor Access Point operates in the 5.925-7.125 GHz band. It is supplied power from a wired connection, has an integrated antenna, is not battery-powered, and does not have a weatherized enclosure. 3. We acknowledge this device is subject to and in full compliance with the device restrictions listed below. All users are notified of these restrictions through the user manual.

- This Indoor Access Point operating in the 5.925-7.125 GHz band shell be supplied power from a wired connection, has an integrated antenna, is not battery powered and does not have a weatherized enclosure.

- This device's operation will not be allowed on oil platforms, cars, trains, boats, and aircraft, except that operation of this device is permitted in large aircraft while flying above 10,000 feet.

- This device is that prohibited for control of or communications with unmanned aircraft systems, including drones. 4. This device employs a Contention-Based Protocol as demonstrated in the test report. Signature:

Title / Name (Printed): Director / Jack Po

Letter Head WIFI Channel 12 & 13 Declaration Letter To whom it may concern, we declare below featured for equipment authorization regarding Date: 2023/12/12 FCC ID: H8N-ASK-NCM1100E Please check Product hardware does not have the capability to operate on channel 12 &

13. Product hardware has the capability to operate on channel 12 & 13. However , these 2 channels will be disabled via software and user will not able to enable these 2 channels. Product hardware has the capability to operate on channel 12 & 13. And meeting KDB 594280 D01 requirement. Pls explain detail here. Others Pls explain detail here. Signature:

Title / Name (Printed): Director / Jack Po