Technical manual 1Module information Product nameTPMS SENSOR Model nameTMSS6F2 BrandBH SENS Manufacture NameBaolong Huf Shanghai Electronics Co., Ltd. Address:No. Building 3, Lane 1099, Zhangjing Road, Dongjing Town, Songjiang District, Shanghai City, P.R. China PowerBattery3.0V Rated current10mA Operating frequency 315MHz or 433.92Mhz Modulation Frequency deviation45KHz Transmit Power5 mW ModulationFSK RF codeManchester Antenna gain-25dBi Receiver Low frequency125kHz ModulationASK LF codeManchester Operating temperature range-40~+125 Software versionV1.0 Hardware versionV3.0 The module is powered by 3V battery, the RF center frequency is 315MHz or 433.92Mhz, the modulation frequency deviation is 45KHz, and the modulation mode is FSK. In normal operation mode, the sensor function module will periodically detect the tire internal pressure and temperature information. The real-time data collected is sent to the receiver by RF circuit. In addition, the pressure, temperature, sensor ID and other information inside the tire can be read in real time through the hand-held low-frequency tool. 2Diagram introduction Description 1. This module contains a highly integrated chip, which includes microprocessor core, pressure sensor, temperature sensor, acceleration sensor and RF function module. The RF center frequency is 433.92Mhz or 315MHz. 2. The module is powered by 3V battery. During the working period of the sensor, the microprocessor periodically reads the pressure and temperature information inside the tire through the pressure sensor and temperature sensor. 3. This module uses crystal oscillator circuit recommended by chip to provide accurate clock frequency for microprocessor. 4. As the core of the sensor, the microprocessor sensor function module is responsible for collecting tire pressure, temperature, acceleration and other information. 5. The sensor contains low-frequency function module, which is used for hand-held tools to read real-time data of sensor or upgrade software. Please take attention that changes or modification not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation. This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device. Le prsent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radioexempts de licence. L'exploitation est autorise aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en compromettre le fonctionnement. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator &
your body. This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. ce matriel est conforme aux limites de dose d'exposition aux rayonnements, CNR-102 nonce dans un autre environnement.cette eqipment devrait tre install et exploit avec distance minimale de 20 entre le radiateur et votre corps.
